Rev. 03 | English | 5
Functional descriptions
Lock-mode
After 100 consecutive failed opening attempts, the lock will be
locked for 180 seconds. During this period, no action can be
performed on the lock. Transponders will be rejected with 8
flashes of the red LED. The lockout-mode can be prematurely
lifted by presenting the master card.
Battery warning
When the battery capacity drops below a certain threshold,
three consecutive descending tones will sound when
presenting a transponder. Once the critical level is reached,
the lock cannot be locked anymore or can only be opened
with the master-card. In the LF-Version, locking is still possible
despite low battery capacity. A low battery level is indicated
by the blinking of the red LED. An individual time period can
be set for the LED indication. The battery warning through the
LED will only occur during this period.
Note: It is recommended to replace the batteries after the first
warning indication.
Automatic locking (Private-mode)
The lock will automatically close after the opening process.
Three locking times are available.:
Time 1 4 Sec.
Time 2 8 Sec.
Time 3 20 Sec.
Note: Make sure that the door is closed and the lock can be
locked smoothly to avoid damage to the lock.
LED lock indicator
The lock indicates the locked state by blinking the red LED
every second. This function can be turned on or off.
Audio signals.
Audio signals sound during the opening or closing process,
as well as when presenting unauthorized transponders. This
function can be turned on or off.
Reset 1: Function reset
All functions will be reset to their default settings. Any
settings made will be deleted.
Reset 2: Transponder reset
All enrolled transponders will be deleted from the lock.
Installation dimensions
Corona
Frontansicht
Knauf
66 mm
55 mm
87 mm
98 mm
30 mm
Ø 5 mm
Ø 41 mm
24 mm
87 mm
min. Ø 19,3 mm
Ø 5
mm
55 mm
24 mm
Middle
43,5 mm 43,5 mm
27,5 mm
27,5 mm
Mode: Fixed authorization (Private-mode)
In this mode, a preconfigured transponder medium is set,
which can operate the lock. This mode is suitable for user
groups where user rights should not change permanently, for
example, in an office cabinet. The lock can be opened and
closed with any stored transponder. Transponders that are not
stored will be rejected by the lock.
Mode: Multiuser authorization (Multiuser-mode)
This mode is suitable for constantly changing users who only
temporarily or once use the compartment, for example, in a
sports facility. Transponder media are valid for a single locking
operation and are deleted by the lock upon reopening. The
lock remains in the open state until it is locked again. Before
locking, the door must be pressed lightly. To close, the user
holds a transponder in the middle of the lock.
Occupancy detection
During the locking process, the transponder is marked with an
occupancy indication. The occupancy indication prevents the
transponder from locking additional locks. The lock can only
be reopened with the same transponder. The opening process
cancels the occupancy indication.
Note: Occupied transponder media can also be released using
the master-card (point 5 under "Configuration") or a
transponder release box.
Master-card
The master-card is authorized for programming the lock.
Additionally, the master-card can open the lock independently
of the set mode (emergency opening) and end the lockout-
mode. In the multiuser-mode, the transponder used for
locking is deleted from the lock upon presenting the master-
card.
ID LOCK 3000 | 07-2023
