Kidde 900-0259 Manual de usuario

CO Alarm Model Number:

CO Alarm Assembly Number:

Date of Manufacture:

Date of Purchase:

Where Purchased:

Battery Operated

Carbon Monoxide

Alarm

User’s Guide

ASSEMBLY: 900-0260

ASSEMBLY: 900-0259

For questions concerning your Carbon Monoxide Alarm,

please call Kidde Safety Europe on 01753 685148

Please have the following information ready when calling:

Battery operated CO alarm

with Digital Display and

Peak Level memory

THIS OWNER’S MANUAL SHOULD BE READ, IN FULL AND RETAINED FOR

THE LIFE OF THE PRODUCT. IT SHOULD ALSO BE PASSED ON TO ANY

SUBSEQUENT OWNER.

Battery operated CO alarm

without Digital display

KM 98848

EN50291:2001 820-1732 REV A 04/09

Contents

CONTENTS OF THIS MANUAL

1 -- CARBON MONOXIDE OVERVIEW

2 -- QUICK SET-UP

3 -- INSTALLATION INSTRUCTIONS

4 -- FEATURES AND OPERATION

5 -- BATTERY INSTALLATION

6 -- WHAT TO DO IF THE ALARM SOUNDS

7 -- CARING FOR YOUR KIDDE CO ALARM

8 -- PRODUCT SPECIFICATIONS

9 -- WARRANTY

Environmental Protection

Waste electrical products should not be disposed of with

household waste. Please recycle where facilities exist.

Check with Local Authority or retailer for recycling advice.

All gas appliances should be checked for safety annually.

WARNING: THIS CARBON MONOXIDE ALARM IS NOT A SUBSTITUTE FOR INSTALLING

AND MAINTAINING AN APPROPRIATE NUMBER OF SMOKE ALARMS IN YOUR HOME.

THIS ALARM WILL NOT SENSE SMOKE, FIRE, OR ANY POISONOUS GAS OTHER THAN

CARBON MONOXIDE. FOR THIS REASON YOU MUST INSTALL SMOKE ALARMS TO

PROVIDE EARLY WARNING OF FIRE AND TO PROTECT YOU AND YOUR FAMILY FROM

FIRE AND ITS RELATED HAZARDS.

WARNING: THIS PRODUCT IS INTENDED FOR USE IN ORDINARY INDOOR RESIDEN-

TIAL AREAS. IT IS NOT DESIGNED TO MEASURE COMPLIANCE WITH COMMERCIAL

AND INDUSTRIAL STANDARDS. THIS ALARM IS NOT SUITABLE FOR INSTALLATION IN

HAZARDOUS LOCATIONS AS DEFINED IN THE NATIONAL ELECTRICAL CODE. INDIVID-

UALS WITH MEDICAL PROBLEMS MAY CONSIDER USING WARNING DEVICES WHICH

PROVIDE AUDIBLE AND VISUAL SIGNALS FOR CARBON MONOXIDE CONCENTRATIONS

UNDER 30 PPM.

IMPORTANT: THIS CARBON MONOXIDE ALARM IS DESIGNED TO DETECT CARBON

MONOXIDE FROM ANY SOURCE OF IMPROPER OR MALFUNCTIONING APPLIANCES.

THE INSTALLATION OF THIS DEVICE SHOULD NOT BE USED AS A SUBSTITUTE FOR

PROPER INSTALLATION, USE AND MAINTENANCE OF FUEL BURNING APPLIANCES

INCLUDING APPROPRIATE VENTILATION AND EXHAUST SYSTEMS

WARNING: THIS ALARM WILL NOT WORK WITHOUT POWER. THIS ALARM

REQUIRES A CONTINUOUS SUPPLY OF POWER.

WARNING: THIS UNIT IS NOT A SMOKE ALARM. IT WILL NOT SENSE SMOKE OR FIRE.

FOR EARLY WARNING OF FIRE YOU MUST INSTALL SMOKE ALARMS, EVEN THOUGH

CARBON MONOXIDE CAN BE GENERATED BY FIRE.

IMPORTANT: IF ANY FAULT SIGNALS OCCUR, CONTACT THE MANUFACTURER OR

SUPPLIER AND DO NOT CONTINUE USING THE ALARM.

Thank you for the purchase of your new Kidde carbon monoxide alarm.

If you have any questions about the operation or setup of your CO

alarm, feel free to call us on 01753 685148

Carbon Monoxide Overview

Your new Kidde Carbon Monoxide (CO) Alarm is a sophisticated instru-

ment that has been carefully designed and tested to detect CO build up

in a residential environments. Your alarm is for use specically in the

home.

CO cannot be seen, smelled or tasted and can be fatal. The build up of

CO in the blood is called the carboxyhemoglobin level and interferes

with the body’s ability to supply itself with oxygen. Depending on the

concentration, carbon monoxide can kill in minutes.

The most common sources of CO are malfunctioning, or misuse of, gas

appliances used for heating and cooking, vehicles engines, electric gen-

erators, blocked chimneys or ues, portable fuel burning heaters, re-

places, fuel powered tools and operating a grill in an enclosed space.

Indications of CO poisoning include symptoms similar to the u, but

with no fever. Other symptoms include dizziness, fatigue, weakness,

headache, nausea, vomiting, sleepiness and confusion. Everyone is sus-

ceptible to the danger of CO, but unborn babies, small children, preg-

nant women, senior citizens and people with heart or respiratory prob-

lems may experience symptoms sooner. Each year a qualied

(gas) or Hetas (solid fuel) engineer should inspect and clean your heat-

ing system, vents, chimney, and ues.

Your new Kidde CO alarm has a ve year warranty. Please take a few

minutes to thoroughly read the user’s guide and familiarize yourself and

your family with its operation. Your Kidde CO alarm was designed to

detect carbon monoxide gas from ANY source of combustion. It is NOT

designed to detect smoke, re or any other gases. If you have any ques-

tions please call us on 01753 685148.

This manual and the products described are copyrighted, with all rights

reserved. Under these copyright laws, no part of this manual may be

copied for use without the written consent of Kidde.

If you require further information, contact our Consumer Hotline, or

write to us at:

Kidde Safety Europe Ltd

Mathisen Way, Poyle Road,

Colnbrook, Berkshire

SL3 0HB

Customer Hotline: 0800 917 0722

www.kiddesafetyeurope.co.uk

Test/

Reset

Operate

Peak Level

KM 98848

EN 50291:2001

CARBON MONOXIDE ALARM

Alarm

PPM of Carbon Monoxide Displayed

Lb = Low Battery

Err = Error Condition

Backlight

Model No. 900-0260

900-0260 digital display model

Kidde Product View

900-0259 non-digital model

Kidde Product View

900-0259

Quick Set Up

NOTE: This CO alarm must be installed by a competent person.

Remove the three enclosed AA batteries and install them into

the battery well. Carefully place the red battery warning ags into

the battery well. Observe the battery polarity markings at the bot-

tom of the battery well. After approximately 30 seconds, your CO

alarm will begin monitoring for CO.

Your Kidde CO Alarm is now operational.

IMPORTANT

A small screwdriver or similar tool may be required when open-

ing the battery compartment cover. This should be levered from

the lip at the bottom of the cover.

The cover is designed this way to discourage the removal of

batteries, or tampering, by young children.

DINING KITCHEN BEDROOM BEDROOM

BEDROOMLIVING ROOM

Installation Instructions

Installation Location

When choosing your installation locations, make sure you can hear the

alarm from all sleeping areas. If you install only one carbon monoxide

alarm in your home, install the alarm near bedrooms, not in the celler or

boiler room.

If you have only one alarm, place it near sleeping areas.

Recommended Locations

Upper Levels of the Home

Where To Install Your Kidde CO Alarm

The following suggestions are intended to help you with the

placement and installation of your Kidde CO Alarm.

• Place out of the reach of children. Under no circumstance should chil-

dren be allowed to handle or install the CO alarm.

• Install in a bedroom or hallway located close to the sleeping area. Take

special care to verify the alarm can be heard in sleeping areas.

• It is recommended that a CO alarm be installed on each level of a multi-

level home.

• Locate at least [but no closer than] 2 metres away from all fuel burning

appliances.

• Placing at eye level allows for optimum monitoring of the red and green

indicator lights, or, as a guide, 1.5 metres from the oor.

• Ensure that all vents of the unit are unobstructed.

• Do not install in dead air spaces such as peaks of vaulted ceilings, or

gabled roofs.

• Do not install in turbulent air from ceiling fans.

• Do not place near fresh air vents or close to doors and windows that

open to the outside.

• Keep the CO alarm away from excessively dusty, dirty, or greasy areas

such as kitchens, garages and boiler or utility rooms. Dust, grease and

household chemicals can aect the sensor.

• Keep out of damp and humid areas such as the bathroom. Avoid spray-

ing aerosols near the CO alarm.

• Do not install in areas where the temperature is below 40˚F (4.4˚C) or

hotter than 100˚F (37.8˚C).

• Do not place behind curtains or furniture. CO must be able to reach the

sensor for the unit to accurately detect carbon monoxide. NEVER place

the CO alarm at on a table top or similar surface.

• Be aware that certain conditions can result in transient CO situations,

such as:

1) Excessive spillage or reverse venting o uel burning appliances caused

by outdoor ambient conditions, such as:

i) Wind direction and/or velocity, including high gusts of wind. Heavy air

in the vent pipes (cold/humid air with extended periods between cycles).

Installation Instructions

ii) negative pressure dierential resulting from the use of exhaust fans.

iii) Simultaneous operation of several fuel burning appliances compet-

ing for limited internal air.

iv) Vent pipe connections vibrating loose from clothes dryers, boilers or

water heaters.

v) Obstructions in or unconventional vent pipe designs which can

amplify the above situations.

2) Extended operation of unvented fuel burning devices (cooker, oven, re

place, etc.).

3) Temperature inversions which can trap exhaust near the ground.

4) Car idling in open or closed garage, or near

the home.

Mounting

This CO alarm can be either wall mounted or

placed on a tabletop.

For wall mounting, follow these steps:

1. Mark the location of the two holes

needed on the wall spaced

2-3/8”apart.

2. Insert the two screws provided until the

screw heads are protruding approximately

1/8”from the wall. (If mounting in a

plasterboard or drywall, drill a 3/16”hole

in the wall and use the plastic anchors

provided.)

3. Hook the CO alarm over the screws and

onto the keyholes in the back of the

alarm.

Your CO alarm may also be placed on a

tabletop. Simply fold out the stand located

on the back of the unit and place in a

location that is easily visible. Be sure the

alarm is no more than three feet from the

floor.

Wall Mount

Tabletop Stand

Screw Head Distance

from Wall

Your new Kidde Battery Powered CO Alarm utilizes sophisticated

electronic components to protect you and your family from the

dangers of CO.

Unique features include a digital display capable of displaying CO

concentrations in (PPM) Parts Per Million and the highest levels

of CO detected. Familiarize yourself with these features:

Digital Display Backlight Feature

To help see the displayed reading in the dark, a backlight appears

when the peak level button is pressed.

Digital Display - Shows CO level in PPM

Your Kidde CO alarm continuously displays a digi-

tal readout of the CO level in Parts Per Million

(PPM). The digital display is capable of detecting

and displaying readings between 30 and 999 (PPM).

A reading of 0 PPM is expected under normal conditions

You will become accustomed to glancing at the display in much

the same manner as you look at a thermometer or clock. The

unit will not automatically display a reading below 30 PPM.

However, readings between 11 and 999 PPM will be stored in the

Peak Level Memory.

Other Possible Displays and Their Meanings

The following symbols will appear on the display during normal

or error operations, and are explained below.

Normal Operation

Normal operation with a full battery. The dot in the

lower right corner cycles on and o every 5 sec-

onds. If CO is present the display will indicate the

reading in Parts Per Million (PPM).

Normal Operation following Power-up or Reset

The gure at the right shows the normal display

immediately after installing batteries or after the

test/reset button is pressed. The display will

change to the normal display approximately 30

seconds after pressing the test/reset button.

Features and Operation of Digital Display Model

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Alarma de monóxido de carbono de Kidde

Kidde

Kidde KN-COPP-B-LS Manual de usuario

Kidde

Kidde CO120X Manual de usuario

Kidde

Kidde SL177i Manual de usuario

Kidde

Kidde K4MCO Manual de usuario

Kidde

Kidde KN-COPF-I Manual de usuario

Kidde

Kidde KN-COB-DP-H) Manual de usuario

Kidde

Kidde C3010-CA Manual de usuario

Kidde

Kidde KN-COB-B-LP Manual de usuario

Kidde

Kidde KN-COP-DP-10YLCA Manual de usuario

Kidde

Kidde K5CO Manual de usuario

Kidde

Kidde Fyrnetics 423D/9HIR Manual de usuario

Kidde

Kidde KN-COP-DP-10YL Manual de usuario

Kidde

Kidde KN-COPP-B Manual de usuario

Kidde

Kidde KN-COPP-3 Manual de usuario

Kidde

Kidde KN-COPP-3 Manual de usuario

Kidde

Kidde Fyrnetics 423/9HIR Instrucciones de montaje

Kidde

Kidde KHU100-28 Manual de usuario

Kidde

Kidde KN-COPP-B Manual de usuario

Kidde

Kidde KN-COB-B-LS (900-0233) Manual de usuario

Kidde

Kidde KN-COPP-3 Manual de usuario

Kidde

Kidde K10LLCO Manual de programación

Kidde

Kidde CO120X Manual de usuario

Kidde

Kidde C3010 Manual de usuario

Kidde

Kidde KN-COEG-3 (900-01 13) Manual de usuario

Manuales populares de Alarma de monóxido de carbono de otras marcas

Honeywell

Honeywell H450EN Manual de usuario

First Alert

First Alert FCD2B Manual de usuario

Honeywell

Honeywell SF350RVUL Manual de usuario

Poolguard

Poolguard DAPT-2 Manual de usuario

Ei Electronics

Ei Electronics Ei 261D Manual

Bacharach

Bacharach Model 105 Manual

Firex

Firex COZ-1 Manual de usuario

Costar

Costar 12RV-D Manual de usuario

First Alert

First Alert CO410 Manual de usuario

FireAngel

FireAngel CO-9X Manual de usuario

Costar

Costar 12-24SIR Manual de usuario

System Sensor

System Sensor CO1224T Manual de usuario

Deltronic Security

Deltronic Security CN-1231 Manual de usuario

GE Interlogix

GE Interlogix 240 COE - Carbon Monoxide Alarm Manual de usuario

Sygonix

Sygonix 2377794 Manual de usuario

Convoy Tech

Convoy Tech CO311 Manual de usuario

nest

nest PROTECT Manual de usuario

Bosch

Bosch CRS-WLCD-TA869 Manual de usuario