Kett HX-700 Manual de usuario
HAY MOISTURE TESTER HX-700
Operating Manual
CAUTION
HAY MOISTURE TESTER SAFETY ISSUES
Read these safety issues to avoid injury, material loss or other accidental damages.
The instrument is designed to be safe, but, nevertheless, be sure to use it only after reading these safety issues.
MAKE SURE TO OBSERVE THE SAFETY PRECAUTIONS.
Read all the safety precautions in this manual.
DO NOT USE THE INSTRUMENT IF A FAILURE HAS OCCURRED
Call for repair or service if a failure or a malfunction has been observed. Contact our service personnel.
GRAPHIC SYMBOLS FOR SAFETY
To prevent damage or harm from incorrect operation of the instrument, this manual contains various graphic symbols. The symbols
concerned with safety issues are as follows.
Be sure to follow the instructions for safety reasons.
CONTANTS
1. FEATURES ................................................................... 4
2. SPECIFICATIONS ........................................................ 5
3. NOMENCLATURE ........................................................ 6
4. DISPLAY SCREEN ....................................................... 7
5. HOW TO USE THE INSTRUMENT .............................. 8
5-1. Preparation for measurement ............................... 8
5-2. How to measure ................................................... 9
5-3. Precautions for measurement .............................. 11
5-4. Display of the average .......................................... 12
5-5. How to set Continuous Measurement mode ........ 13
5-6. How to correct the moisture % display ................. 14
5-7. How to set the alarm ............................................. 15
6. ERROR DISPLAY ......................................................... 16
4
1. FEATURES
Simply inserting the probe in the hay, dried or stored, allows this instrument to display moisture content
in % by utilizing the electric resistance measurement. Very handy to use and easy to operate, it allows
you to measure hay wherever and whenever you want to.
Damp hay in storage is apt to ferment or rot, and over drying will reduce the quality. The weight fluctua-
tion of the hay due to water content is an important issue in business transactions.
HX-700 is a long, weighted instrument designed to match the needs of this industry. Make the most of
the advantages offered to you by the HX-700, whether for moisture control during storage or to check
moisture during a buying or selling transaction.
AUTO POWER OFF FUNCTION
Tu r ns the instrument power off automatically if not operated for 5 minutes.
ALARM SETTING INSTALLED
Buzzer alarm can be set for high moisture at 10~39%.
WATER % CORRECTION INSTALLED
Accepts a correction in moisture % from -9.9 to +9.9%
5
2. SPECIFICATIONS
Measurement method : Electric resistance
Measurement object : Hay (Grass)
Measurement range : 8~30%
Measurement accuracy : Standard error 1.0% (20% or under)
Standard method : 135°C (275°F), 2hours
Display : Digital (LCD, The smallest display digit is 0.1%
Usable temperature : 0°C~40°C (32F~104°F)
Special features : Average display
Upper alarm setting (10~39% or off)
Automatic power off (in 5 minutes)
Moisture % correction (-9.9 to +9.9%)
Power source : 1.5V AA alkaline battery x 6
Dimension : 110(W) x 210(D) x 50(H)mm
Weight : 0.5Kg
Accessories : Probe, Shoulder strap, Carrying case, 1.5V AA alkaline battery x 3, Operat-
ing manual
6
3. NOMENCLATURE
[Instrument body] [Accessories]
Connector
Battery compartment
cover (on the back)
Display
screen
Operation
panel
Probe
Operating manual
1.5V AA alkaline
battery x 6
Carrying case
Shoulder strap
7
4. DISPLAY SCREEN
Number
Battery information
Measurement times
HAY display
Alarm setting
Moisture %
Bar graph
8
5. HOW TO USE THE INSTRUMENT
5-1. Preparation for measurement
(1) Install the six AA alkaline batteries in the battery compartment
on the back of the instrument. Remove the battery compart-
ment door and install the batter ies. Take care not to reverse
the polarity (+ & –) of the batteries. Replace the cover.
•When the batteries are worn, will blink on the display screen.
Change all batteries at the same time.
(2) Connect the probe firmly to the body. Turn the lock ring at the
base of the probe clockwise to secure the sensor probe.
(3) Take off the probe cap.
1 Tum the lock ring.
2 Insert firmly.
9
5-2. How to measure
(1) Press the key to turn the instrument power on. For 3
seconds the LCD will show all the letters and signs on it.
After that "HAY", "TIMES" and "%" will be displayed.
•If the LCD wouldn't start up as described here, there might be an
error occurring in the instrument. Refer to "6. Error display" .
(2) Insert the probe in the hay.
•The top of the probe has a sharp edge. Take good care not to
damage anything while measuring. Be sure to put the cap on
after use.
10
(3) Press the or key, the decimal point will blink.
In about 3 seconds after a short beep, "Measurement Times",
"Moisture %" and "Bar Graph" will be displayed.
•The bar graph increment is 2%, and capable of displaying 50% at
maximum.
•If the measurement result is out of the range, "HI" for exceeding
and "LO" for lower than will be displayed.
(4) Pull the probe out of the hay. The last moisture % will remain
displayed. To continue the measurement, insert the probe again
in the hay, as per (2) above.
Tu rn the power off pressing the key after you have
finished measurement.
•This instrument turns the power off automatically after being left
unused for 5 minutes.
shows that either numbers or
marks enclosed are blinking.
Tabla de contenidos
Otros manuales de Equipo de prueba de Kett
Kett
Kett PM-410 Manual de usuario
Kett
Kett LE-330J Manual de usuario
Kett
Kett MT-900 Manual de usuario
Kett
Kett HG-770 Manual de usuario
Kett
Kett LE-373 Manual de usuario
Kett
Kett Riceter fg Series Manual de usuario
Kett
Kett MT-700 Manual de usuario
Kett
Kett PR-930 Manual de usuario
Kett
Kett KH-70 Manual de usuario
Kett
Kett LZ-990 Manual de usuario
Kett
Kett L-500 Manual de usuario
Kett
Kett HI-520-2 Manual de usuario
Kett
Kett LE-200J Manual de usuario
Kett
Kett 94i-II Manual de usuario
Kett
Kett HK-300-1 Manual de usuario
Kett
Kett HX-120 Manual de usuario
Kett
Kett HI-700 Manual de usuario
Kett
Kett fv Series Manual de usuario
Kett
Kett PM-410 Manual de usuario
Kett
Kett AN-900 Manual de usuario
Manuales populares de Equipo de prueba de otras marcas
SMART
SMART KANAAD SBT XTREME 3G Series Manual de usuario
Agilent Technologies
Agilent Technologies BERT Serial Manual de usuario
Agilent Technologies
Agilent Technologies N3280A Manual de usuario
Vernier
Vernier Go Direct Voltage Manual de usuario
Lifeloc
Lifeloc R.A.D.A.R. Manual de usuario
Fluke
Fluke T5-600 Instrucciones de funcionamiento e instalación
