Quick Start Guide DVR5000-3U Series
WWW.INSTEKDIGITAL.COM | Page 8
e. Change the Time Zone:
System Configuration > Time Zone Change > Select Continent or Area > Select Country/
Region. Press Yes to confirm.
f. Change the Date/Time:
System Configuration > Date/Time Change > Press Proceed to stop the process and wait
for a few seconds > Use [TAB], Up Arrow, Down Arrow to change Year, Month and
Date. Use [TAB], Up Arrow, Down Arrow to change the Hour, Minutes and Seconds >
Press Proceed to accept the changes.
g. Change the IP Address:
System Configuration > Network Settings > IP Configuration Select eth0 > Enable eth0 >
Static IP Configuration > Enter the IP address, Netmask, Gateway > Press OK to proceed.
The eth0’s IP address is changed to “192.168.1.10” in the document. Please wait for a
few moments for the changes to take effect.
h. Add Storage to the NVR:
The first HDD will automatically be in use by the NVR. Subsequent HDDs will need to be
added via the hDSM. Navigate to Storage Management > Add Storage Repository and
select the available storage repositories to add to the NVR. This can be done individually
or by using All to select all available storage repositories. Select OK. Proceed to the menu
option Detect Available Disk Volume to check the status of the HDDs. The status of the
HDDs should display In Use.
i. To restart NVR processes go back to the hDSM main menu and navigate to hDVR > Start.
This will take a few seconds to complete.
Note: Keep the value of MTU as default (1500) unless you have other devices
such as a SAN connected to the same network.
