IMPORTANT SAFETY INSTRUCTIONS
Please read the operating instructions and notes carefully before starting operation in order
to prevent accidents. The "Caution, Attention, Warning and Danger" statements in the
products and product manual do not represent all safety matters to be observed and are
intended to supplement various operational safety precautions.
During the various operations of our products and equipment, it is necessary to comply with
relevant National Safety Regulations and strictly observe the precautions and special safety
instructions of the related equipment.
Electrical Safety
Since some parts of this power system are under high voltage during operation,
direct or indirect contact can be fatal.
It is necessary to comply with relevant National Safety Regulations during the installation of
the Portable DC Charger. Personnel who install and maintain this equipment must be
qualified to work with high DC voltage up to 1000Vdc and 3-phase AC voltage up to 500Vac.
It is strictly forbidden to wear watches, bracelets, bangles, rings, and other conductive
objects on the wrist during installation and maintenance.
If there is water inside the DC Charger enclosure, AC power and DC connector must be
disconnected immediately. During operation in a humid environment, water should be strictly
prevented from entering the equipment.
During installation, it is strictly forbidden to operate the DC Charger and an “Operation
prohibited” signboard must be used.
Construction operation of high voltage lines may cause fire or electric shock. The
wiring area and the area where the line passes through for AC cables must comply
with national and local regulations and norms. As this device utilizes high voltages
do not attempt to install this equipment if you are not a qualified electrician.
Tools
Special tools must be used during various operations involving high DC and AC
voltages.
It is strictly forbidden to carry out live installation and maintenance work during
thunderstorms
A strong electromagnetic field will be produced in the atmosphere during a thunderstorm.
Therefore, the equipment should be well grounded to avoid damage to the equipment due
to lightning strikes.
