Displaying the pressure and the temperature by °C/°F:
Press the “►” forward button to change the pressure and temperature readout:
- Temperature readout °C & pressure readout to mbar/hPa
or
- Temperature readout °F & pressure readout to inHg
Digital barometer specification:
- The pressure range: 800 mbar to 1100 mbar
- The altitude range: –300 M to +1200 M (-900 ft to +3600 ft)
The temperature specification:
- The reading range: –20 °C to 70 °C (14 °F to 158 °F)
- The resolution: 0.1 °C/°F
TROUBLE SHOOTING
If for some reason the real time is incorrect,
Please use the following steps to reset the real time memory:
Slide the ‘TIME ZONE’ Switch to select the desired time zone
Note: The clock should already be set in the WET time zone this is Western
European Time (WET). Please see the diagram on page 1 for switch location.
WET (Western European Time) Greenwich Mean Time (GMT)
CET Central European Time GMT+1 hour
EET Eastern European Time GMT +2 hours
MSK Moscow Standard Time GMT +3 hours
Please follow the steps 1 – 6 below to set the Year, Mouth, Date, Hour & Minute.
Note: You will only need to use the “ALARM SET” button and the “+” and “-”
button
Important note: Between each Step you will have only 5 seconds before you can
press the “ALARM” button again, if you take too long the clock will revert back to
the original time and date display and you will then have to start again from step 1.
1. Press and hold the “ALARM SET” button for 5-7 seconds until the year shows
on the display, release you finger and press the “+” or “-” button to set the year.
‘Immediately after’
2. Press the “ALARM SET” button once, and the Month will begin to flash,
press“+” or “-” button to set the month.
‘Immediately after’
3. Press the “ALARM SET” button once and the Date will begin to flash, press“+”
or “-” button to set the Date.
‘Immediately after’
4. Press the “ALARM SET” button once and the Hour will begin to flash, press“+”
or “-” button to set the Hour.
‘Immediately after’
5. Press the “ALARM SET” button once and the Minutes will begin to flash,
press“+” or “-” button to set the Minutes.
‘Immediately after’
6. Press the “ALARM SET” button once to secure all the new settings in the
clocks memory. – If you do not press the “ALARM SET” to secure the memory
you will lose all the new settings and have to start again from Step 1.
If the time is blank or the real time cannot be re-set when plugged
into the AC power, please re-set the clock following the instruction
below: You will need to re-set the clock by pressing the ‘reset’ button inside the
button cell battery compartment.
To find the reset button
1. Open the 9V battery compartment at the back of the clock.
2. Now press the Black “RESET” button, bottom left corner.
3. In a few seconds, the display will be ON, and show 12:00 (at time zone
WET).
4. Now repeat the procedure to ‘reset the real time’ memory, the time will
be automatically stored in the clock
Reset button
inside 9V battery
compartment
