Short clicks mo e the cursor through 6 le els of brightness. While you are mo ing the rose cursor, you
see how the brightness of white scale changes. Higher position of the cursor causes higher
brightness. Conrm required brightness by 1-second push. The poi go into running mode, so you can
see the current brightness right away.
https://youtu.be/R42gudSvO5
Watch a video guide of button operation for better
understanding
(turn on English subtitles in Youtube settings)
To sum up the principal modes in operation with the button
To turn the poi o, press and hold the button for 3 seconds. From running
mode, you will see standby mode, then brightness le el scale, then the de ice turns o
Turning o.
the poi: push the button for at least 1 second. You will see ascending gradient, then
the poi gets to Standby mode with blinking cursor;
Turn on
from selected timeline/image: short click the button (less than 0,5 second);
Run the poi
back to Standby mode: click the button and hold it for 1 second
(such delay protects from incidental clicks when you spin the poi)
Go out of Running mode
the poi push the button and hold it for 3-
4
seconds until all lights fade away;
Turn o
in Standby mode: press and hold the button for at least 0,5 seconds.
A
s soon as the cursor shifts up, release the button.
S
hift the
c
ur
s
or up
in Standby mode: press and hold the button for at least 1 second until
B
attery le el scale appears (red-to-green gradient), then release the button. The cursor shifts
down, you are in battery le el mode. Click the button short to get back to Standby mode.
To go one more step down, hold the button until battery le el scale appears.
S
hift the
c
ur
s
or do
w
n
from any position of the cursor
–
j
ust turn o the poi and turn it on
(works only if the poi is not connected to a power source.
I
f otherwise, the cursor retains its
position after turning o and on)
Return to
1s
t po
s
ition
ro
s
e
run any timeline, then click
the button and keep holding (around 3 seconds)
until the cursor on the white scale appears.
Choose required brightness.
S
et re
q
uired
b
rightne
ss:
when you are in
Standby mode, push the button for 1 second. The
current battery le el is displayed as a red-to-green
gradient. Full scale means 100
%
charge, half
–
50
%
,
etc.
C
he
ck
c
urrent
ba
tter
y
l
e
v
e
l:
O
n the gure the poi is
9
0
%
charged
