Instructional Manual GD-14
Innovative DisplayWorks
65
PREPARATION PRIOR TO OPERATION
• Remove all packaging materials before using cooler.
This includes: foam pedestal, adhesive tape (used to x accessories) and protective gaskets.
• Inspect cooler for concealed damage. Immediately le a claim with the freight carrier if there is damage.
IDW is not responsible for damage incurred during shipping.
• For proper operation, place the cooler on a dry, level surface.
• Clean the interior surface with a soft cloth and lukewarm water before operation.
• Keep cooler in an upright position for 30 minutes prior to use.
• IDW requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty.
WARNING: Do not use extension cords.
WARNING: Compressor warranties are void if compressor burns out due to low voltage.
WARNING: Power supply cord should not be removed or altered in any way.
Shelving Installation
• Position all four shelf clips equal in distance from the
oor for at shelves.
• Hook shelf clips on shelf strip.
• Place shelf on shelf clips.
FEATURES
• Designed with an elegant shape and quick refrigeration speed, this commercial-grade product is an
ideal choice for shopping malls, supermarkets, hotels, etc.
• Transparent glass doors are built with hollow, toughened glass that provides a high level of heat
insulation. Clear doors allow for high product visibility.
• The forced air system allows for fast cooling speeds, which helps maintain a consistent temperature.
• Adjustable shelves allow for a wide variety of products to be stocked.
• The refrigeration unit is designed for easy access, allowing for fast and simple repairs.
• This equipment is intended for storage and display of non-hazardous packaged product.
INSTRUCTIONS
Ambient Environment
• Place cooler on an even surface to reduce vibration and noise.
• To transport, do not tilt the cooler beyond a 45 degree angle.
• Do not place cooler in direct sunlight or near any heat sources.
• Do not place cooler in environment temperatures that exceed 109°F.
• Do not place cooler in below normal temperatures.
• Do not place cooler in extreme humid environments, this may cause components to rust.
• Do not place cooler near constant running or splattering water, this may cause immediate damage to
refrigeration system.
• Must allow at least 2” between rear of cooler and wall for proper ventilation and heat dissipation of
cooler.
• Do not place furniture or other articles with sharp edges near the cooler in order to prevent damage to
the glass door.
