SAFETY INFOR MATION
READ INSTRUCTIONS!
·
·
SAFETY WARNINGS
·
· Keep children away from work area.
·
· 2Ton/4412 lbs.)
·
suitable for the weight.
· Only use this jack on level, flat, hard surfaces.
·
during the lifeof the jack.
· The operator and any bystanders of the jack should be trained and use care
·Improperly secured loads, overloading, and off-center loads may all lead
to failing, slipping, falling, etc. of the object being supported. It is up to the
operator to properly load the jack.
· Do not use this jack for a task it was not designed for.
· Before each use the operator should inspect the jack for any abnormal
· Do not move the vehicle or other load while on the jack.
·
INITIAL SET UP
INSTALLING HANDLE
1.
2.
Loosen the thumb screw( 42 ) on the floor jack where the handleis installed. Slide the
handle into the socket whilelining up the square drive on the jack to the handle.
3. Tighten the thumb screw ( 42 ) to secure the handle in its place.
The K-Tool 2 Ton Aluminum Double-Piston Hydraulic Floor Jack raises the vehicle quickly, and
with a 3-3/10” minimum saddle height, it gets under low-profile vehicles without a problem. It’s
made of strong, lightweight, aluminum for easy maneuvering around your garage. Meets ANSI
2
Attach the upper and lower handle(46) together by aligning the steel sheet (45)
