©2020 by Taylor Design Group, Inc. All rights reserved. Rev.1/20
Page 8
Manufactured by Taylor Design Group, Inc. P.O. BOX 810262 Dallas, TX 75381 WWW.INCRA.COM
INCRA MITER1000SE OWNER’S MANUAL
1) Place a square against the front face of your fence.
If you see a gap between the top of the fence and your
square rst loosen both outside nuts. Tighten one of
inside nuts about 1/6 turn against the rear leg of the
bracket as shown in Figure 20, and then tighten the
other inside nut by the same amount in the same di-
rection against the rear leg. Alternate this 1/6 turn
procedure between the two nuts until the fence is
perfectly square to the table DO NOT TURN THE
SET SCREW and DO NOT over tighten the nuts. It
usually takes less than 1 full turn of the nuts to square
your fence to the table.
If you see a gap between the bottom of your fence and
the square, rst loosen both inside nuts. Tighten one
of outside nuts about 1/6 turn against the rear leg of
the bracket as shown in Figure 21, and then tighten
the other outside nut by the same amount in the same
direction against the rear leg. Alternate this 1/6 turn
procedure between the two nuts until the fence is
perfectly square to the table DO NOT TURN THE
SET SCREW and DO NOT over tighten the nuts. It
usually takes less than 1 full turn of the nuts to square
your fence to the table.
2) After the fence has been squared to the table as
described above, tighten both of the loose nuts against
the rear leg of the bracket to secure your setting,
Figure 22. DO NOT TURN THE SET SCREW.
Fig. 20 To Tilt Fence Forward
Fig. 21 To Tilt Fence Back
Fig. 22 To Lock Setting
Adjustable Fence Mounting Bracket
Your INCRA Miter1000SE Fence has been adjusted square to the table at the factory so
no further adjustment should be required. If adding a wooden sub-fence, ne adjust-
ments to the angle can be easily made as described below.
Incra’s fence mounting bracket enables any fence to be quickly and easily adjusted for perfect squareness to the
table. We have provided two adjustment points so you can also neutralize twist or thickness variation that is
sometimes present in homemade wooden fences or sub-fences.
1st, loosen both
outside nuts
2nd, rotate 1/6
turn as shown
alternating
between
2 inside
nuts until
square
1st, loosen
both
inside
nuts
2nd, rotate 1/6
turn as shown
alternating
between 2
outside nuts
until square
After adjustment, re-tighten the
remaining loose nuts
MADE IN THE
USA
Manufactured by:
Taylor Design Group, Inc.
P.O. Box 810262 Dallas, TX 75381
www.incra.com
P: 972-242-9975/F: 972-242-9985
INCRA is a Registered Trademark of Taylor Design Group, Inc.
You can also register your INCRA product
online at www.incra.com
Scan this QR code to register your product online
It’s quick and easy!
ONLINE WARRANTY REGISTRATION
