TROLL®Replaceable Battery Pack
Part number 0090000
Kit Contents
lTROLL Replaceable Battery Pack
l1.5 V or equivalent AA size batteries (8)
lSmall desiccant (for shipping use only)
Available Connections
The TROLL Replaceable Battery Pack connects to the following components.
lThe twist-lock connectors on a RuggedCable System
lTROLL Com Communication Devices
lSmall desiccant (for shipping use only), large desiccant
pack, extra large desiccant pack (for instrument
deployment)
Application
The TROLL Replaceable Battery Pack supplements internal battery power for
an Aqua TROLL 100, 200, or Level TROLL 400, 500, or 700. The battery pack
extends the life of a TROLL device when used properly. The battery pack is
particularly suited for long-term or limited-access deployments, and for
applications that require frequent, fast data sampling.
Physical Characteristics
Materials Titanium, Viton®, Acetal
Dimensions 17.8 cm (7.0 in.) length, 4.3 cm
(1.7 in.) OD
Weight 0.43 kg (0.95 lb) without
batteries installed
Alkaline battery
temperature range -5 to 55° C (23° to 131° F)
Lithium battery
temperature range -40 to 60° C (-40 to 140° F)
Environmental rating IP67 (not submersible)
Battery type 1.5 V or equivalent AA size
Estimated
battery lifetime*
Aqua TROLL 100/200 - 5.4
years
Level TROLL family - 1.4 years
* Logging all available parameters at 15-minute intervals.
Battery lifetime is dependent on temperature and site
conditions.
Guidelines and Precautions
lDo not use with any instrument other than an Aqua
TROLL 100 or 200, or Level TROLL 400, 500, or 700.
lThe battery pack is vented, and therefore must be
desiccated even if the rest of the deployment is non-
vented.
lDo not submerge the battery pack.
lThe battery pack will not function if the batteries are
installed incorrectly.
lDo not mix lithium and alkaline batteries.
lFor best performance in all environmental conditions,
use Energizer®L91 lithium batteries or equivalent.
lEnergizer E91 alkaline batteries should not be used at
very low or very high temperatures.
lDo not apply additional external power to a TROLL Com
device when the battery pack is connected.
lDo not install an instrument directly into the female
connection port of the battery pack, as shown below.
Instruments must be connected using only a
RuggedCable that connects to the male connection port
of the battery pack.
Information subject to change without notice. In-Situ, In-Situ logo, Baro Merge, BaroTROLL, HERMIT, HydroVu™, iSitu, Pocket-Situ, RDO, RuggedCable,
RuggedReader, SmarTROLL™, TROLL, VuSitu, and Win-Situ are trademarks or registered trademarks of In-Situ Inc.©2015. All rights reserved. 02/2016 | Rev. 005 | 0090002
Instruction Sheet
