KAMEP Bell J7 Manual de usuario
Thank you for purchasing products from KAMEP.
We distinguish ourselves by an unrelenting
commitment to excellence in terms of our reliable
quality, robust design and whole-hearted service.
All items you bought from KAMEP enjoy life-time
warranty service.
Should you have any questions in using our
products, pleasefeel free to contact us by e-mail. A
reply email with solution will reach you within 24
hours.
Your advice and suggestions will be highly appreci-
ated and welcomed.
Email: [email protected]
Whatsapp: (+86) 189-2848-4091
Website: www.kameplife.com
Warranty Service
1. Meet the doorbell
Camera
PIR Motion Sensor
Microphone
Doorbell Button
LED Indicator
Speaker
Reset Button
Memory Card
Slot
ON/Off Switch
Micro USB Port
(for battery charging)
Security Screw
Charging
Indicator
Li-ion Battery
Built-in
Doorbell comes with a 4,500mAh rechargeable Li-ion battery.
1
Chime can be powered either by AA batteries or a Micro USB
compatible phone charger
Please mind the battery polarities when installing.
Settings
Volume Control
Select Ringtone
Blue indicator
Red indicator
AA Batteries
Micro USB Port
(DC5V power port)
2. Meet the chime (optional)
2
3
3. Charge your doorbell
Prior to the doorbell installation, please charge up your
doorbell for about 8-10 hours till the charging LED
turns BLUE from RED.
LED STATUS INDICATION
Battery charging
Fully charged
Solid red
Solid blue
Compatible charger ( not provided ):
USB compatible phone charger (DC 5V 1A~2A).
4
Switch on power for your doorbell, and you will see
the LED indicator flashes red (once per second). Start
setting up your doorbell following the in-app instruc-
tions.
4. App download
5. Set up doorbell
Search ‘Cloudot’ in the App stores or scan below QR
codes to download the App.
LED Indicator
ON/Off Switch
5
Tips
• Please operate the setup near your Wi-Fi router.
• Make sure your phone is connecting to a 2.4GHz Wi-Fi.
• Make sure the doorbell is turned on, and its indicator
LED is flashing red. If not, press and hold RESET for 5
seconds.
• Ensure the Wi-Fi signal is good, and the Wi-Fi password
is correct.
LED STATUS INDICATION
Device is abnormal.Solid red
Ready for Wi-Fi configuration.
Connecting to Wi-Fi
Device is onlineSolid blue
Live-viewing doorbell cam
Firmware upgrading
Flash blue (once/sec)
Flash blue (twice/sec)
Flash red (once/sec)
Flash red (twice/sec)
Click the SETTING button on the chime, and the chime
will be in pairing mode for 20 seconds, with its red LED
flashing.
6
6. Pair with chime (optional)
Press the doorbell button to send a pairing signal, and
your chime will sound to react, together with its blue LED
flashing. Chime pairing succeeds.
Chime rings &
indicator flashes blue
Settings
Flashing Red
Tabla de contenidos
