IEI Technology POS-478 Manual de usuario

POS-478

Socket 478 Pentium 4 with

Multimedia POS Control

Board

PCB Version 1.2

Manual Version 1.0

Jul 31, 2003

The information in this document is subjected to change without prior notice in

order to improve reliability, design and function and does not represent a

commitment on the part of the manufacturer.

In no event will the manufacturer be liable for direct, indirect, special, incidental, or

consequential damages arising out of the use or inability to use the product or

documentation, even if advised of the possibility of such damages.

This document contains proprietary information protected by copyright. All rights

are reserved. No part of this manual may be reproduced by any mechanical,

electronic, or other means in any form without prior written permission of the

manufacturer.

Trademarks

POS-478 is registered trademarks of ICP Electronics Inc. IBM PC is a registered

trademark of International Business Machines Corporation. Intel is a registered

trademark of Intel Corporation. AMI is registered trademarks of AMI Software Inc.

Other product names mentioned herein are used for identification purposes only

and may be trademarks and/or registered trademarks of their respective

companies.

Support

Any questions regarding the product or the content of this manual please email us

at: support@iei.com.tw

Table of Contents

1. Introduction............................................................... 5

1.1 Specifications ..................................................................................6

1.2 Package Contents ............................................................................8

2. Installation................................................................. 9

2.1 POS-478 Layout ...............................................................................9

2.2 Unpacking Precautions ..................................................................11

2.3 CompactFlashDisk™ TYPE II Flash Disk Setting .............................12

2.4 Clear CMOS Setup ..........................................................................12

2.5 COM2 RS-232/422/485 Selection..................................................12

2.6 COM Port RI and Voltage Selection ................................................13

2.7 Keyboard & Mouse Power Source Setting ......................................14

2.8 LCD Panel Setup.............................................................................15

2.9 Serial ATA Enable/Disable Setting .................................................16

3. Connection ............................................................... 17

3.1 Floppy Disk Drive Connector..........................................................17

3.2 PCI E-IDE Disk Drive Connector.....................................................18

3.3 Parallel Ports .................................................................................19

3.4 Serial Ports ....................................................................................20

3.5 Keyboard / Mouse Connector.........................................................24

3.6 External Switches and Indicators ..................................................26

3.7 USB Port Connector .......................................................................26

3.8 IrDA Infrared Interface Port..........................................................27

3.9 VGA Connector...............................................................................28

3.10 LAN RJ45 Connector....................................................................29

3.11 Fan Connector.............................................................................30

3.12 LCD Backlight Connector.............................................................30

3.13 LCD Panel LVDS Interface Connector ..........................................31

3.14 Audio Connector..........................................................................32

3.15 Digital Input / Output.................................................................33

3.16 CompactFlash TYPE II Storage Card Socket ................................34

3.17 ATX Power Connector..................................................................35

3.18 ATX-12V Power Connector ..........................................................36

3.19 Internal Switches and Indicators................................................36

3.20 IEEE-1394 Connector ..................................................................37

3.21 Serial ATA Connector (only for POS-478S)..................................37

4. AMI BIOS SETUP..................................................... 38

4.1 Introduction ..................................................................................38

4.2 Starting Setup................................................................................38

4.3 Using Setup ...................................................................................39

4.4 Getting Help...................................................................................40

4.5 Main Menu .....................................................................................41

4.6 Standard CMOS Setup ....................................................................43

4.7 Advanced CMOS Setup ...................................................................45

4.8 Advanced Chipset Setup ................................................................49

4.9 Power Management Setup .............................................................51

4.10 PCI / Plug and Play Setup...........................................................52

4.11 Peripheral Setup .........................................................................54

Appendix A Watchdog Timer....................................... 57

Appendix B I/O Address Map...................................... 59

Appendix C How to Use Wake-Up Function.............. 61

Appendix D Digital I/O................................................. 62

Appendix E Creating/Deleting SATA Raid Sets ....... 63

Appendix F Connecting LCD to POS-478................... 65

1. Introduction

Thank you for choosing POS-478 Socket 478 Pentium 4 with Multimedia POS

Control Board. POS-478 board is an POS form factor board equipped with high

performance processor and advanced high performance multi-mode I/O, designed

for the system manufacturers, integrators, or VARs that want to provide all the

performance, reliability, and quality at a reasonable price.

POS-478 is built-in with AGP4X VGA (Intel 845GV), which is a VGA controller

supporting 3D graphics capability to provide up to 2048x1536x16-color resolution.

The onboard VGA shares 8MB system DDR-SDRAM. POS-478 provides a highly

integrated scaling IC with LVDS Transmitter with a scaled resolution up to SXGA for

single pixel Input. It supports up to 48-bit color TFT LCD.

An advanced high performance super AT I/O chip — ITE IT8712 is used in POS-478

board. Both on-chip UARTs are compatible with the NS16C550. The parallel port

and IDE interface are compatible with IBM PC/AT architecture.

POS-478 has one 10/100 Fast Ethernet LAN built-in (ICH4) and one Intel 82540

Gigabit LAN. They are of high performance networking functions and low power

features.

POS-478 is equipped with IEEE1394 controller (TI TSB43AA22). You can connect

it to your 1394 devices. POS-478 also provides two Serial ATA ports to connect

with Serial ATA devices.

POS-478 uses the advanced Intel 845GV Chipsets which are 100% software

compatible chipset with PCI 2.2 standard.

1.1 Specifications

CPU (PGA 478) Intel Pentium 4 processor. Supports 400/533

MHz FSB.

Bus speed PCI: 33MHz

DMA channels 7

Interrupt levels 15

Chipset INTEL 845GV (GMCH)

Real-time clock INTEL 82801DB (ICH4)

System memory Two 184-pin DIMM sockets support DDR 200/266

SDRAM. The maximum memory is up to 2 GB.

ATA/100

IDE interface

Up to four PCI Enhanced IDE hard drives. The

ATA/100 IDE can handle data transfer up to

100MB/s. Compatible with existing ATA-2 IDE

specifications its best advantage, so there is no

need to do any changes for user’s current

accessories.

Floppy disk drive

interface

Supports up to two floppy disk drives,

5.25”(360KB and 1.2MB) and/or 3.5” (720KB,

1.44MB, and 2.88MB).

Serial ports

COM1 (RS-232), COM2 (RS-232/RS-422/

RS-485), COM3 (RS-232) & COM4 (RS-232) with

16C550 UART (or compatible) with 16-byte FIFO

buffer. Support up to 115.2Kbps. Ports can be

individually configured to COM1, COM2, COM3,

COM4 or disabled.

Bi-directional parallel

port

Configurable to LPT1, LPT2 or disabled.

Supports EPP/ECP/SPP.

Hardware monitor Built-in to monitor power supply voltage and fan

speed status.

IrDA port Supports Serial Infrared (SIR) and Amplitude

Shift Keyed IR (ASKIR) interface.

USB port Supports 6 USB2.0 ports for future expansion.

Watch-dog timer

Software Programmable Reset generated when

CPU does not periodically trigger the timer. Your

can use BIOS INT15 to control the watchdog and

generate a system reset.

VGA controller Built-in AGP2.0 4X 3D graphics engine. Share

system DDR SDRAM 8M. Screen Resolution: up

to 2048x1536x16.

LVDS connector Extra Display output, Support up to 48-bit color

TFT LCD. Resolution up to SXGA for single pixel

input.

Ethernet

One ICH4 Fast Ethernet controllers, IEEE 802.3u

Auto-Negotiation support for 10BASE-

T/100BASE-

X standard. One Intel 82540 Gi

abi

LAN. Two RJ45 connectors are located on board

for easy connection.

Serial ATA

Support Two independent serial ATA channels.

Serial ATA generation 1 transfer rate of 150MB/s.

(Only for POS-478S)

1394 Port Support Two 1394 ports compliant with 1394 OHCI

specification 1.1, IEEE 1394-1395 and

1394a-2000.

Keyboard and PS/2

mouse connector

6-pin mini DIN connector is located on board for

easy connection to a keyboard and PS/2 mouse.

For alternative application, a keyboard and a PS/2

mouse pin header connector are also available on

board.

Digital input/output It provide with 4bit digital input/output (+5V level).

Your can use I/O PORT 201H to control it.

Audio AC’97 Audio CODEC

PCI Slot Expansion bus, only PCI slot are provided.

Compact flash It can be used with a passive adapter (True IDE

Mode) in a Type I/II Socket.

Power consumption

(PENTIUM 4: 2GHz, 1GB DDR PC2700 SDRAM)

+5V @ 4.7A, +12V @ 7A, +3.3V@ 4.2A, +5VSB @

0.5A, -12V @ 0.1A

Recommended: 350-watt power supply or higher

Operating

temperature

0℃~60℃(*CPU needs Cooler & silicone heatsink

paste*)

WARNING!

1. Never run the processor without the heat sink (cooler) properly and

firmly attached.

2. Please use ATX-12V Power Connector (PW1) to provide power to the

CPU.

1.2 Package Contents

In addition to this User's Manual, POS-478 package includes the following

items:

•POS-478 with Multimedia POS Control Board x 1

•FDD cable x 1

•ATA/100 IDE cable x 2

•Serial ATA IDE cable (only for POS-478S) x 2

•Serial ATA Power cable (only for POS-478S) x 2

•Printer cable x 1

•RS-232 serial port cable x 1

•Driver CD x 1

If any of these items are missing or damaged, contact the dealer from

whom you purchased this product. Save the shipping materials and carton

in case you want to ship or store the product in the future.

2. Installation

This chapter describes how to install POS-478. Follow the instructions and

unpacking precautions carefully.

2.1 POS-478 Layout

Tabla de contenidos

Otros manuales de Placa madre de IEI Technology

IEI Technology

IEI Technology WAFER-BW-N4-R10 Manual de usuario

IEI Technology

IEI Technology IOWA-8522 Manual de usuario

IEI Technology

IEI Technology IMBA-XQ354-R11 Manual de usuario

IEI Technology

IEI Technology IMB-H110 Manual de usuario

IEI Technology

IEI Technology PCIE-G41A2 Manual de usuario

IEI Technology

IEI Technology PM-PV-D4251 Manual de usuario

IEI Technology

IEI Technology HYPER-RK39 Manual de usuario

IEI Technology

IEI Technology IMBA-8650 Manual de usuario

IEI Technology

IEI Technology NANO-KBN-i1 Manual de usuario

IEI Technology

IEI Technology IMB-H810-i2-R11 Manual de usuario

IEI Technology

IEI Technology IMB-Q670 Manual de usuario

IEI Technology

IEI Technology gKINO-DMF-421-R10 Manual de usuario

IEI Technology

IEI Technology KINO-6614 Manual de usuario

IEI Technology

IEI Technology NANO-8522 Manual de usuario

IEI Technology

IEI Technology WAFER-OT-Z650 Manual de usuario

IEI Technology

IEI Technology IMB-C2160 Manual de usuario

IEI Technology

IEI Technology IMB-C2060 Manual de usuario

IEI Technology

IEI Technology IOWA-8522 Manual de usuario

IEI Technology

IEI Technology IMBA-Q470 Manual de usuario

IEI Technology

IEI Technology NANO-GM45A2 Manual de usuario

IEI Technology

IEI Technology ROCKY-4783EV Series Manual de usuario

IEI Technology

IEI Technology ICPMB-8650 Manual de usuario

IEI Technology

IEI Technology IMBA-C604EP Manual de usuario

IEI Technology

IEI Technology IMBA-G410 Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario