ICP DELUXE HIGH WALL MINI SPLIT Manual de usuario

ELUXE IMINISPLIT

UAt

SPLIT TYPE ROOM AIR CONDITIONER

• Please read carefully and thoroughly this manual

before operating this unit.

° Contact a qualified service technician for

installation, repair and maintenance of this unit.

. The appliance is not intended for use by young

children or infirm persons without super¢ision.

° Young children should be supervised to ensure

that they do not play with the appliance.

CONTENTS

CAUTION ....................................................................................................... 3

PRODUCT COMPONENT IDENTIFICATION ............................................... 4

(1) Feature ................................................................................................... 4

(2) Indoor Unit, Outdoor Unit ...................................................................... 5

(3) Name and Function-Remote Controller(Heating model) ........................ 6

(4) Name and Function-Remote Controller(Cooling model) ........................ 7

(5) Remote Controller Preparation ............................................................. 8

AIR CONDITIONER OPERATION ................................................................ 9

(1) Operation Mode .................................................................................... 9

(2) Operation Procedure ............................................................................. 9

(3) Sleep Mode Auto-Control Setting ......................................................... 15

(4) Airflow Direction Procedure ................................................................. 16

(5) Setting the Present Time ..................................................................... 17

(6) Timer Setting ....................................................................................... 18

(7) Operation Details ................................................................................ 20

FORCED OPERATION ................................................................................ 21

CARE AND MAINTENANCE ...................................................................... 22

OPERATION TIPS ....................................................................................... 24

BEFORE CALLING FOR SERVICE ............................................................ 25

THIS IS NOT MALFUNCTION .................................................................... 26

To warm up the system,

power mains must be turned

on at least five(5) hours

Leave the power ON unless

you will not be using this

appliance for an extended

period.

_lect the most appropriate

Take care to adjust the

temperature to suit the

conditions. Rooms occupied

by young infants, the elderly,

or invalids should be kept at

an appropriate temperature.

Do not use the air

conditioner for purposes

other than cooling the room.

DOnot use the air conditioner

for other purposes, such as

drying clothes, preserving

foods, or cultivating

vegetables.

Do not use heating

apparatuses in the vicinity,

The air conditioner's plastic

partsmay melt if exposed to

excessive heat.

PRODUCT COMPONENT IDENTIFICATION

(1) Feature

zASoft Dry Operation Mode

page 12

This mode is designed to dehumidify without

overcooling.

zBAuto O_ration

page11

Inselecting this mode of operation, the

setting temperature, indoor fan speed, and

the desired operation mode are

automatically set by the unit electronic

control on the basis of the room

temperature.

During Auto Operation, pressing the Air-flow

direction control button makes vertical louver

swings up and down automatically. Pressing

the Airflow Direction Controi Button wilt set

the louvers at a fixed position. Pressing the

Airflow Direction Control Button again will

restore the auto-swing.

Wireless Remote Controller puts

all functions at your fingertips.

zc ONIOFF Dual Timer_ing

page 18_19

You can program the room air conditioner to

turn itself on or off at a predeterminated time

to ensure maximum comfort when you return

from being away.

zDSl_p Mode Auto Control

page 15

A touch of the Sleep Mode Button

automatically programs the room air

conditioner to control the indoor fan speed,

and adjusts the setting temperature to create

a more comfortable sleep.

of handling the Remote Controller

•Aim at the signal receptor on the room air

conditioner so as to operate.

•The remote contro_signal can be received

at a distance of up to about 7m(23_).

• Be sure that there are no obstructions

between the remote controller and the

signal receptor.

Do not drop or throw the remote controlfer.

DOnot place the remote controller in a

location exposed to direct sunlight, or near

the heating unit, or any other heat source.

, Block a strong light over the signal re_ptor

with a curtain or etc. so as to prevent the

abnormal operation.

(2) Indoor Unit, Outdoor Unit

I Indoor Unit ]

Air Intake Vent

(front panel)

Air Outlet Vent

Horizontal Airflow

Direction Louver

Vertical Airflow Direction Louver

(The air outlet vent opens when the eperation

starts.)

Air Filters

(behind front panel)

Power Supply Cord

Controller

Storage

Panel Opening

(]eft and right)

Indoor unit controls

and indicators

-- Open the front panel

Pull the panel to

open(te_ and right side

of front panel) and open

the panel upward.

Force Ope_tion Button

Use for operation when the remote controller cannot be used

(When eperation is stepped by the remote _ntre] without

removing power pMg, the room air conditioner consumes

approximately 2W of electricity_)

--Signal Receptor

Receives the signats from the remote controller.

(Signal receiving sound:two short beeps or one tong beep.)

--Operation Indication Lamps

O On/Off : Lights up during the air conditioner

operation,

s_¢ Sleep Mode : Lights up during Sleep Mode Auto

operation.

G Timer : Lights up during timer operation.

Defrost Mode : Lights up during Defrost Mode or hot

6 start operation.

-Heating Model only

OUT _tdoer Un_ "

DOOR Operation Lights up during the outdoor unit's

operatien.- Cooling Model only

Outdoor Unit]

Air intake Vents

Air Outlet Vent

(Rear)

Piping

Drain Hose

(3) Name and Function-Remote Controller(Heating Model)

Remote Controller

Signal transmitter

Transmits the signals to the room

air conditioner,

zAOperation display

Displays the operation conditions.

zBStart/Stop Button

-Operation starts when this bu_on is pressed, and

stops when the button is pressed again,

• The fan blows at low speed when start button is

pressed initially, after a while the fan speed will be

reached at the desired speed.

zcOperation Mode _lection Button

Used to select the operation mode.

• Cooling Operation Mode.

• Auto Operation Mode.

• Soft Dry Operation Mode.

• Heating Operation Mode(Heat Pump Only).

_DON Timer Button

Used to set the time of starting operation

zEOFF Timer Button

Used to set the time of stopping operation.

_FTime Setting Button

Used to adjust the time.

1@Timer Set Button

Used to set the timer when the desired time is

obtained,

zHTimer Cancel Button

Used to cancel the timer operation.

zSleep Mode Auto Button

Used to set Steep Mode Auto Operation.

zJAir Circulation Button

Used to circulate room air without cooling.

iH Room Temperature Checking Button

Used to check the room temperature.

zLAirflow Direction Control Button

Used to set the desired vertical airflow direction.

zMR_et Button

(4) Name and Function-Remote Controller(Cooling Model)

Remote Controller

Signal transmitter

Transmits the signals to the room

air conditioner

zAO_ration display

Displays the operation conditions.

zBStart/Stop Button

• Operation starts when this button is pressed, and

stops when the button is pressed again.

•The fan blows at low speed when start button is

pressed initially, after a while the fan speed will be

reached at the desired speed.

zcOperation Mode _lection Button

Used to select the operation mode.

• Cooling Operation Mode.

, Auto Operation.

° Soft Dry Operation Mode.

zDON Timer Button

Used to set the time of starting operation.

zEOFF Timer Button

Used to set the time of stopping operation.

/_iTime Setting Button

Used to adjust the time.

zcTimer Set Button

Used to set the timer when the desired time is

obtained.

zHTimer Cancel Button

Used to cancel the timer operation_

I zSleep Mode Auto Button

Used to set Sleep Mode Auto Operation

JAir Circulation Button

Used to circulate room air without cooling or heating_

_KRoom Temperature Checking Button

Used to check the room temperature.

z L Airflow Direction Control Button

Used to set the desired vertical airflow direction.

_MResetButton

(5) Remote Controller Preparation

How to storethe remote controller How to mount onto a wall

Pull the left and the right side to open the

front pane_upward.

Store the remote control,

(Remove it when using.)

Press the left and the right side to close

the front panel.

How to insert bakeries

Use the screws to secure the holder to

the wail,

Confirm that the remote

control signals can reach

the signat receptor of unit

To attach the remote controller to the

holder

To remove,

Remove the battery cover from the remote

controller,

. Slide the cover according to the arrow

direction,

Insert the two batteries,

. Be sure that the (+) and (-) directions are

correct.

. Be sure that both batteries are new.

Re-attach the cover.

• Slide it back into position.

° Do not use rechargeable

bakeries, such batteries differ

from standard dry cells in

shape, dimensions, and

performance,

. Romove the batteries from the

remote controller if the air

conditioner is not going to be

used for some long time.

. Batteries for the remote

controller are type "AAA".

AiR CONDITIONER OPERATION

(1) Operation Mode

(Heat Pump Model)

Cooling Mode ]

Heating Mode

(Cooling Model)

Cooling Mode

IAuto M_e

ISoft Dry Mode

_11_

(2) Operation Procedure

[_ S_rb'Stop Button

[_ Operation Mode Selection

Button

Room Temperature Setting

Button

[

Heatpumpmodel 8A.1_._

Cooling model 8A5

Indoor Fan Sp_d _|ection Button

zACooling Operation Mode

(_ LED lamp ON)

Press the StaWStop Button.

•Two short beeps witl sound and the

operation lamp will light up.

Select Cooling Operation.

Press the Operation Mode Selection Button.

Each time the button is pressed, the operation mode is shifted in the arrow direction.

Auto Operation Soft Dry Operation Heating Operation

(Heat pumpm_el only)

Set the temperature

lower than the room

temperature.

• The temperature can be set

within a range of 64_*-86°F by

2_.

-To raise the Temperature

.To tower the Temperature

Set the fan speed.

__ - Select the fan speed in four steps

-low, medium, high, AUTO.

- The display shows high fan

speed

• Each time the button is pressed, the fan speed mode is

shifted.

B10m

Tabla de contenidos

Otros manuales de Acondicionador de aire de ICP

Manuales populares de Acondicionador de aire de otras marcas

Spheros

Spheros CC 355 Manual de usuario

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manual de usuario

Panasonic

Panasonic CS-E12HKEW Manual de usuario

nedis

nedis ACMB1WT7 Manual de usuario

Samsung

Samsung AR KV Series Guía

Daikin

Daikin FCFV50A Manual de usuario

Fujitsu

Fujitsu Inverter ASBA30JFC Manual de usuario

Toshiba

Toshiba RAS-M10SMUV-E Manual de usuario

Daikin

Daikin FXLQ20MAVE Manual de usuario

Hitachi

Hitachi RAS-E24CAK Manual de usuario

CIAT

CIAT Magister 2 Series Guía

Bestron

Bestron AAC6000 Manual de usuario

Hisense

Hisense 7K Manual técnico

Frigidaire

Frigidaire FFRE0533S1E0 Manual de usuario

Samsung

Samsung AS09HM3N Manual de usuario

Frigidaire

Frigidaire CRA073PU11 Manual del propietario

Soleus Air

Soleus Air GB-PAC-08E4 Manual de usuario

McQuay

McQuay MCK020A Manual de usuario