Infinite Transtector CP 2341 Manual de usuario
Thank you for your recent purchase of our surge protection solution.
Your satisfaction with our product and service is important to us.
If you have any questions, comments or concerns, please contact us
at 800.882.9110 or visit our website at www.transtector.com.
We look forward to continuing to serve your protection needs.
800.882.9110 | 208.772.8515 | www.transtector.com
1. IMPORTANT SAFETY INSTRUCTION
2. Read and understand all instructions.
3. SAVE THESE INSTRUCTIONS
SIEMENS FIRE SAFETY
MODEL CP 2341
800.882.9110 | 208.772.8515 | www.transtector.com
Siemens Fire Safety Model CP 2341
1. This product is intended for use only on 15A
120Vac circuits.
2. Warning! Disconnect power upstream from the device
when wiring to avoid potential shock hazard.
3. Mounting
1.1 See Figure 1 for mounting dimensions.
1.2 Mount the unit within the enclosure next to the AC input.
4. Wiring (See Figure 2)
2.1 Connect the 120Vac power source to the two outside
screw sterminals labeled LINE and NEUTRAL. Connect the
hot side of 120Vac to the LINE terminal (Figures 3 & 4).
2.2 Connect the re alarm control panel to the two inside
screw terminals marked LOAD and NEUTRAL (Figures 3 & 4).
1200-137 REV B
Figure 2
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Protector contra sobretensiones de Infinite
Infinite
Infinite TRANSTECTOR ALPU-TSU Manual de usuario
Infinite
Infinite L-com SRCN-C03A Manual de usuario
Infinite
Infinite Transtector ALPU PTP INJ Manual de usuario
Infinite
Infinite Transtector 1101-1110 Manual de usuario
Infinite
Infinite Transtector ALPU Manual de usuario
Infinite
Infinite L-com SRCN-C037 Manual de usuario
Infinite
Infinite TRANSTECTOR ACP 100MN Manual de usuario
Infinite
Infinite Transtector DRDC Series Manual de usuario
Infinite
Infinite TRANSTECTOR ALPU Series Manual de usuario
Infinite
Infinite L-com SRCN-C033 Manual de usuario
