Infinix X665E Manual de usuario
Infinix X665E
User Manual (Aa&Ad)
1
Explosion diagram specification
1
FL(CTP+LCM)
2
F HSG
3
R CAM RUBBER
4
R FLASH HOOD
5
PS RUBBER
6
F CAM RUBBER
7
CAM FF
8
R CAM LENS
9
CAM FF
10
CAM AF
11
PCBA MB
12
REC
13
SIM HOLDER
14
CAM DECO
15
REAR FRAME
16
SCREW M1.4*D2.5*L2.5
17
SCREW M1.4*D2.5*L3.5
18
BATT COVER
19
FINGER PRINT
20
SPK FRAME
21
USB RUBBER
22
PCBA SUB
23
EARJACK RUBBER
24
COAXIAL CABLE
25
SIDE KEY FPC
26
MOTO
27
BATTERY
28
2
Know your phone
1. Front camera
2. Volume + key
3. Volume - key
4. Power key
1
SIM/SD card installation
1. Power off mobile.
2. Refer to the following picture for SIM / SD card
installation.
2
Charging the phone
You can charge your device using a charger or by connecting
it to the computer using a USB cable (comes with the
phone).
1. Please remind the front and back of the plug.
2. Use only INFINIX charger and cables. Other chargers or
cables may damage the device. This will invalidate your
phone warranty.
3
FCC Statement
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,
including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
4
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission
limits for exposure to radiofrequency (RF) energy set by the
Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for
the general population. The guidelines are based on
standards that were developed by independent scientific
organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons,
regardless of age and health. The exposure standard for
wireless mobile phones employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6 W/kg. * Tests for SAR are
conducted with the phone transmitting at its highest
certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified
power level, the actual SAR level of the phone while
operating can be well below the maximum value. This is
because the phone is designed to operate at multiple
power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless
base station antenna, the lower the power output. Before a
5
phone model is available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the
limit established by the government adopted requirement
for safe exposure. The tests are performed in positions and
locations (e.g., at the ear and worn on the body) as
required by the FCC for each model. The highest SAR value
for this model phone when tested for use at the ear is
0.923W/Kg and when worn on the body, as described in
this user guide, is 0.784W/Kg (Body-worn measurements
differ among phone models, depending upon available
accessories and FCC requirements). The maximum scaled
SAR in hotspot mode is 1.131W/Kg. While there may be
differences between the SAR levels of various phones and
at various positions, they all meet the government
requirement for safe exposure. The FCC has granted an
Equipment Authorization for this model phone with all
reported SAR levels evaluated as in compliance with the
FCC RFexposure guidelines. SAR information on this model
phone is on file with the FCC and can be found under the
Display Grant section of http://www.fcc.gov/ oet/fccid after
searching on
FCC ID: 2AIZN-X665E Additional information on Specific
Absorption Rates (SAR) can be found on the Cellular
Telecommunications Industry Asso-ciation (CTIA) web-site
at http://www.wow-com.com. * In the United States and
Canada, the SAR limit for mobile phones used by the public
is 1.6 watts/kg (W/kg) averaged over one gram of tissue.
The standard incorporates a sub-stantial margin of safety to
give additional protection for the public and to account for
any variations in measurements.
6
Body-worn Operation
This device was tested for typical body-worn operations. To
comply with RF exposure requirements, a minimum
separation distance of 10mm must be maintained between
the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used
by this device should not contain any metallic components.
Body-worn accessories that do not meet these
requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied
or an approved antenna.
For DTS patents, see http://patents.dts.com. Manufactured under license
from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol
together are registered trademarks or trademarks of DTS, Inc. in the
United States and/or other countries. © DTS, Inc. All Rights Reserved.
Tabla de contenidos
Otros manuales de Teléfono móvil de Infinix
Infinix
Infinix X6817 Manual de usuario
Infinix
Infinix X676C Manual de usuario
Infinix
Infinix X601 Manual de usuario
Infinix
Infinix Smart 6 Plus Manual de usuario
Infinix
Infinix X606D Manual de usuario
Infinix
Infinix SMART 7 HD Manual de usuario
Infinix
Infinix HOT 12 PLAY Manual de usuario
Infinix
Infinix X693 Manual de usuario
Infinix
Infinix X675 Manual de usuario
Infinix
Infinix X6511E Manual de usuario
Infinix
Infinix X683 Manual de usuario
Infinix
Infinix X602 Manual de usuario
Infinix
Infinix X652B Manual de usuario
Infinix
Infinix ZERO ULTRA Manual de usuario
Infinix
Infinix X5515 Manual de usuario
Infinix
Infinix X666 Manual de usuario
Infinix
Infinix X666B Manual de usuario
Infinix
Infinix NOTE 12 Pre 5G Manual de usuario
Infinix
Infinix X601-LTE Manual de usuario
Infinix
Infinix SMART 7 Manual de usuario
