Charge
Hand push mode
7
6
Insert the charger into the standard socket and check to ensure that
the charger light turns red.
Battery charging port
Remove the battery from the car.
Open the cover of the battery charging port and insert the charger
plug into the battery port. The red light flashes when charging.
At this point, the lamp on the side of the battery
will also flicker to indicate the charging status.
When the green light of the charger stops flashing and the battery is
charged, the battery power will be turned off.To check the remaining
battery power, press the [battery power check] button.
Remove the charger plug, close the cover of the charging port on
the battery, and put the battery back on the device.
Stop and turn off the power.
Find the lower part of the rear base, two
red levers near the inside of the wheel
(this is the brake), and press the two red
levers down.
After that, you can use the push mode.
1 Separate Charging of Charging Battery and Body Put the car body close to the wall socket and turn off the power supply.
Insert the charger into the standard socket and check to ensure
that the charger light turns red.
Open the cover of the battery charging port and insert the charger
plug into the battery port. The charging red light flashes.
When the green light of the charger stops flashing, the battery is charged.
Unplug the charger and close the cover of the charging port on the battery.
2 Installed on the body for charging
※Don't release the brakes on the slope. Make sure the vehicle is on a
horizontal plane before releasing them.
