Interlogix TVE-DEC10 Manual de usuario

TVE-DEC10 IP Video

Decoder User Manual

P/N 1072583B-EN • REV 1.0 • ISS 16OCT12

2012 UTC Fire & Security Americas Corporation, Inc.

Interlogix is part of UTC Climate Controls & Security, a unit of United

Technologie

Trademarks and

patents

The

Interlogix name and logo are trademarks of United

Technologies.

Other trade names used in this document may be trademarks or

registered trademarks of the manufacturers or vendors of the

respective products

Manufacturer

UTC Fire & Security Americas Corporation, Inc.

2955 Red Hill Avenue, Costa Mesa, CA 92626

-5923, USA

Authorized EU manufacturing representative:

UTC Fire & Security B.V.

Kelvinstraat 7, 6003 DH Weert, The Netherlands

Certification

N4131

FCC compliance

Class B:

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against har

mful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

There is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to corre

ct the

interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for

help.

European Union

directives

12004/108/EC (EMC directive):

Hereby, UTC Fire & Security

Americas Corporation, Inc

declares that this device is in compliance

or wit

h the essential requirements and other relevant provisions of

Directive 2004/108/EC

2002/96/EC (WEEE directive):

Products marked with this symbol

cannot be disposed of as unsorted municipal waste in the European

Union. For proper recycling, return this

product to your local supplier

upon the purchase of equivalent new equipment, or dispose of it at

designated collection points. For more information see:

www.recyclethis.info.

2006/66/EC (battery directive):

This product contains a battery that

cannot

be disposed of as unsorted municipal waste in the European

Union. See the product documentation for specific battery

information. The battery is marked with this symbol, which may

include lettering to indicate cadmium (Cd), lead (Pb), or mercury

(Hg). For

proper recycling, return the battery to your supplier or to a

designated collection point. For more information see:

www.recyclethis.info.

Contact information

For contact information

, see www.utcfireandsecurity.com or

www.utcfssecurityproducts.eu

TVE-DEC10 IP Video Decoder User Manual i

Content

Introduction 1

Package contents 1

Key features 1

Product description 2

Connections 3

Network settings 5

TruVision Device Finder 5

Using a web browser 8

Before you start 8

Accessing the web browser 8

Decoder operation 10

Dynamic decoding 11

Sequence mode 11

Remote playback 12

Display settings 14

Enable/disable decoding channel 14

Image scaling 15

Picture overlay 15

Connection status 16

Check decoding channel status 17

Check display channel status 17

Transparent channel 18

Configuration 19

Device properties 19

Time settings 20

Basic network settings 21

Alarm input settings 22

Serial ports 23

Arming time 23

User account management 24

Device management 26

Specifications 27

ii TVE-DEC10 IP Video Decoder User Manual

TVE-DEC10 IP Video Decoder User Manual 1

Introduction

The TruVision TVE H.264 IP video decoder converts compressed IP video

streams to analog video output for display. Based on a powerful DSP and a

stable embedded system design, the TVE-DEC10 decoder provides a high

resolution decoding function for both live view and playback streams from

Interlogix IP cameras, digital video recorders and network video recorders

This user manual provides basic information on setting up and using the TVE-

DEC10 model.

The decoder browser is shipped with on-screen display (OSD) menus in English

only.

Package contents

The TruVision TVE H.264 IP video decoder is shipped with the following items:

• TVE-DEC10 decoder

• Power adaptor

• Power cable

• Quick start guide

• CD (includes the user manual and TruVision Device Finder)

Key features

The following key features are supported by TVE decoders:

• Supports compression H.264 and MPEG4 codec

• Supports PS, RTP and proprietary encapsulation formats

• Powerful decoding capability: 1-channel video stream at 1080P resolution, 2-

channel video stream at 720P resolution, or 4-channel video stream at 4CIF

resolution

• Multiple video display outputs: BNC, VGA, HDMI, and DVI

• Compatible with Interlogix TruVision IP cameras and TruVision NVRs. Please

check the Interlogix web site for the latest compatible device list.

• Supports PSIA communication

• Discoverable via the TruVision Discovery Tool

2 TVE-DEC10 IP Video Decoder User Manual

Product description

Figure 1: Front panel

LED indicator

Description

WR The power LED

LINK

Network connection LED

RX/TX

Data transmitting/receiving status LED

RESET

Reset to factory default settings

VGA

VGA decoding output

DVI

DVI decoding output

HDMI

HDMI decoding output

VIDEO OUT

BNC decoding output

Figure 2: Back panel

Item

Name Description

. MIC In Microphone input.

. Audio Out Connect to an audio output device. R is right channel, L is left

channel.

RS-232 Connect to an RS-232 device, such as a computer.

RS-485 Connect to RS-485 serial port.

Alarm Out Connect up to two alarm relay outputs.

Alarm In Connect up to four alarm relay inputs.

LAN Connect the 10M/100M/1000Mbps self-adaptive UTP Ethernet

port to a network.

12 VDC Connect a 12 V power supply via a PSU.

. GND Connect to ground.

TVE-DEC10 IP Video Decoder User Manual 3

Connections

See Figure 2 on page 2 for information on connecting the power, camera, audio

and network cables.

Alarm connections

The TVE decoder supports the open/close relay input as the alarm input mode.

When the alarm input signal is not in open/close relay signal mode, please follow

the connections shown below:

Figure 3: Alarm input connections

Alarm input connections for Emerson alarm:

Alarm input connections for normal alarm:

. Emerson alarm

. V output

. 10 V regulator

4. 4N35 optocoupler

5. Relay output

6. Normal alarm

7. JQC-3FG 24 V relay

The TVE decoder supports the open/close relay input as the alarm output mode.

The alarm input can be selected to NO or NC. Different alarm output connection

methods are applied to the AC or DC load. See Figure 3.

100Ω

ALM(-)

IN(n)

ALM(+)









TVE



Relay input

V-output

Emerson alarm

10 V regulator



10 V regulator

14N34

optocoupler

JQC-3FG

24 V relay

ALM(-)

ALM(+)





IN(n)



TVE

Relay input

V-output

Alarm



4 TVE-DEC10 IP Video Decoder User Manual

Figure 4: Alarm output connections

Note: Please note the different connections of JJ1 shown above. For a DC load,

JJ1can be safely used both in NC and NO methods. It is recommended to use

12 V / 1 A. For an external AC input, JJ1 must be open. The motherboard has

two jumpers, each corresponding to one alarm output. Both jumpers are factory

set to be connected.

TVE-DEC10 IP Video Decoder User Manual 5

Network settings

This chapter explains how to use TruVision Device Finder to find and configure

the IP address and other parameters of the device.

Note: The default user name of TVE is admin and the password is 1234. The

default IP address is 192.168.1.70

TruVision Device Finder

The TruVision Device Finder tool can be found on the CD shipped with that

product.

This tool automatically identifies TruVision devices that support “auto-discovery”

anywhere on the network, even in different subnets. You can view and modify the

IP address of any discovered device.

To install the TruVision Device Finder:

1. Insert the CD in the computer’s CD/DVD drive.

2. Browse to the folder IP Discovery Tool and double-click the Setup file located

in the folder.

3. Click Next.

4. Select the folder where setup will install the files then click Next.

5. The program requires a utility called WinPcap to be installed on the computer.

If it is already installed, go to step 6.

If the program is not installed, the WinPcap window appears. Follow the on-

screen instructions.

6 TVE-DEC10 IP Video Decoder User Manual

6. The TruVision Device Finder Wizard appears. Click Finish to complete its

installation.

Using the TruVision Device Finder

The setup will install the necessary files and place the following shortcut on your

desktop.

Figure 5: TruVision Device Finder shortcut icon

To use the TruVision Device Finder:

1. Double-click the shortcut icon to open the tool.

The Start window appears.

2. Click Start to begin the discovery process.

The list of TruVision devices located on your network appears.

Note: The TruVision Device Finder can only detect devices that are on the

same LAN. The tool cannot detect devices placed on a VLAN.

Otros manuales para TVE-DEC10

Tabla de contenidos

Otros manuales de Hardware de red de Interlogix

Interlogix

Interlogix TruVision 10 Manual de usuario

Interlogix

Interlogix ATS1340 Instrucciones de montaje

Interlogix

Interlogix TruVision 10 Manual de usuario

Interlogix

Interlogix TruVision NVR 50 Manual de usuario

Interlogix

Interlogix TruVision NVR 20 Manual de usuario

Interlogix

Interlogix TruVision NVR 21 Manual de usuario

Interlogix

Interlogix ATS 500A Series Instrucciones de montaje

Interlogix

Interlogix TruVision NVR 20 Manual de usuario

Interlogix

Interlogix TruVision TVN-11 Manual de usuario

Interlogix

Interlogix TruVision NVR 11 Manual de usuario

Interlogix

Interlogix TruVision NVR 22 Manual de usuario

Interlogix

Interlogix TruVision NVR 20 Manual de usuario

Interlogix

Interlogix TruVision NVR 21 Manual de usuario

Interlogix

Interlogix TruVision 10 Manual de usuario

Interlogix

Interlogix TruVision NVR 21P Manual de usuario

Interlogix

Interlogix TruVision NVR 21 Manual de usuario

Interlogix

Interlogix TruVision NVR 50 Manual de usuario

Interlogix

Interlogix TruVision NVR 21P Manual de usuario

Interlogix

Interlogix TruVision Series Manual de usuario

Interlogix

Interlogix TruVision NVR 21 Manual de usuario

Interlogix

Interlogix TruVision 10 Manual de usuario

Interlogix

Interlogix POE303-MS Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario