IPC CT45 BT Manual de usuario

This guide is intended for quick consultation only and does not replace the user and maintenance manual.

Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the

instructions.

PREPARATION & OPERATION

CT45 BT Quick guide

2 3

5 7

8 10 11

PLDC02197.indd

AUTO

ECO

CHEM

> 3”

REPLACING THE SQUEEGEE BLADES

ATTACHING/REMOVING THE BRUSH

Attaching the brush:

• rest the brush on the oor in front of the machine. Raise the front of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Action the drive lever repeatedly until the brush

engages..

Removing the brush:

• Raise the front of the machine by levering on the handle, then operate the brush lever repeatedly. After operating the lever a few times, the brush is released and falls to the ground.

DAILY MAINTENANCE

Clean the dirty

water tank.

Check the dirty water tank oat

is undamaged and clean and

moves freely on the pin.

Check that the

detergent outlet lter

is clean.

Check that the brush is clean.

Replace if necessary.

Check that the

squeegee is clean

and the blades are not

worn.

Open the clip (Ref. 1).

Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.

Remove the blade.

Reuse the same blade by reversing the edge in contact with the oor until all four edges are worn out, or replace with a new blade, tting it onto the

screws on the body of the squeegee.

Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing

devices inwards.

Close the hook again.

Replace the squeegee on its support, following the instructions described previously.

PLDC02197.indd

BATTERY

CHARGER ON

BOARD

Tabla de contenidos