INSTALLATION INFORMATION
Accessories
Find the following when unpacking the Registration Interface:
An ImproX (RS) Registration Interface housed in a Black, Aluminium extruded
Cabinet. The Cabinet consists of a Top Cover, a Base and two End Plates (each
End Plate is attached with three Thread Cutter Screws (M3 x 8 mm)).
Four Brass Wood Screws (3.5 mm x 25 mm).
Four Wall Plugs (7 mm).
A 1.8 m (5.90 ft) standard USB Cable with a Type A to Type B Connector.
An extra Fixed Address Label.
General
Remember the following when installing the Registration Interface:
FCC Compliance
For FCC compliance:
Ensure the comms cable is routed through a separate grommet to the power
cable.
Ensure that you use a CE approved Power Supply Unit.
Communications Distance
The USB communications distance between the Host PC and the Registration
Interface MUST NOT exceed 5 m (16.40 ft).
DO NOT cut and join the supplied USB Cable. If extension of the USB Cable is
required, source a new longer length USB Cable.
Distance between the Registration Interface and the ImproX RRM or
ImproX RRA
The maximum cable distance between the ImproX Registration Interface and the
ImproX RRM or ImproX RRA, MUST NOT exceed 2 m (6.56 ft).
Mounting the Cabinet
CAUTION: Make certain that you mount the ImproX RS on a vibration-free
surface.
Select the mounting position of the ImproX RS, considering accessibility, routing of
wires and visibility of the externally visible LED.
Secure the Cabinet to the mounting surface, using four suitable screws and wall plugs
(supplied), nuts and bolts or rivets.
Blank Space
