Johnny Vac JVC70RIDER Manual de usuario
Floor Scrubber
JVC70RIDER
OPERATOR MANUAL
Please read this manual before operating the machine.
2www.johnnyvac.com
Introduction
Each new model shall be equipped with this operator manual to provide
necessary instructions for operation and maintenance.
Please read this manual carefully before operating and repairing this manual for a full
understanding of this machine.
In spite of the excellent services this machine provides with, adhesion to the following
precautions will bring more benet with less endeavor:
● Operate the machine with caution.
● Maintain the machine periodically--according to maintenance instructions for
the machine.
● Use the special parts provided by GAOMEI or equivalent ones during maintenance.
Usage:
JVC70RIDER is a ride-on industrial/commercial machine used to scrub rough
and smooth hard surfaces such as concrete, ceramic tile floor, stone, and synthetic
materials, etc. Typically, this machine is designed solely for cleaning smooth ooring
in an indoor environment like schools, hospitals/health care facilities, ofce buildings,
and marketplace, but it is not allowed to use it on earth surface, grassland, articial
turf, or carpeted areas, neither can it be used for road cleaning. Any operation other
than those stated in the operator manual is not recommended.
PROTECT THE NVIRONMENT
Please dispose of the pack materials,
old machine parts and used battery
cells following local waste disposal
regulations.
See to it that recycling carried out
appropriately
MACHINE DATA
Please fill this form at the time of
installation for future references.
Model No.-
Serial No.-
nstallation Date-
3
JVC70RIDER
OPERATOR MANUAL
www.johnnyvac.com
Contents
Safety Precautions.....................................4
Operation...............................................8
Machine Components................................8
Controls and instruments.......................... 9
Operation principle..................................10
Scrubbing method....................................10
Brush information....................................11
Machine setup..........................................12
Install queegee assembly ........................12
Install brush/pad holder/cleaning pad......12
Fill solution tank......................................13
Machine operation...................................14
Pre-operational check..............................14
Before operation......................................14
Scrubbing................................................15
During operation......................................17
Scrubbing method....................................17
Water gauge tube of solution tank............18
Recovery tank full indicator.....................19
Battery Voltage Indicator.........................19
Overload reset switch..............................20
Backup light.............................................20
Drain and clean the recovery tank............21
Troubleshooting.......................................24
Maintenance........................................26
Maintenance form...................................26
Battery charge..........................................27
Precautions for Battery installation and
Use...........................................................27
Brush, pad holder, cleaning pad
replacement.............................................28
Brush and cleaning pad installation.........28
Squeegee blade........................................29
Squeegee blade replacement....................30
Squeegee blade adjustment......................33
Push, Tow and transport the machine.......34
Machine storage.......................................35
Frost protection........................................35
Charger LED indicator.............................35
Specications.......................................36
Machine dimension /capacity..................36
Type.........................................................36
Duty caster...............................................36
Machine dimensions................................37
Contents
4www.johnnyvac.com
Safety Precautions—Keep Properly
Safety Precautions—Keep Properly
Signs used in this manual and relevant instructions are given as follows:
WARNING: To warn the hazards or unsafe operations that may cause severe
personal injury or death.
The following signs mean warning of danger for operators who should learn
about when such situation will occur,how to find all the potential safety
hazards, and report on machine damage or fault operation.
WARNING: Hydrogen emitted by batteries may lead to fire or explosion,
keep them away from sparks or open re.
WARNING: Do not use ammable materials in the tank in case of explosion
or re.
WARNING: Flammable materials or reactive materials can cause explosion
or re. Do not pick up.
FOR SAFETY:
1. Do not operate the machine:
-Unless trained or authorized
-Unless operation manual is carefully read and fully understood.
-After taking alcohol or drugs.
-When using a mobile phone or other electronic devices.
-With brake disabled.
-When operator is not in an appropriate working condition.
-If the machine lies in the presence of combustible gas/liquid/dust.
-If it is too dark to check control unit or to operate the machine safely, unless the
machine is under operation or lighting is provided.
-In case of dropped stuff, unless equipped with a ceiling.
2.When operating the machine:
-Check if there is liquid leakage on the machine.
-Keep sparks and open ame away from fuel recharge area.
-Make sure all the safety devices are in place and operate properly.
-Check whether the brake and steering apparatus operate properly.
3. When using the machine:
5
JVC70RIDER
OPERATOR MANUAL
www.johnnyvac.com
-Follow the instructions in this manual.
-Use brake to stop the machine.
-Go slowly on inclines and slippery surfaces.
-Slow down before turning.
-Make sure the whole body of operator is inside the control console when the
machine is running.
-Take care when the machine reverses.
-Children are forbidden to play on or near the machine.
-Do not carry passengers on the machine.
-Follow safety and trafc rules.
-Report machine damage or fault operation immediately.
-Follow the mixing and handling instructions on chemical containers.
-Follow the safety instructions on wet oor.
-Follow the in-situ safety instructions on wet oor.
4. Before leaving or servicing the machine:
-Stop the machine on level surfaces.
-Turn off machine and remove the key.
5. When service the machine:
-All the job must be done in an environment with good illumination ad high
visibility.
-Avoid moving parts. Do not wear loose jackets, shirts or sleeves when working on
the machine. Get long hair tied.
-Do not push or tow the machine on inclines with the brake disabled.
-Do not power spray or hose off the machine. Electrical malfunction may occur.
-Disconnect battery before working on the machine.
-Battery must be installed by trained or authorized personnel.
-Maintenance must be carried out by well-trained technicians.
-Do not ret the any part of the machine that is different from its original design.
-Use the parts provided or approved by JohnnyVac.
-Wear necessary personal protective equipment recommended by this manual.
FOR SAFETY: Wear hearing protection devices.
FOR SAFETY: Wear protection gloves.
FOR SAFETY: Wear eye protection devices.
FOR PROTECTION: Wear a dust musk.
Safety Precautions
6www.johnnyvac.com
6. When loading/unloading the machine onto/off the truck or trailer:
-Drain the tanks before loading machine.
-Lower the scrub head and squeegee before tying down the machine.
-Turn off the machine and remove the key.
-Use a ramp, truck or trailer that can support the machine weight and operator's.
-Use a winch. Do not push the machine onto the truck or trailer/pull it off the truck
or trailer unless loading height is less than 380 mm (15in) above the ground.
-Block the machine tires.
-Tie the machine to the tuck or trailer.
7
JVC70RIDER
OPERATOR MANUAL
www.johnnyvac.com
Safety labels are marked on appropriate surfaces according to their contents. Please
replace the labels in case they are missing, damaged or difcult to recognize.
Warning label--Hydrogen emitted by
batteries may lead to fire or explosion,
keep them away from sparks or open
re. Keep the cap open while charging.
Warning label--Flammable materials
can cause explosion or fire. Do not
use such materials in the tanks.
Safety label--Read the
operator manual before
operating the machine
On the seat panel
Safety label--Authorized
technicians only.
On the electronic panel
below the seat.
On the seat panel
On the seat panel
Safety label--Read the
operator manual before
operating the machine
Warning label-- Flammable
materials or reactive materials can
cause explosion or re. Do not pick
up.
8www.johnnyvac.com
Machine Components
1. Main handle
2. Backup light
3. Hand brake handle
4. Steering wheel
5. Operation panel
6. Brake pedal
7. Pedal switch
8. Driving wheel
9. Water valve handle
10. Brush waterproof blade
11. Guide wheel
12. Battery charge interface
13. Discharge hose
14. Solution tank cap
15. Vacuum hose
16. Squeegee caster
17. Squeegee assembly
18. Wall Roller
19. Duty caster
20. Brush disc
2
5
13
14
16
15
17 20
1
4
3
6
12
78
9
10
11
18 19
9
JVC70RIDER
OPERATOR MANUAL
www.johnnyvac.com
Operation
Controls and Instruments
1.Battery electricity meter
2.Fault indicator light
3.Brush motor switch
4.Vacuum motor switch
5.Main power switch
6.Loudspeaker button
7.Forward/backward switch
8.Circuit-Breaker
9.Speed control switch
Signs on the Console
Main power
switch
Vacuum motor
switch
Brush motor
switch
Forward/
backward
switch
Speed
control
switch
Speaker
1
2
4
3
5
6
7
8
9
10 www.johnnyvac.com
Parts need to be cleaned up: A
solution tank, brush, pad holder
or pad, a squeegee assembly, a
vacuum motor and a recovery
tank.
Brushing function is controlled
by the buttons on the control
panel. Turn on brush motor
switch and squeegee lifting
switch, lay the brush and
squeegee down. Set forward/
backward switch to "forward"
position, adjust the speed switch
appropriately (turn the switch to proper speed and water yield based on different
types of ground). Release the manual brake and depress the pedal to start washing.
There are two brushes available, and the width of brush head is 360mm (14 inches).
NOTE: The type of brush head or cleaning pad is determined by the severity and
type of dirt. For special suggestions, please refer to Section Brush Information of
this manual or conduct the representatives of GAOMEI.
Scrubbing Method
Water and detergent in solution tank ow to the brush and ground via the magnetic
valve. The solution of water and detergent is used to scrub the ground by brush head
rotation. The squeegee will take up the waste water into solution tank with vacuum
motor while the machine is operating.
Operation Principle
Tabla de contenidos
Otros manuales de Depurador de Johnny Vac
Johnny Vac
Johnny Vac JVC85BCT Manual de usuario
Johnny Vac
Johnny Vac JVC50BCN Manual de usuario
Johnny Vac
Johnny Vac JVC65RBTN Manual de usuario
Johnny Vac
Johnny Vac JVC56RIDERN Manual de usuario
Johnny Vac
Johnny Vac JVC110RIDER Manual de usuario
Johnny Vac
Johnny Vac JVC70RIDERN Manual de usuario
Johnny Vac
Johnny Vac JVC50BC Manual de usuario
Johnny Vac
Johnny Vac JVC110RIDERN Manual de usuario
Johnny Vac
Johnny Vac JVC56BN Manual de usuario
Johnny Vac
Johnny Vac JVC50BCN Manual de usuario
