Kenwood KRK-10 Manual de usuario

■Install the KRK-10 rear panel onto the front panel

6. Insert the flat cable attached to the interface unit (B/2) of

the KRK-10 rear panel (A82-0056-01) into the connector

(CN902) of the display unit of the panel ( o). (The flat

cable has been pre-inserted in the connector (CN2) of the

rear panel at the time of shipping.)

Note : The terminal side of the flat cable must face down

when inserting the flat cable into the connector.

7. Fit the four tabs of the rear panel into the front panel. ( !0 )

CN902

CN2 KRK-10 rear panel

■

Install the KRK-10 main panel onto the transceiver

4. Insert the flat cable that was removed in step 2 above into

the connector (CN1) of the interface unit (A/2) of the KRK-

10 main panel (A62-1101-01). ( u)

Note : The terminal side of the flat cable must face down

when inserting the flat cable into the connector.

5. Fit the main panel with four tabs onto the front of the

chassis. ( i)

Note : When installing the main panel onto the front of the

chassis, hold down the flat cable with your fingers to pre-

vent it from being caught.

CN1

KRK-10 main panel

CN902

4. Control Head Remote Kit (KRK-10 : Option)

The KRK-10 remote kit is used to remotely operate a TK-

8180 transceiver.

4-1. Installing the KRK-10 kit to the transceiver

1. Remove the front panel from the transceiver.

2. Install the KRK-10 main panel onto the transceiver.

3. Install the KRK-10 rear panel onto the front panel.

4. Connect the KRK-10 main panel to the rear panel with the

cable.

■Remove the front panel from the transceiver

1. Lift the two tabs of the panel on the bottom of the trans-

ceiver with a flat-head screwdriver ( q) and remove the

panel from the chassis ( w).

Note : Confirm that the tabs of the speaker hardware fix-

ture and holder is securely fitted in the front panel.

2. Remove the flat cable from the connector (CN902) of the

display unit of the panel. ( e)

3. Fold the black line of the flat cable (in three parts) as

shown in Figure 4-2. ( r, t, y)

Chassis

side

Panel

side

Fig. 4-1

Fig. 4-2

Fig. 4-3

Fig. 4-4

KRK-10 INSTALLATION

■Connect the KRK-10 main panel to the rear panel

with the cable

8. Insert one 14-pin connector of the cable (E30-7514-05)

into the connector (CN3) of the interface unit (A/2) of the

main panel. ( !1 )

9. Secure the cable bush on the main panel and fit the water-

proof packing (orange) ( !2 ) securely over top.

CN4

CN3

!8 !8

(Right side)

10. Install the molded cover ( !3 ) over the connector on the

main panel and secure it with two screws ( !4 ).

11. Insert the other 14-pin connector of the cable into the

connector (CN4) of the interface unit (B/2) of the rear

panel. ( !5 )

12. Secure the cable bush on the rear panel and fit the water-

proof packing (orange) ( !6 ) securely over top.

13. Install the molded cover ( !7 ) over the connector on the

rear panel and secure it with two screws ( !8 ).

Note : A cable can be connected from the left side as shown

in the Figure 4-5 or from right side.

However, the 14-pin connector must be connected to correct

direction.

Fig. 4-5

Otros manuales de Mando a distancia de Kenwood

Kenwood

Kenwood KCA-RC50MR - Marine Wired Remote Control Manual de usuario

Kenwood

Kenwood RC-R0907 Guía del administrador

Kenwood

Kenwood RC-R0905 Manual de usuario

Kenwood

Kenwood KNA-RCDV331 Manual de usuario

Kenwood

Kenwood Sovereign LCD Remote Control Manual de usuario

Kenwood

Kenwood KCA-RC35MR Manual de usuario

Kenwood

Kenwood KCA-RC107MR Manual de usuario

Kenwood

Kenwood KCA-RC547 Manual de usuario

Kenwood

Kenwood KCA-RC35MR Manual de usuario

Kenwood

Kenwood RC-R0801 Manual de usuario

Kenwood

Kenwood KCA-RC527 Manual de usuario

Kenwood

Kenwood KCA-RC60MR Manual de usuario

Kenwood

Kenwood KCA-RC700A Manual de usuario

Kenwood

Kenwood Klicker Manual de usuario

Kenwood

Kenwood Excelon KCA-RC800AV Manual de usuario

Kenwood

Kenwood KCA-RC547 Manual de usuario

Kenwood

Kenwood KCA-RC60MR Manual de usuario

Kenwood

Kenwood GRC-151 Manual de usuario

Kenwood

Kenwood RC-R0801 Manual de usuario

Kenwood

Kenwood KCA-R6A Manual de usuario

Kenwood

Kenwood KRF-V6030 Manual de usuario

Kenwood

Kenwood KCH-20R Manual de usuario

Kenwood

Kenwood KCA-RCDV340 Manual de usuario

Kenwood

Kenwood RC100MR - Marine CD Receiver Remote Control... Manual de usuario

Manuales populares de Mando a distancia de otras marcas

Panasonic

Panasonic EUR7622KB0 Manual de usuario

Bang & Olufsen

Bang & Olufsen Beo4 Manual de usuario

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manual de usuario

Multiplex

Multiplex PROFI TX 9 Manual de usuario

One Remote

One Remote RMB4 Manual de usuario

FUTABA

FUTABA 9ZAP - PART2 Manual de usuario

HR Matic

HR Matic HR MULTI 3 Manual de usuario

Yamaha

Yamaha ACC-GNRST-30-20 Manual de usuario

EisSound

EisSound KBSOUND Manual de usuario

Marantz

Marantz RC101 Manual de usuario

Conrad

Conrad FS20 TC6 Manual de usuario

Anritsu

Anritsu MP1777A Manual de usuario

Niles

Niles WVC100 Guía de solución de problemas

RCA

RCA RCU1300 Manual de usuario

Bang & Olufsen

Bang & Olufsen BEO6 Manual de usuario

GE 94901 Manual de usuario

Onbon

Onbon YQ1-75 Manual de usuario

FUTABA

FUTABA R7108SB Instrucciones de instalación