Jabra BIZ 2400 Series Manual de usuario
1
USER MANUAL
www.jabra.com
Jabra BIZ 2400
2
© 2012 GN Netcom A/S. All Rights Reserved.
This user guide is published by GN Netcom A/S.
The information in this user guide is furnished for informational use only, is subject to change without notice, and
should not be construed as a commitment by GN Netcom A/S. GN Netcom A/S assumes no responsibility or liability
for any errors or inaccuracies that may appear in this user guide.
Written and designed at GN Netcom A/S, Lautrupbjerg 7, 2750 Ballerup, Denmark, www.jabra.com.
part overview
HEADBAND ASSEMBLY
1 Headband
2 Ear cushion
EAR HOOK ASSEMBLY*
5 Ear hook ring 6 Ear gel
7 Ear hooks
(Small/Large)
HEADSET
3 Headset
4 Quick disconnect
connector
4
6
1
2
8
3
NECKBAND ASSEMBLY*
8 Neckband 9 Neckband ring
CLOTHING CLIP
10 Name tag
11 Transparent cover
*Only included in some Jabra BIZ 2400 models. Also available to order as accessory
5
7
9
3
connecting the headset to the phone:
- Plug the headset into an adapter cord suited to your phone system
- Unplug the handset from the phone*
- Connect the adapter cord to the handset port
*If your phone has a headset port, connect the adapter cord directly to the headset port.
4
english
Thank you for buying a GN Netcom A/S product.
All GN Netcom A/S products are designed and manufactured in accordance with strict quality standards and
should, with a minimum of maintenance, give many years of satisfactory use.
wearing the headset with the headband
All mono Jabra BIZTM 2400 models include a headband attachment. To use it:
1
2 cm
3/4" 2
1. How to wear the headband.
Place the headband over your head, with the headset positioned against your preferred ear and the T-bar
positioned just above the opposite ear. Adjust the headband for optimal t on your head.
2. How to position the microphone.
Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less
than 2 cm from the front of your mouth.
43
3. How to rotate the boom arm.
The boom is free to rotate 360o.
4. How to attach the ear cushion.
Align the ear cushion with the headset ear plate so that the groove in the ear cushion slips around the ridge of
the headset ear plate. Rotating the cushion will ensure it snaps securely into place.
5
65
5. How to remove the headband
Remove the ear cushion by gently pulling it o the ear-plate. Push on the inner part with your thumb until the
headset clicks out of the headband.
6. How to press the headset into the headband ring on the headband.
Hold the headband in one hand and the headset in the other. Align the headset against the outside of the
headband ring with the headset cable pointing down. Gently press the headset into the headband ring until it
clicks into place.
wearing the headset with an ear hook
Two sizes of ear hook are included with some Jabra BIZ 2400 models. They can be purchased as an accessory for
any mono model. To use it:
12 3
R
L
1. How to attach the ear gel.
The ear gel is a round rubber part which helps stabilize the headset on your ear. Place the ear gel inside the
ear hook ring. Gently push the ear gel through the hole so that it sits in the hole. Once you click the headset
into the ear hook ring, the ear gel will be locked into place.
2. How to press the headset into its ear hook ring on the ear hook.
Hold the ear hook ring in one hand and the headset in the other. On the inside surface of the ear hook ring
you will nd "L" and "R" markings. Align the cable of the headset with the "R" marking if you wish to wear it on
you right ear, or "L" if you wish to wear it on your left ear. Gently press the headset into the ear hook ring until
it clicks into place.
6
R
L
3
3. How to position the ear hook on the ear hook ring for left or right ear use.
The ear hook wearing style has two parts: an ear hook and an ear hook ring. One end of the ear hook forms a
pin that presses into a loop on the ear hook ring and holds it there.
You will wear the headset with the ear hook behind your ear and the ear hook opening pointing down towards
your jaw. Decide on which ear you would like to wear the headset and assemble the ear hook and ear hook ring
appropriately.
To change from one ear to the other, pull the ear hook up and away from the loop, and press into the other side
of the loop. Then remove the headset from the ear hook ring. Rotate it and replace it again with the cable posi-
tioned at the ‘L’ or ‘R’ for the selected wearing side as described in point 2.
4
2 cm
3/4"
5 6
4. How to wear the ear hook.
To wear the headset, slip the ear hook behind your ear while keeping the ear gel centred into the middle part
of your ear. The ear hook comes in two sizes for optimal t. Please try both for best personal support and t.
5. How to position the microphone.
Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less
than 2 cm from the front of your mouth.
6. How to rotate the boom arm.
The boom is free to rotate 360o.
7
wearing the headset with the neckband
A neckband wearing style is included with some Jabra BIZ 2400 models. Neckbands can be purchased as an
accessory for any mono Jabra BIZ 2400. To use it:
1
1. How to press the headset into the neckband ring.
The neckband can be assembled for wearing on either the left or right ear. Decide whether you would like to
wear your headset on your left or right ear and position the neckband ring appropriately. Hold the neckband
ring in one hand and the headset in the other. Align the headset against the outside of the neckband ring with
the headset cable pointing down. Gently press the headset into the neckband ring until it clicks into place.
32
2. How to attach the ear cushion.
Align the ear cushion against the neckband ear plate so that the groove in the ear cushion slips around the
ridge of the ear plate. Rotating the cushion will ensure it snaps securely into place (you can remove it as you
attach it).
3. How to position the neckband on the neckband ring.
Attach the neckband by sliding the left or right tip of the neckband through the loop in the neckband ring.
Note the small bump inside the neckband ring; this must align with the groove on the tip of the neckband.
8
2 cm
3/4"
456
4. How to wear the neckband.
Wear the neckband so the band goes around the back of your neck and the bowed sections go over your right
and left ear respectively, whilst the ear cushion sits on your ear.
5. Position the microphone.
Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less
than 2 cm from the front of your mouth.
6. How to rotate the boom arm.
The boom is free to rotate 360o.
wearing a duo headset
(Duo models only)
The duo version of Jabra BIZ 2400 is always worn as a headband. To wear and adjust your headset:
1 2
1. Adjust the headband length.
The headband is adjustable in length to t the size of your head. Push or pull the top section of the
headband until the headset ts comfortably.
2. How to wear the headset.
Position one speaker over each ear with the headband going over the top of your head, just as with a
traditional pair of headphones. The headset can be worn on either the left or right ear, simply rotate
the boom arm as needed.
9
3 4
2 cm
3/4"
3. How to position the microphone.
Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less
than 2 cm from the front of your mouth.
4. How to rotate the boom arm.
The boom is free to rotate 360o.
connecting the headset to a phone or computer
The headset features a Quick Disconnect (QD) connector, which enables you to use the headset with a variety of
telephones, computers and other sound sources by attaching any of the QD cords and adapters available from
GN Netcom A/S.
To connect your headset to a QD adapter, simply press its connector into the similar connector on your adapter.
Then connect the adapter to a telephone or computer and your headset is ready to use.
You can disconnect your headset at any time without terminating the current call (if any). To do so, hold the QD
adapter with your thumb and index nger and pull the connectors apart. Always pull on the connectors, never
on the cords.
For more information about QD adapters, please see the documentation that came with your adapter and/or go
to www.jabra.com.
care, cleaning and maintenance
- Avoid getting the headset wet and never submerge it in water.
- Avoid stretching, bending or twirling the wire; this will weaken the connectors and the wire itself and may
result in loss of audio.
- Do not block the microphone holes on either side of the boom arm. Advanced Jabra BIZ 2400 models
feature a small hole on both the inward and outward facing sides of the boom. This front-facing hole is a
noise-cancelling feature and does not allow extra noise into the microphone.
- You can clean the ear cushions or other parts of the headset by using a cleaning wipe designed for use with
electronic and plastic equipment. Allow to dry before replacing them. Suitable tissues are available from
GN Netcom A/S; contact your GN Netcom A/S representative for details. After extensive use, the ear cushion
may become worn. New ear cushions are available from GN Netcom A/S.
10
Dispose of the product according to local standards and regulations.
www.jabra.com/weee
Otros manuales para BIZ 2400 Series
6
Tabla de contenidos
Otros manuales de Auriculares de Jabra
Jabra
Jabra BT8030 - Headset - Convertible Manual de usuario
Jabra
Jabra BT8040 Multiuse Manual de usuario
Jabra
Jabra SPORT COACH Manual de usuario
Jabra
Jabra GN9120 Flex Manual de usuario
Jabra
Jabra GO 6470 Manual de usuario
Jabra
Jabra BT620S - MANUAL 2 Manual de usuario
Jabra
Jabra Pro 920 Mono Manual de usuario
Jabra
Jabra BT2080 - Headset - Ear-bud Guía de referencia
Jabra
Jabra BT250v - Headset - Over-the-ear Manual de usuario
Jabra
Jabra BIZ 360 Manual de usuario
Jabra
Jabra PRO 9460 Duo Manual del operador
Jabra
Jabra BT3010 - Headset - In-ear ear-bud Manual de usuario
Jabra
Jabra Orator-G Manual de usuario
Jabra
Jabra BT2090 Manual de usuario
Jabra
Jabra BT500 - Headset - Over-the-ear Manual de usuario
Jabra
Jabra SP100 Manual de usuario
Jabra
Jabra Evolve 75e Manual de usuario
Jabra
Jabra Pro 9470 Mono Manual del operador
Jabra
Jabra BIZ 2400 II Manual de usuario
Jabra
Jabra BT135 - Headset - Over-the-ear Manual de usuario
