Keystone KSTAP05PHA Manual de usuario
Read this owner’s manual thoroughly before operating the appliance and keep it handy for reference at all times.
KSTAP05PHA
KSTAP07PHA
Producto
Troubleshooting Tips
Read This Manual
Inside you’ll find many helpful hints on how to use and maintain your air conditioner
properly. Just a little preventive care on your part can save you a great deal of time
and money over the life of your air conditioner. You’ll find many answers to common
problems in the troubleshooting tips - you should be able to fix most of them quickly
before calling service. These instructions may not cover every possible condition of
use, so common sense and attention to safety is required when installing, operating,
and maintaining this product.
FRONT REAR
Control panel
Handle
(both sides)
Horizontal louver
control lever(adjust
manually)
Vertical louver
control lever
(adjust manually)
Panel
Caster Bottom tray
drain outlet
Air filter
Upper air intake
air outlet
Lower air intake
Drain outlet
Design Notice: In order to ensure the optimal performance of our products, the design specifications of the unit and remote
control are subject to change without prior notice.
Please read through these instructions before you start the
installation process. Improper installation can cause
damage to the unit, your personal property, and also poses
a personal safety hazard.
- DO NOT share a single outlet with other electrical appliances.
Improper power supply can cause fire or electrical shock.
Caution: Risk of fire/flammable materials
(Required for R32/R290 units only)
Caution: This symbol shows
that the operation manual should
be read carefully.
- DO NOT install your air conditioner in a wet room such as
a bathroom or laundry room. Too much exposure to water
can cause electrical components to short circuit.
- DO NOT install the unit in a location that may be exposed
to combustible gas, as this could cause a fire.
- The unit has wheels to facilitate movement. Make sure not
to use the wheels on thick carpet or to roll over objects, as
this could cause the unit to fall.
- DO NOT operate the unit that has been dropped or damaged.
- DO NOT allow children to play with the air conditioner.
Children must be supervised around the unit at all times.
- During a thunderstorm, the power must be cut off to avoid
damage to the machine due to lightning.
- If the air conditioner is knocked over during use, turn off the
unit and unplug it from the main power supply immediately.
Visually inspect the unit to ensure there is no damage. If you
suspect the unit has been damaged, contact a technician or
customer service for assistance.
-This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
-If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly
qualified persons in order to avoid a hazard.
-Prior to cleaning or other maintenance, the appliance must be disconnected.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do
not route cord under furniture or appliances. Arrange the cord away from the traffic area and where it
will not be tripped over.
- Never attempt to operate this appliance if it is damaged, malfunctioning, partially disassembled, or has
missing or broken parts, including a damaged cord or plug.
-To reduce the risk of fire or electric shock, do not use this unit with any solid-state speed control device.
-The appliance shall be installed in accordance with national wiring regulations.
- Contact the authorized service technician for repair or maintenance of this unit.
- Contact the authorized installer for the installation of this unit.
-When there are significant differences between features or operation implied by the remote control
illustration and the actual functions described in the USER MANUAL, the descriptions in the USER
MANUAL shall prevail.
Your installation location should meet the following requirements:
- Make sure that you install your unit on an even surface to minimize noise and vibration.
- The unit must be installed near a grounded outlet, and the Collection Tray Drain (found on the back of the unit) must be accessible.
- The unit should be located at least 19.7 inches from the nearest wall to ensure proper air conditioning.
- DO NOT cover the Intakes, Outlets, or Remote Signal Receptor of the unit, as this could cause damage to the unit.
Note About Fluorinated Gasses
- This air-conditioning unit is a hermetically sealed unit that contains fluorinated gasses. For specific information on the type of gas and the amount,
please refer to the relevant label on the unit itself.
- Service, maintenance, or repair of this unit must be performed by a certified technician.
- Product uninstallation and recycling must be performed by a certified technician according to local regulations.
NOTE:
All the illustrations in the manual are for explanation purposes only. Your air conditioner may be slightly different. The actual shape
shall prevail.
19.7inch
19.7inch
19.7 inch
Step Two: Install the exhaust hose assembly to the unit
Step Three: Preparing the adjustable window slider
Align the unit adaptor of the exhaust hose assembly to the groove of the
air outlet opening on the back of the unit. Slide the exhaust hose
assembly along the direction indicated by the arrow for installation.
1. Depending on the size of your window, adjust the size of the window
slider.
2. If the length of the window requires two window sliders, use the bolt to
fasten the window sliders once they are adjusted to the proper length.
Press the exhaust hose into the window slider adaptor and the unit
adaptor. Each adaptor will snap into the exhaust hose automatically with
plastic clips.
Step One: Preparing the exhaust hose assembly.
- Medium Phillips screwdriver;
- Tape measure or ruler;
- Knife or scissors;
- Saw (optional, to shorten window adaptor for narrow windows)
Your Window Installation Kit fits windows 26.5 – 48
"
and can be shortened
for smaller windows.
Unit adaptor Window slider
adaptor
Exhaust hose Exhaust hose assembly
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Acondicionador de aire de Keystone
Keystone
Keystone KSTAP12B Manual de usuario
Keystone
Keystone KSTHW18B Manual de usuario
Keystone
Keystone KSTAT12-1A Manual de usuario
Keystone
Keystone KSTAT08-1D Manual de usuario
Keystone
Keystone KSTAP12CG Manual de usuario
Keystone
Keystone KSTAT08-1C Manual de usuario
Keystone
Keystone R-KSTAT08-1C Manual de usuario
Keystone
Keystone KSTSW08A Manual de usuario
Keystone
Keystone KSTAW08A Manual de usuario
Keystone
Keystone KSTAW08A Manual de usuario
Keystone
Keystone KSTAW12INV-HC Manual de usuario
Keystone
Keystone KSTAP14WCG Manual de usuario
Keystone
Keystone KSTAW15C Manual de usuario
Keystone
Keystone R-KSTHW08A Manual de usuario
Keystone
Keystone KSTAT12-1B Manual de usuario
Keystone
Keystone KSTHW08B Manual de usuario
Keystone
Keystone R-KSTAW06B Manual de usuario
Keystone
Keystone R-KSTAP08D Manual de usuario
Keystone
Keystone KSTAW05A Manual de usuario
Keystone
Keystone REFURBISHED R-KSTAP12B Manual de usuario
