9
Wireless headphone Channel selection
•Press the SETUP or MENU button to select FM FREQ adjustment
and press UP/DOWN or –ADJUST+ button to select an FM
Frequency you want.
Monitor Aspect ratio
•Press the SETUP or MENU button to select D.MODE adjustment and
press UP/DOWN or –ADJUST+ button to select a Display Mode you
want.
Monitor Dimmer
•Press the DIMMER button to reduce the brightness of the monitor by
half; press it again to resume the brightness.
Dome Lamps
•Slide the Slide Switch (OFF/AUTO/ON) on the main unit to “ON”
position to turn lamps on.
•Slide the Slide Switch (OFF/AUTO/ON) on the main unit to “OFF”
position to turn lamps off.
Automatic operation
•The Dome lamps can be controlled by the car doors. Slide the Slide
Switch (OFF/AUTO/ON) on the main unit to “AUTO” position; when a
door is opened, the two lamps will light; when the door is closed, the
two lamps will go out.
Note: This feature will need to be installed before it will work, please
check with your installation technician.
Wireless Headphones
•A built in FM signal transmitter transmits the wireless headphone
signal. The signals are transmitted over 7 different and selectable FM
frequencies. The wireless headphones receive these frequencies for
the listener.
•The FM signal transmitter will transmit over 7 FM frequencies:
87.7MHz, 87.9MHz, 88.1MHz, 88.3 MHz, 88.5MHz, 88.7 MHz, and
88.9MHz. It is possible to receive these signals over any FM radio
tuned to those frequencies. In some cases the vehicles own radio may
pick them up.
oTo change the monitors FM signal transmission frequency,
press the FM TX button on the remote control, and then keep
pressing the FM TX button to shift between the 7 reset
frequencies.
oTo receive the FM transmission on a radio, tune the radio to
the specific frequency selected above. You must be in front of
the monitors screen to receive these signals.
