ARGUS
ARGUS PRI 3
1Introduction ........................................................................................5
2Configuring accesses ........................................................................7
2.1 Access wizard .....................................................................................8
2.2 Notice ................................................................................................12
3Connection for a PRI network .........................................................15
3.1 Pin Assignment on the ARGUS (BRI/PRI/E1) .................................15
4Operation on a PRI Access .............................................................16
4.1 Configuring the PRI Interface and Access Mode Settings ...........16
4.1.1 TE Simulation of a Primary Rate Interface ................................17
4.1.2 NT Simulation of a Primary Rate Interface ................................17
4.2 Initialization Phase including B-Channel Test ...............................17
4.3 Configuring the PRI Parameters .....................................................19
4.4 Bit error rate Test .............................................................................24
4.4.1 Setting the BERT Parameters ...................................................25
4.4.2 BERT start .................................................................................27
4.4.3 BERT saving .............................................................................31
4.4.4 BERT wait .................................................................................32
4.4.5 B-channel loop ..........................................................................33
4.5 Supplementary Services Test .........................................................34
4.5.1 Supplementary Services on DSS1 ............................................34
4.5.2 Error Messages .........................................................................35
4.6 Service Tests ....................................................................................35
4.7 X.31 Test ............................................................................................36
4.7.1 Setting the X.31 Parameters .....................................................36
4.7.2 Automatic X.31 Test ..................................................................40
4.7.3 Manual X.31 Test ......................................................................42
4.8 Connection display ..........................................................................44
4.9 Clear down (disconnect) the connection .......................................50
4.10 Connection setup time .....................................................................52
4.11 The L1 Status of a PRI Access ........................................................53
4.12 Monitor ..............................................................................................56
4.13 Leased line on a PRI access ...........................................................59
4.13.1 Telephony ................................................................................59
4.13.2 Bit error rate Test ....................................................................60
4.13.3 Configuration: BERT ...............................................................62
4.13.4 Loopbox ...................................................................................65
4.14 Managing Multiple Tests on a PRI Access .....................................66
4.14.1 Starting Several Tests to Run Simultaneously ........................67
4.14.2 Switching between Parallel Tests or Connections ..................69
4.14.3 End All Currently Running Tests or Connections ....................70
5Appendix ...........................................................................................72
A) Acronyms ......................................................................................... 72
B) Index ..................................................................................................75
