Juniper mesa 2 Guía de instalación y uso
How to activate Verizon Wireless on a
Mesa 2 with OS 18323
Inserting a SIM card from Verizon Wireless may not immediately activate on a Mesa 2 unit that has
“Original OS Version: 18323” in “Device Info” similar to as shown below.
To activate, please follow these steps.
1. Download and extract the following archive file. This file is large, so may take a while to
download. You may also need to allow permissions to download and access this file.
Sierra-Wireless-EM-7355-build-4775.zip
2. Once the files are all extracted to the same folder on the Mesa 2, run the
“Generic7355DriverSetup.exe” installer. It may take a minute or two for this large file to launch.
3. Follow the instructions provided by the installer until finished.
4. If still needed, perform a Shut Down then insert the SIM card (with applying adhesive tape for a
pull tab). Otherwise, perform a Restart.
5. Once the unit has finished powering back on and rebooting, check the status under Cellular. It
should now show Verizon and state “Getting ready…” for a minute or two. The setup should be
complete when the status changes to Connected.
Otros manuales para mesa 2
4
Tabla de contenidos
Otros manuales de Tableta de Juniper
Juniper
Juniper mesa 4 Manual de usuario
Juniper
Juniper Mesa 3 Manual de usuario
Juniper
Juniper Mesa 3 Manual de usuario
Juniper
Juniper Mesa Rugged Notepad Manual de usuario
Juniper
Juniper Mesa Manual de usuario
Juniper
Juniper mesa 2 Manual de usuario
Juniper
Juniper Mesa Manual de usuario
Juniper
Juniper Mesa Pro Manual de usuario
Juniper
Juniper mesa 2 Manual de usuario
Juniper
Juniper mesa 4 Manual de usuario
