6
Joining multiple fixtures
With power disconnected, each additional fixture (not included) should be mounted in the same manner as the first installed fixture.
Installation instructions using linking cord
-
-
-
-
-
Installation instructions with end-to-end connector
-
-
-
-
-
-
-
WARNING: LINKABLE 20 UNITS MAXIMUM.
NOTE:Each light can be individually operated by the on/off
switch located on each fixture.
WARNING: IN MULTIPLE FIXTURE INSTALLATIONS DO NOT ELECTRIFY FIXTURE GROUP UNTIL ALL ELECTRICAL CONNECTIONS HAVE BEEN
SECURELY MOUNTED. PLASTIC CAP MUST BE INSTALLED IN ALL OPEN PORTS AT THE COMPLETION OF INSTALLATION.
NOTE: Each light can be individually operated by the on/off switch located on each fixture.
WARNING: LINKABLE 20 UNITS MAXIMUM.
WARNING: DO NOT USE JUMPER CORD AS A MEANS TO TURN FIXTURES ON AND OFF.
1
2
Hold the fixture in the desired mounting location allowing approximately
2 ½” clearance for interconnect cables. Drive mounting screws into cabinet
surface, mount the fixture to surface by aligning screws to keyholes and
sliding over until the narrow ends of the keyhole slots are under the heads
of the wood screws.(ref. page. 4 mounting installation)
Carefully remove the plastic caps that cover the power
port on the fixtures.
The linking cord is fitted with a distinct cord connector plug at each
end and will only connect one way. Try inserting one end of the
linking cord into a power port (input/output receptacle), if it fails to
connect, try the other end. Do not try to force the plug into the port.
Make sure the plugs on both ends are fully inserted into ports on both fixtures.
If this will be an end fixture in a run, use plastic cap to cover any connector
not being used.
Turn on power.
Carefully remove the plastic caps that cover the power
port on the fixtures.
The End to End connector is fitted with a distinct cord connector
plug at each end and will only connect one way. Try inserting one
end of the End-to-End connector into a power port (input/output
receptacle), if it fails to connect, try the other end.
Do not try to force the plug into the port.
Hold new fixture to the same level of installed fixture, align the two
fixtures by meeting the ene-to-end connector with a power port
Push new fixture to existing fixture until fixtures are flush and
connectors snap together. Fixtures should fit fully and squarely
end-to-end when mounting is complete.
Drive mounting screws into cabinet surface until fixture is secure.
If screws are difficult to install, mark holes, remove fixture and
drill 1/16” maximum pilot holes. (ref. page. 4 Mounting Installation)
If this will be an end fixture in a run, use plastic cap to cover any
connector not being used.
Turn on power.
