iPECS Vertical Edge IP 9830 Manual de usuario
iPECS Phone Connection
Last Modified on 10/23/2018 4:43 pm EDT
If you need help:
E-mail service@vertical.com
Call us at 877-VERTICAL (877-837-8422)
Vertical Edge IP 9830 Handset
Your iPECS phone comes with a stand, handset with handset cord, and Ethernet cable.
Connect headset & handset
Phone ports on back of Edge IP
phones (your phone may have
slight differences depending on
model)
Connect the handset cord to the Handset port on the bottom of the phone.
If you are using a headset, connect the headset cord to the Headset port.
Thread the cords through the adjacent channels.
Connect to network
Connect one end of the Ethernet cable into the LAN Ethernet port on the bottom of
the phone. Then connect the other end of the cable to your network connection.
or,
If you are connecting your PC Ethernet through the phone, connect the Ethernet
cable to the PC Ethernet port on the phone instead. Then connect the other end of
the Ethernet cable to the LAN Ethernet connection on your PC.
Connect to power
If you are using Power over Internet (PoE), skip this step.
Connect the AC power adapter to the AC adaptor jack on the bottom of the phone.
Plug the AC power adapter into the nearest AC power outlet.
Attach the stand
Align the tabs on the stand with one of the pairs of notches on the bottom of the
phone. You can choose a lower profile or higher profile setting.
Push the stand upward in the slots as far as it can go until firmly attached.
If you need help, contact iPECS Support .
Tabla de contenidos
Otros manuales de Auricular de iPECS
iPECS
iPECS LIP-9071 Manual de usuario
iPECS
iPECS 1010i Manual del propietario
iPECS
iPECS LIP-9020 Hoja de especificaciones
iPECS
iPECS GDC-800H Manual de usuario
iPECS
iPECS 1030i Manual del propietario
iPECS
iPECS LIP-9010 Hoja de especificaciones
iPECS
iPECS LIP-9040C Manual del propietario
iPECS
iPECS 1050i Manual del propietario
iPECS
iPECS 1040i Manual del propietario
iPECS
iPECS LIP-9010 Hoja de especificaciones
