JAMO JSS4-TS Manual de usuario

Tabla de contenidos

Manuales populares de Oradores de otras marcas

argon audio

argon audio IE20 Manual de usuario

Denon

Denon SC-N7 Manual de usuario

Gemline

Gemline Ace 3952 Manual de usuario

Focal

Focal ON WALL 300 Manual de instrucciones

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manual de usuario

SoundLogic

SoundLogic BCCS-6/6395 Manual de usuario

Peavey

Peavey DTH 218 Manual de usuario

Avantree

Avantree Pluto Air Manual de usuario

Morel

Morel Integra Series INTEGRA OVATION 4 Manual de usuario

Oppo

Oppo SONICA Manual de usuario

Bose

Bose SoundLink Wireless Music System Manual de usuario

Rocksteady

Rocksteady Stadium Manual de usuario

Bowers & Wilkins

Bowers & Wilkins 4 Manual de usuario

Sonance

Sonance SONOS OUTDOOR Series Manual de usuario

Electro-Voice

Electro-Voice EVID FM4.2 Manual de usuario

Pioneer

Pioneer XW-HTD630 Manual de usuario

Onn

Onn BWA16AA002 Manual de usuario

HP

HP GL313AA - USB Speakers PC Multimedia Manual de usuario

JSS4-TS

WARNING: Improper installation could result in damage to the amplifier. Read all instructions

before installation.

All manuals and user guides at all-guides.com

all-guides.com

Introduction

Your JSS4-TS speaker selector allows simultaneous operation of up to 4 pairs of 8 hm speakers.

Automatic load protection circuits assure that the amplifier will always see a load of 4 hms or

higher no matter what combination of speaker is turned N. The built-in protection circuit

operates with switch pairs, permitting hookup choices for maximum power to your most

frequently used speakers (up to 2 pairs). More information will be found under INSTALLATI N

below.

The left and right channels are completely separate to assure safe operation with any type of

amplifier, including those with isolated grounds (bridging outputs).

ther features include power handling capability of up to 155 watts per channel.

Installation

When any speakers are turned on resistance is inserted in series with them in order to keep the

amplifier load at 4 hms or higher. Coupling to any speaker is always direct when only one

switch in  N

The JSS4 rubber feet provide a non-marring, stable mount to permit convenient placement.

Allow room for adequate ventilation around the switch box, it can become quite warm if opera-

tion at high power with the productive resistors switched in. Do not place on surfaces easily

damaged by heat.

The JSS4 front panel buttons all operate in the same manner, push to turn N, push again to

turn FF. The switch is N when pushed in closest to the JSS4 front panel.

Caution: Do not apply audio power in excess of 155 watts per channel when the internal

impedance matching resistors are switched in! DAMAGE T C MP NENTS CAUSED BY EXCES-

SIVE P WER APPLICATI N IS N T C VERED UNDER WARRANTY.

All manuals and user guides at all-guides.com

Connection

To make a connection, strip about ¼in of insulation from the end, twist any loose strands toget-

her tightly so that no loose end sticks out to cause problems with short circuits. Make the

connection by unscrewing the binding post counterclockwise and exposing the wire hole. Insert

the stripped wire end into the wire hole and tighten the binding post by turning it clockwise.

Make sure the metal conductor contacts the stripped part of the wire, not the insulation, and

there are no loose strands to cause problem short circuits.

bserve polarity when making connections, making sure +(plus) goes to + (plus), - (minus) goes

to  (minus) and that the channels are not crossed. Improper connections can cause the system

to be inoperative or less than optimum.

Following the same precautions, connect the speaker wires to the appropriate JSS4 terminals

marked output.

All manuals and user guides at all-guides.com

69441 / 33.2000

The scope of the warranty

The warranty period will come into force as from the purchase date stated on the invoice. The warranty will

apply for the following period of time:

 2 years for electronics (power supply, amplifier, etc.)

 7 years for other parts (cabinet, speaker units, etc.)

In case of warranty inquiries, please contact your dealer.

In case of request for service under warranty, please enclose your original receipt.

Defects covered by the warranty:

Except for the defects stated below, the warranty covers any production and material defects of the product.

Defects not covered by the warranty:

 Defects arising from accidents, misuse, normal wear and tear, mis-maintenance, voltage variation,

overloading, stroke of lightning, and other force majeure events

 Defects arising from incorrect installation or operation

 Defects arising from modification/repair/attempt of repair by a non-authorised service centre

 Defects arising from the use of non-original spare parts

 Defects on products with altered or lacking series number

 ther defects due to conditions or circumstances beyond the suppliers control

Transportation costs for servicing are not covered by the warranty.

The supplier is liable only to repair or replace defective parts or products. A replacement cannot exceed the

value of the product under warranty.

All manuals and user guides at all-guides.com