InFocus Work Big IN32 Guía

33

Replacing the projection lamp

The lamp hour timer in the Service Info menu counts the number of hours

the lamp has been in use. Twenty hours before the specified end of the

lamp’s life, the message “Replace lamp” briefly appears on the screen at

each startup. When the expected lamp life has been reached, the Lamp indi-

cator icon lights red (page 12).

NOTE: You can order new lamp housings from www.infocus.com (in select

areas), your retailer or your dealer. Use only a replacement lamp with the

same type and rating as the original lamp.

1Turn off the projector and unplug the power cable.

2Wait 60 minutes to allow the projector to cool thoroughly.

3Turn the projector upside down and remove the lamp door by placing a

flat-blade screwdriver into the space between the lamp door and the

projector and gently prying the door off.

4Loosen the captive screw on the lamp module.

WARNINGS:

• To avoid burns, allow the projector to cool for at least 60 minutes before

you replace the lamp.

• Unplug the power cord before replacing the lamp.

• Do not drop the lamp module. The glass may shatter and cause injury.

• Do not touch the glass lamp screen. Fingerprints can obscure projection

sharpness.

Service Info menu

turn off and unplug

the projector

wait 60 minutes

pry the lamp door off

loosen the screw on lamp module

34

• Be extremely careful when removing the lamp housing. In the unlikely

event that the lamp ruptures, small glass fragments may be generated.

The lamp module is designed to contain most of these fragments, but

use caution when removing it. Before replacing a ruptured lamp, clean

the lamp compartment and dispose of cleaning materials. Wash hands

after lamp replacement. This product has a lamp which contains a very

small amount of mercury. Dispose of it as required by local, state or fed-

eral ordinances and regulations. For more information see

www.eiae.org.

5Detach the lamp connector from the projector by gently pulling the con-

nector until it is disconnected from the projector.

6Carefully remove the lamp module by grasping and lifting the metal

bail wire. Dispose of the lamp in an environmentally proper manner.

7Install the new lamp module, making sure that it is properly seated. Be

careful not to touch the interior components of the projector.

8Snap the bail wire back into its flat position against the lamp module.

9Re-attach the lamp connector to the projector. Make sure the connector is

fully inserted.

10 Tighten the screw on the lamp module.

11 Replace the lamp door.

12 Plug in the power cable then press the Power button to turn the projec-

tor back on, then reset the lamp hour timer.

Resetting the lamp timer

To reset the lamp timer, navigate to the Settings>Service menu and select

Reset Lamp Hours.

disconnect lamp connector

remove module using bail wire

reset lamp time in Service menu

Otros manuales para Work Big IN32

4

Este manual sirve para los siguientes modelos

3

Tabla de contenidos

Otros manuales de Proyector de InFocus

InFocus

InFocus IN1156 Manual de usuario

InFocus

InFocus LP500 Manual de usuario

InFocus

InFocus IN5533 Manual de usuario

InFocus

InFocus LP 850 Manual de usuario

InFocus

InFocus IN5110 Manual de usuario

InFocus

InFocus IN1112A Manual de usuario

InFocus

InFocus in114ST Manual de usuario

InFocus

InFocus SP777 Manual de usuario

InFocus

InFocus IN8606HD Manual de usuario

InFocus

InFocus CEILING MOUNT LP 1000 SERIES Guía rápida

InFocus

InFocus SCREEN PLAY 7205 Manual de usuario

InFocus

InFocus X2 multi-use perfomance Manual de usuario

InFocus

InFocus IN224 Manual de usuario

InFocus

InFocus IN5122 Manual de instrucciones

InFocus

InFocus X6 Manual de usuario

InFocus

InFocus IN5542 Manual de usuario

InFocus

InFocus LitePro Manual de usuario

InFocus

InFocus in2100 Series Manual de usuario

InFocus

InFocus LP340 Manual de usuario

InFocus

InFocus LP400 Manual de usuario

InFocus

InFocus LP280 Manual de usuario

InFocus

InFocus LP 740 LiteMount Manual de usuario

InFocus

InFocus Learn Big IN5102 Manual de usuario

InFocus

InFocus LP 425 LiteMount Manual de usuario

Manuales populares de Proyector de otras marcas

iEmmet

iEmmet MP-312 Manual de usuario

Epson

Epson VS400 Manual de usuario

Sony

Sony VPL-HS10 Marketing Specifications & Features Manual de usuario

Sony

Sony VPL-HW65ES Manual de servicio

Toshiba

Toshiba TLP-791U Manual de usuario

Philips

Philips LC1341 Guía de referencia

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manual de usuario

NEC

NEC NP600S EDU Manual de usuario

BenQ

BenQ SH753P Manual de usuario

Eiki

Eiki EK-623U series Manual de usuario

Epson

Epson PowerLite Pro Cinema 6020UB Manual de usuario

Epson

Epson PowerLite Home Cinema 705HD Manual de usuario

Christie

Christie LHD700 Manual de usuario

Navitar

Navitar FX Manual de usuario

Sony

Sony SRX-R815P Manual de usuario

Vivitar

Vivitar DP1500 X Manual de usuario

Acer

Acer C20 Series Manual de usuario

Asus

Asus ZenBeam Latte Manual de usuario