Kimball Office Xsite Manual de usuario
Systems Assembly Instructions
Xsite®Page 1 of 2
Attach Privacy Panel to Xsite
Tools Required
■Level ■Phillips Screwdriver
Package Contents
■Caster ■Double-sided Adhesive Tape
■Clamp Plate ■Attachment Bracket
■Base Pivot Bracket ■2 10-24 x 1⁄2" Flathead
with Carpet Gripper Machine Screws
Installation
Note: On Xsite panels, the privacy panel attachment bracket can be
installed at the 5-high position only. (Figure A).
1. Tilt clamp plate slightly and insert the plate into the
Xsite Traxx channel at the desired position.
Note: Privacy panel can be installed at any location along
an Xsite Traxx. (Figure B).
2. Position the attachment bracket over the clamp plate and
use the screws provided to connect the attachment bracket
to the plate. Tighten screws securely when attachment
bracket is in desired position. (Figure C).
3. Insert base pivot bracket and caster into openings in
bottom of the posts on privacy panel. Make sure bracket
and caster fully seat. (Figure D).
Figure B
Figure C
Figure A Figure D
Attachment bracket
can be installed at
5-high position only
Xsite
panel
Clamp Plate
Insert into
Traxx channel
Use screws to connect
attachment bracket to
clamp plate
Insert base
pivot bracket
Insert caster
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2015812 Revision A-06
Systems Assembly Instructions
Xsite
Printed in U.S.A. © 2006 Kimball International, Inc. T 800.482.1818 F 812.482.8300
Page 2 of 2
Installation (continued)
4. In situations where the base pivot bracket will sit on a
non-carpeted floor, remove the carpet gripper from
the bottom of the base pivot bracket and attach a piece
of the double-sided adhesive tape provided. (Figure E).
5. Tilt the top of the privacy panel towards the Xsite panel
and insert attachment bracket into the hole in top of the
same post on the privacy panel where base pivot bracket
is installed. Rotate the bottom of the privacy panel inward
toward the Xsite panel. (Figure F).
6. For correct operation the privacy panel must be level.
You can adjust the location of the base pivot bracket,
top attachment bracket, and caster to position the panel
correctly. Ensure that the panel is level in the open and
closed positions. When leveled, press down slightly on
panel to engage the carpet gripper or double-sided tape
on bottom of base pivot bracket. (Figure G).
Figure E
Figure F
Figure G
Pry out
carpet
gripper
Attach double-sided
adhesive tape to bottom
of base pivot bracket
Tilt panel to
install onto
attachment
bracket
Insert attachment
bracket into hole in
top of panel post
Level panel in
open and closed
positions
For non-carpeted situations:
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2015812 Revision A-06
Otros manuales de Equipos de oficina de Kimball Office
Kimball Office
Kimball Office Guide Lectern Manual de usuario
Kimball Office
Kimball Office Xsite Door Kit for Fold Down Tile Manual de usuario
Kimball Office
Kimball Office Footprint Manual de usuario
Kimball Office
Kimball Office Perks Complete Series Manual de usuario
Kimball Office
Kimball Office Priority Manual de usuario
Kimball Office
Kimball Office Footprint Interworks EQ Manual de usuario
Kimball Office
Kimball Office Xsite Privacy Door Manual de usuario
Kimball Office
Kimball Office NARRATE Manual de usuario
