Jeep 2018 WRANGLER Manual de usuario

2018 JEEP

®WRANGLER QUICK REFERENCE GUIDE

ALL NEW

Vehicle User Guide

Access your Owner’s Information – right

through your Uconnect 4C or 4C NAV touch-

screen radio — If Equipped.

To access the Vehicle User Guide on your

Uconnect Touchscreen: Push the Uconnect

Apps button, then push the Vehicle User Guide

icon on your touchscreen. No Uconnect regis-

tration is required.

NOTE:

Vehicle User Guide features are not available

while the vehicle is moving. If you try to access

while the vehicle is in motion, the system

displays: Feature not available while the vehicle

is in motion.

Pre-Installed Features

• Your User Guide

— Updated in

real-time

• Available when

and where you

need it

• Touchscreen

convenience

• Customizable

interface

• Maintenance

schedules and

information

• Multilingual

• Comprehensive

icon & symbol

glossary

NOTE:

Uconnect screen images are for illustration

purposes only and may not reflect exact soft-

ware for your vehicle.

Introduction To Keyless

Enter-N-Go

The Keyless Enter-N-Go — Passive Entry sys-

tem is an enhancement to the vehicle’s key fob.

This feature allows you to lock and unlock the

vehicle’s door(s) without having to push the key

fob lock or unlock buttons as well as starting

and stopping the vehicle with the push of a

button.

Vehicle User Guide Touchscreen Icon

VEHICLE USER GUIDE — IF

EQUIPPED

KEYLESS ENTER-N-GO —

PASSIVE ENTRY

To Lock The Vehicle’s Doors

With a valid Keyless Enter-N-Go key fob within

5 ft (1.5 m) of the driver or passenger front door

handles, push door handle lock button to lock

all doors.

Do NOT grab the door handle, when pushing

the door handle lock button. This could unlock

the door(s).

NOTE:

• After pushing the door handle lock button,

you must wait two seconds before you can

lock or unlock the doors, using either Passive

Entry door handle. This is done to allow you

to check if the vehicle is locked by pulling

the door handle without the vehicle reacting

and unlocking.

• The Passive Entry system will not operate if

the key fob battery is dead.

The vehicle doors can also be locked by using

the key fob lock button or the lock button

located on the vehicles interior door panel.

Push The Button To Lock

Do NOT Grab The Handle When Locking

To Unlock From The Driver Or

Passenger Side

With a valid Keyless Enter-N-Go key fob located

outside the vehicle and within 5 ft (1.5 m) of

the driver or passenger side door handle, grab

either front door handle to unlock the door

automatically.

For further information, and applicable warn-

ings and cautions, please refer to the Owner’s

Manual at www.mopar.com/en-us/care/

owners-manual.html (U.S. Residents) or

www.owners.mopar.ca (Canadian Residents).

To Unlock/Lock The Swing Gate

To Unlock/Enter The Swing Gate

The Swing Gate passive entry unlock feature is

built into handle of the Swing Gate. With a valid

Passive Entry key fob within 5 ft (1.5 m) of the

Swing Gate, pull the Swing Gate handle to open

with one fluid motion.

Grab The Door Handle To Unlock

Swing Gate Passive Entry Location

To Lock The Swing Gate

With a valid Passive Entry key fob within 5 ft

(1.5 m) of the Swing Gate, push the passive

entry lock button located on the outside Swing

Gate door handle.

NOTE:

The Swing Gate passive entry lock button will

lock all doors and the Swing Gate. The Swing

Gate unlock feature is built into the Swing Gate

handle.

Front Door Removal

NOTE:

•Doors are heavy; use caution when removing

them.

•Hinge pin can break if overtightened during

door reinstall (Max Torque: 7.5 ft· lb / 10 N·m).

1. Roll down the glass window to prevent any

damage.

2. Remove the hinge pin screws from the upper

and lower outside hinges (using a #T50 Torx

head driver).

NOTE:

The hinge pin screws and nuts can be stowed

in the rear cargo tray located under the rear

loadfloor.

Door Removal Warning Label

Hinge Pin Screw

DOORS

3. Remove the plastic wiring access door under

the instrument panel by sliding the plastic

panel along the door frame toward the seats

until the tabs are detached.

NOTE:

Do not pry back to open, as this will break the

plastic cover.

4. Pull up on the red locking tab to unlock the

wiring harness.

5. Push and hold down the black security tab

under the wiring harness, and lift the har-

ness into the open position.

6. With the wiring harness open, pull down-

ward on the wiring connector to unplug.

Store wiring connector in the lower door

basket.

7. Remove the check screw from the center

door check (using a #T40 Torx head driver).

Wiring Access Door

Closed Wiring Harness

1 – Locking Tab

2 – Wiring Harness

Door Check

8. With the door open, lift the door with the

help of another person, to clear the hinge

pins from their hinges and remove the door.

To reinstall the door(s), perform the previous

steps in the opposite order.

NOTE:

The upper hinge has a longer pin, which can be

used to assist in guiding the door into place

when reinstalling.

Rear Door Removal (Four-Door

Models)

NOTE:

•Doors are heavy; use caution when removing

them.

•Hinge pin can break if overtightened during

door reinstall (Max Torque: 7.5 ft· lb / 10 N·m).

1. Roll down the glass window to prevent any

damage.

2. Remove the hinge pin screws from the upper

and lower outside hinges (using a #T50 Torx

head driver).

NOTE:

The hinge pin screws and nuts can be stowed in

the rear cargo tray located under the rear load

floor.

3. Slide the front seat(s) fully forward.

4. Pry open and remove the plastic wiring ac-

cess door from the bottom of the B-pillar.

5. Unplug the wiring connector.

Door Removal Warning Label

NOTE:

Squeeze the tab on the base of the wiring

harness. This will unlock the connector tab,

allowing the wiring connector to be unplugged.

6. Remove the check screw from the center

door check (using a #T40 Torx head driver).

7. With the door open, lift the door with the

help of another person, to clear the hinge

pins from their hinges and remove the door.

To reinstall the door(s), perform the previous

steps in the reverse order.

NOTE:

The upper hinge has a longer pin, which can be

used to assist in guiding the door into place

when reinstalling.

For further information, and applicable warn-

ings and cautions, please refer to the Owner’s

Manual at www.mopar.com/en-us/care/

owners-manual.html (U.S. Residents) or

www.owners.mopar.ca (Canadian Residents).

Easy Entry Seat — Two Door

Models

Pull upward on the easy entry lever located on

the outboard side of the seat back, and slide the

entire seat forward.

To return the seat to a sitting position, fold the

seatback upright until it locks and push the

seat rearward until the track locks.

Wiring Connector

Easy Entry Lever

SEATS

Fold And Tumble Rear Seat —

Two Door Models

Folding The Rear Seat

1. Lift the seatback release lever, located on

the seatback between the head restraints,

and fold the seatback forward.

2. Slowly flip the entire seat forward.

3. Use the two retention straps located on the

back of the rear seat and two corresponding

wire loops located on the back of each

b-pillar, and thread the hook-and-loop fas-

teners on the straps through the loops to

secure the seat in the folded position.

For further information, and applicable warn-

ings and cautions, please refer to the Owner’s

Manual at www.mopar.com/en-us/care/

owners-manual.html (U.S. Residents) or

www.owners.mopar.ca (Canadian Residents).

Folding Rear Seat — Four Door

Models

To fold the seat, lift upward on the seatback

release lever, located on the outboard sides of

the rear seat, and slowly fold down the seat-

back. The head restraint will fold automatically

with the seat when this lever is pulled.

Rear Seat Tumble Position Retention Strap

Seatback Release Lever

1 — Seatback Release Lever

2 — Head Restraint Release Lever

Four–Wheel Drive Operation

Four And Five Position Transfer Case

The transfer case provides the following mode

positions:

Rear Wheel Drive High Range — This range is

for normal street and highway driving on dry,

hard surfaced roads.

4H AUTO — If Equipped

Four-Wheel Drive Auto High Range — This

range sends power to the front wheels. The

four-wheel drive system will be automatically

engaged when the vehicle senses a loss of

traction. Additional traction for varying road

conditions.

4H / 4H PART TIME (P-T)

Four-Wheel Drive High Range — This range

maximizes torque to the front driveshaft, forc-

ing the front and rear wheels to rotate at the

same speed. This range provides additional

traction for loose, slippery road surfaces only.

NEUTRAL (N)

Neutral — This range disengages both the front

and rear driveshafts from the powertrain. To be

used for flat towing behind another vehicle.

Refer to “Recreational Towing” in “Starting

And Operating” in your Owner’s Manual at

www.mopar.com/en-us/care/owners-manual.html

(U.S. Residents) or www.owners.mopar.ca (Ca-

nadian Residents) for further information.

Four-Wheel Drive Low Range — This range

provides low speed four-wheel drive. It maxi-

mizes torque to the front driveshaft, forcing the

front and rear wheels to rotate at the same

Four Position Four-Wheel Drive Gear Selector

Five Position Four-Wheel Drive Gear Selector

STARTING AND OPERATING

Otros manuales para 2018 WRANGLER

Tabla de contenidos

Otros manuales de Automóvil de Jeep

Jeep

Jeep 2010 Wrangler Manual de usuario

Jeep

Jeep GRAND CHEROKEE 2023 Manual de usuario

Jeep

Jeep Patriot Instrucciones de funcionamiento y seguridad

Jeep

Jeep 2002 WG Grand Cherokee Manual de usuario

Jeep

Jeep Jeep Wrangler Manual de usuario

Jeep

Jeep 2016 CHEROKEE Manual de usuario

Jeep

Jeep Liberty 2011 Manual de usuario

Jeep

Jeep CHEROKEE 2017 Manual de usuario

Jeep

Jeep Compass Manual de usuario

Jeep

Jeep 2009 Wrangler Manual de usuario

Jeep

Jeep 2020 RENEGADE Manual de usuario

Jeep

Jeep Compass Manual de usuario

Jeep

Jeep 2016 CHEROKEE Manual de usuario

Jeep

Jeep GLADIATOR 2023 Manual de usuario

Jeep

Jeep Compass 2022 Manual de usuario

Jeep

Jeep 2015 Wrangler Manual del propietario

Jeep

Jeep 2016 CHEROKEE Manual de usuario

Jeep

Jeep Grand Cherokee 2015 Manual de usuario

Jeep

Jeep Liberty 2007 Manual de usuario

Jeep

Jeep Gand Sherokee 2016 Manual de usuario

Jeep

Jeep 2010 Grand Cherokee Manual de usuario

Jeep

Jeep 2014 Patriot Instrucciones de funcionamiento e instalación

Jeep

Jeep Patriot Guía de instalación

Jeep

Jeep compass 2017 Manual de usuario

Manuales populares de Automóvil de otras marcas

Toyota

Toyota 2000 Tundra Manual de usuario

CITROËN

CITROËN DS4 DSign Manual de usuario

Lexus

Lexus 2015 CT 200h Manual de usuario

Cadillac

Cadillac CTS 2008 Manual de usuario

Mercedes-Benz

Mercedes-Benz M-class ML 55 AMG Manual de usuario

Porsche

Porsche Boxster S Manual de usuario

GMC

GMC 2010 Savana 1500 Cargo Manual de usuario

KIAM

KIAM SPORTAGE 2014 Manual de lista de piezas

GMC

GMC 2013 Terrain Instrucciones de montaje

GMC

GMC T-Series 1999 Manual de usuario

Mercury

Mercury 1998 Mystique Manual de usuario

Mercury

Mercury 2007 Mariner Manual de usuario

Mazda

Mazda 2007 Mazdaspeed 3 Guía

Mazda

Mazda 2014 CX-5 Manual de usuario

GMC

GMC Chevrolet Express 2022 Manual de usuario

GMC

GMC 1997 Jimmy Manual de usuario

Chevrolet

Chevrolet 2012 Malibu Manual de usuario

Cadillac

Cadillac 2010 Escalade Manual de usuario