Kenwood TK-2260EX Manual de usuario

TK-2260EX/ TK-3260EX

09 08 07 06 05 04 03 02 01

VHF FM TRANSCEIVER/

UHF FM TRANSCEIVER

INSTRUCTION MANUAL

ÉMETTEUR-RÉCEPTEUR FM VHF/

ÉMETTEUR-RÉCEPTEUR FM UHF

MODE D’EMPLOI

TRANSCEPTOR FM VHF/

TRANSCEPTOR FM UHF

MANUAL DE INSTRUCCIONES

RICETRASMETTITORE FM VHF/

RICETRASMETTITORE FM UHF

MANUALE DI ISTRUZIONI

VHF-FM-TRANSCEIVER/

UHF-FM-TRANSCEIVER

BEDIENUNGSANLEITUNG

VHF FM ZENDONTVANGER/

UHF FM ZENDONTVANGER

GEBRUIKSAANWIJZING

VHF FM EL TELSİZİ/

UHF FM EL TELSİZİ

KULLANIM KILAVUZU

ΠΟΜΠΟΔΕΚΤΗΣ VHF FM/

ΠΟΜΠΟΔΕΚΤΗΣ UHF FM

ΟΔΗΓΙΕΣ ΧΡΗΣΗΣ

VHF FM TRANSCEIVER/

UHF FM TRANSCEIVER

TK-2260EX/ TK-3260EX

INSTRUCTION MANUAL

ENGLISH

NOTIFICATION

This equipment complies with the essential requirements of

Directive 1999/5/EC.

The use of the warning symbol means the equipment is

subject to restrictions of use in certain countries.

This equipment requires a licence and is intended for use in

the countries as below.

AT BE DK FI FR DE GR IS

IE IT LI LU NL NO PT ES

SE CH GB CY CZ EE HU LV

LT MT PL SK SI BG RO

ISO3166

Thank You

We are grateful you have chosen Kenwood for your land

mobile radio applications.

noTices To The user

◆Government law prohibits the operation of unlicensed radio

transmitters within the territories under government control.

◆Illegal operation is punishable by fine and/or imprisonment.

◆Refer service to qualified technicians only.

Safety:

◆ It is important that the operator is aware of, and understands,

hazards common to the operation of any transceiver.

◆ For use in explosive atmospheres, read additional document

“SAFETY MANUAL FOR HAZARDOUS LOCATIONS” (B62-

2233-XX).

Information on Disposal of Old Electrical and Electronic Equipment and Batteries

(applicable for EU countries that have adopted separate waste collection systems)

Products and batteries with the symbol (crossed-out wheeled bin) cannot be

disposed as household waste.

Old electrical and electronic equipment and batteries should be recycled at

a facility capable of handling these items and their waste byproducts.

Contact your local authority for details in locating a recycle facility nearest

to you.

Proper recycling and waste disposal will help conserve resources whilst

preventing detrimental effects on our health and the environment.

Notice: The sign "Pb" below the symbol for batteries indicates that this

battery contains lead.

Firmware Copyrights

The title to and ownership of copyrights for firmware embedded in

Kenwood product memories are reserved for Kenwood Corporation.

PrecauTions

• Do not charge the transceiver and battery pack when they are wet.

• Ensure that there are no metallic items located between the

transceiver and the battery pack.

• Use only Kenwood specified explosion-protected options for the

TK-2260EX and TK-3260EX transceivers.

• If the die-cast chassis or other transceiver part is damaged, do not

touch the damaged parts.

• Do not place the microphone cable around your neck while near

machinery that may catch the cable.

• Do not place the transceiver on unstable surfaces.

• Ensure that the end of the antenna does not touch your eyes.

• When the transceiver is used for transmission for many hours, the

radiator and chassis will become hot. Do not touch these locations

when replacing the battery pack.

• Do not immerse the transceiver in water.

• Always switch the transceiver power off before installing optional

accessories.

• The charger is the device that disconnects the unit from the AC

mains line. The AC plug should be readily accessible.

iii

Turn the transceiver power off in the following locations:

• Near blasting sites.

• In aircrafts. (Any use of the transceiver must follow the instructions

and regulations provided by the airline crew.)

• Where restrictions or warnings are posted regarding the use of

radio devices, including but not limited to medical facilities.

• Near persons using pacemakers.

• Do not disassemble or modify the transceiver for any reason.

• Do not place the transceiver on or near airbag equipment while

the vehicle is running. When the airbag inflates, the transceiver

may be ejected and strike the driver or passengers.

• Do not transmit while touching the antenna terminal or if

any metallic parts are exposed from the antenna covering.

Transmitting at such a time may result in a high-frequency burn.

• If an abnormal odor or smoke is detected coming from the

transceiver, switch the transceiver power off immediately, remove

the battery pack from the transceiver, and contact your Kenwood

dealer.

• Use of the transceiver while you are driving may be against traffic

laws. Please check and observe the vehicle regulations in your

area.

• Do not expose the transceiver to extremely hot or cold conditions.

• Do not carry the battery pack with metal objects, as they may

short the battery terminals.

• Danger of explosion if the battery is incorrectly replaced; replace

only with the same type.

Information concerning the battery pack:

The battery pack includes flammable objects such as organic

solvent. Mishandling may cause the battery to rupture

producing flames or extreme heat, deteriorate, or cause other

forms of damage to the battery. Please observe the following

prohibitive matters.

• Do not disassemble or reconstruct battery!

The battery pack has a safety function and protection circuit to

avoid danger. If they suffer serious damage, the battery may

generate heat or smoke, rupture, or burst into flame.

• Do not short-circuit the battery!

Do not join the + and – terminals using any form of metal (such

as a paper clip or wire). Do not carry or store the battery pack in

containers holding metal objects (such as wires, chain-necklace or

hairpins). If the battery pack is short-circuited, excessive current will

flow and the battery may generate heat or smoke, rupture, or burst

into flame. It will also cause metal objects to heat up.

• Do not incinerate or apply heat to the battery!

If the insulator is melted, the gas release vent or safety function is

damaged, or the electrolyte is ignited, the battery may generate

heat or smoke, rupture, or burst into flame.

• Do not leave the battery near fire, stoves, or other heat

generators (areas reaching over 80°C)!

If the polymer separator is melted due to high temperature, an

internal short-circuit may occur in the individual cells and the

battery may generate heat or smoke, rupture, or burst into flame.

• Avoid immersing the battery in water or getting it wet by

other means!

If the battery becomes wet, wipe it off with a dry towel before

use. If the battery’s protection circuit is damaged, the battery may

charge at extreme current (or voltage) and an abnormal chemical

reaction may occur. The battery may generate heat or smoke,

rupture, or burst into flame.

• Do not charge the battery near fire or under direct sunlight!

If the battery’s protection circuit is damaged, the battery may

charge at extreme current (or voltage) and an abnormal chemical

reaction may occur. The battery may generate heat or smoke,

rupture, or burst into flame.

• Use only the specified charger and observe charging

requirements!

If the battery is charged in unspecified conditions (under high

temperature over the regulated value, excessive high voltage or

current over regulated value, or with a remodeled charger), it may

overcharge or an abnormal chemical reaction may occur. The

battery may generate heat or smoke, rupture, or burst into flame.

• Do not pierce the battery with any object, strike it with an

instrument, or step on it!

This may break or deform the battery, causing a short-circuit. The

battery may generate heat or smoke, rupture, or burst into flame.

• Do not jar or throw the battery!

An impact may cause the battery to leak, generate heat or smoke,

rupture, and/or burst into flame. If the battery’s protection circuit

is damaged, the battery may charge at an abnormal current (or

voltage), and an abnormal chemical reaction may occur. The

battery may generate heat or smoke, rupture, or burst into flame.

• Do not use the battery pack if it is damaged in any way!

The battery may generate heat or smoke, rupture, or burst into

flame.

• Do not solder directly onto the battery!

If the insulator is melted or the gas release vent or safety function

is damaged, the battery may generate heat or smoke, rupture, or

burst into flame.

• Do not reverse the battery polarity (and terminals)!

When charging a reversed battery, an abnormal chemical reaction

may occur. In some cases, an unexpected large amount of

current may flow upon discharging. The battery may generate

heat or smoke, rupture, or burst into flame.

• Do not reverse-charge or reverse-connect the battery!

The battery pack has positive and negative poles. If the battery

pack does not smoothly connect with a charger or operating

equipment, do not force it; check the polarity of the battery. If the

battery pack is reverse-connected to the charger, it will be reverse-

charged and an abnormal chemical reaction may occur. The

battery may generate heat or smoke, rupture, or burst into flame.

• Do not touch a ruptured and leaking battery!

If the electrolyte liquid from the battery gets into your eyes, wash

your eyes with fresh water as soon as possible, without rubbing

your eyes. Go to the hospital immediately. If left untreated, it may

cause eye-problems.

• Do not charge the battery for longer than the specified time!

If the battery pack has not finished charging even after the

regulated time has passed, stop it. The battery may generate heat

or smoke, rupture, or burst into flame.

• Do not place the battery pack into a microwave or high

pressure container!

The battery may generate heat or smoke, rupture, or burst into

flame.

• Keep ruptured and leaking battery packs away from fire!

If the battery pack is leaking (or the battery emits a bad odor),

immediately remove it from flammable areas. Electrolyte leaking

from battery can easily catch on fire and may cause the battery to

generate smoke or burst into flame.

• Do not use an abnormal battery!

If the battery pack emits a bad odor, appears to have different

coloring, is deformed, or seems abnormal for any other reason,

remove it from the charger or operating equipment and do not use

it. The battery may generate heat or smoke, rupture, or burst into

flame.

CONTENTS

UNPACKING AND CHECKING EQUIPMENT.......................... 1

PREPARATION .......................................................... 2

ORIENTATION ........................................................... 5

PROGRAMMABLE AUXILIARY FUNCTIONS ........................ 6

BASIC OPERATIONS ................................................... 9

BACKGROUND OPERATIONS ........................................ 11

UNPACKING AND CHECKING EQUIPMENT

Carefully unpack the transceiver. If any of the items listed

below are missing or damaged, file a claim with the carrier

immediately.

SUPPLIED ACCESSORIES

Battery pack (KNB-58LEX)..........................................................1

Belt clip (KBH-16EX)...................................................................1

• Screws for belt clip (M3 x 8 mm) ............................................2

Universal connector cap..............................................................1

• Screw (pre assembled)...........................................................1

• Packing (pre assembled)........................................................1

Instruction manual.......................................................................1

Note:

◆Refer to "PREPARATION" for accessory installation

instructions.

◆For charging the battery pack, refer to the optional battery

charger instruction manual.

PREPARATION

INSTALLING/ REMOvING THE BATTERY PACK

1Match the guides of the battery

pack with the grooves on the

upper rear of the transceiver,

then firmly press the battery

pack in place.

2Lock the safety catch to

prevent accidentally releasing

the battery pack.

3To remove the battery pack,

lift the safety catch, press the

release latch, then pull the

battery pack away from the

transceiver.

Note: Before charging a battery pack that is attached to the

transceiver, ensure that the safety catch is firmly closed.

INSTALLING THE (OPTIONAL) ANTENNA

Antenna Screw the antenna into the connector

on the top of the transceiver by

holding the antenna at its base and

turning it clockwise until secure.

Otros manuales para TK-2260EX

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Transceptor de Kenwood

Kenwood

Kenwood TS-530SP Manual de usuario

Kenwood

Kenwood TK-7102H Manual de usuario

Kenwood

Kenwood TH-79A Manual de usuario

Kenwood

Kenwood TK-785 Manual de usuario

Kenwood

Kenwood TS-830 Manual de usuario

Kenwood

Kenwood TR-7730 Manual de usuario

Kenwood

Kenwood UBZ-LF14 Manual de usuario

Kenwood

Kenwood TS-450S Manual de usuario

Kenwood

Kenwood TM-V708A Manual de usuario

Kenwood

Kenwood TK-7180 Manual de usuario

Kenwood

Kenwood TR-851A Manual de usuario

Kenwood

Kenwood TR-50 Manual de usuario

Kenwood

Kenwood TK-3302 Manual de funcionamiento

Kenwood

Kenwood TS-830M Manual de usuario

Kenwood

Kenwood TM-201A Manual de usuario

Kenwood

Kenwood TK-285 Manual de usuario

Kenwood

Kenwood ProTalk tk-3501 Manual de usuario

Kenwood

Kenwood TK-880 series Manual de usuario

Kenwood

Kenwood TS-590SG Manual de usuario

Kenwood

Kenwood TK-760G series Manual de usuario

Kenwood

Kenwood TH-K2AT Manual de usuario

Kenwood

Kenwood TK-3207 Manual de usuario

Kenwood

Kenwood TK-7102 Manual de usuario

Kenwood

Kenwood TK-2400 Manual de usuario

Manuales populares de Transceptor de otras marcas

Yaesu

Yaesu FT-7B Manual de usuario

Texas Instruments

Texas Instruments TLK10232 Manual de usuario

Mizuho

Mizuho MX-2 Guía del producto

Blitz

Blitz MJ-398U Manual de usuario

Utilicom

Utilicom LongRanger 2050 Manual de usuario

Standart

Standart HX290UKA Manual de usuario

Altronix

Altronix Pace1PTM Manual de usuario

Kirisun

Kirisun PT2208 Manual de usuario

ELECRAFT

ELECRAFT KX2 Manual de usuario

Zodiac

Zodiac K3 Manual de usuario

Assa Abloy

Assa Abloy SecureComm HKC GSM-WIFI U Manual de usuario

Siemens

Siemens PSO 4000 Manual de usuario

Midland

Midland G8E-BT Manual

ComNav

ComNav Mariner X2 Manual de usuario

Uniden

Uniden UH820 Series Manual de usuario

Standard Horizon

Standard Horizon HX320E Manual de usuario

Em-Trak

Em-Trak A100 Manual de usuario

HPE

HPE Aruba QSFP28 Manual de usuario