Icidu 300MBPS Manual de usuario
II
COPYRIGHT
Copyright ©2010/2011 ICIDU. All rights reserved. No part of this
publication may be reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language or computer language, in any form or
by any means, electronic, mechanical, magnetic, optical, chemical, manual or
otherwise, without the prior written permission of ICIDU.
ICIDU makes no representations or warranties, either expressed or implied,
with respect to the contents hereof and specifically disclaims any warranties,
merchantability or fitness for any particular purpose. Any software described in
this manual is sold or licensed "as is". Should the programs prove defective
following their purchase, the buyer (and not ICIDU, its distributor, or its dealer)
assumes the entire cost of all necessary servicing, repair, and any incidental or
consequential damages resulting from any defect in the software. Further,
ICIDU reserves the right to revise this publication and to make changes from
time to time in the contents thereof without obligation to notify any person of
such revision or changes.
III
Federal Comm unicatio n Commis s ion
Inter f erence Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio technician for help.
FCC Caution
This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the authority to operate equipment.
IV
Federal Comm unicatio n Commis s ion ( FCC)
Radia t ion Exposure Statemen t
This EUT is compliance with SAR for general population/uncontrolled
exposure limits inANSI/IEEE C95.1-1999 and had been tested in accordance
with the measurement methods and procedures specified in OET Bulletin 65
Supplement C.
The equipment version marketed in US is restricted to usage of the channels
1-11 only.
V
R TTE C ompli a nce Statement
This equipment complies with all the requirements of DIRECTIVE 1999/5/EC
OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on
radio equipment and telecommunication terminal Equipment and the mutual
recognition of their conformity (R&TTE)
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station
Equipment) As of April 8, 2000.
Safety
This equipment is designed with the utmost care for the safety of those who
install and use it. However, special attention must be paid to the dangers of
electric shock and static electricity when working with electrical equipment. All
guidelines of this and of the computer manufacture must therefore be allowed
at all times to ensure the safe use of the equipment.
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use in Austria,
Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy,
Luxembourg, the Netherlands, Portugal, Spain, Sweden, and the United
Kingdom.
The ETSI version of this device is also authorized for use in EFTAmember
states: Iceland, Liechtenstein, Norway, and Switzerland.
EU Countries Not intended for use
None.
VI
C A T A L O G
Chapter I: Product Information ........................................................................ 1
1-1 Introduction and safety information ...................................................................... 1
1-2 Safety Information ................................................................................................. 1
1-3 System Requirements ........................................................................................... 2
1-4 Package Contents .................................................................................................. 3
1-5 amiliar with your new wireless network card ..................................................... 4
CHAPTER II: Driver Installation and Configuration .......................................
2-1 Network Card Installation ............................................................................................ 5
2-2 Connect to Wireless Access Point ........................................................................... 10
2-2-1 Using Realtek Utility ................................................................................. 10
2-2-2 Using Windows Zero Configuration .......................................................... 15
2-3 Connection Profile Management ............................................................................. 1
2-3-1 Add a new profile ..................................................................................... 20
2-3-2 Remove an existing profile ...................................................................... 24
2-3-3 Edit an existing profile ............................................................................. 25
2-3-4 Make a copy of existing profile ................................................................ 26
2-3-5 Set as default profile ............................................................................... 27
2-4 View Network Statistics, General Information, and Status ............................. 27
2-4-1 General Information ................................................................................. 28
2-4-2 Status ...................................................................................................... 29
2-4-3 View Network Statistics ........................................................................... 30
2-5 Miscellaneous Settings ................................................................................................ 31
2-6 Establish secure connection with AP by WPS .................................................... 32
2-6-1 PIN Code .................................................................................................. 35
2-6-2 Push Button ............................................................................................. 37
CHAPTER III: Soft-AP Function ....................................................................... 39
3-1 Switch to AP Mode and Station Mode ..................................................................... 3
3-1-1 Configure SSID and Channel .................................................................... 42
3-1-2 Setup Soft-AP Security ............................................................................ 44
3-2 Advanced Settings ......................................................................................................... 45
3-3 Wireless Statistics .......................................................................................................... 46
3-4 Internet Connection Sharing (ICS) ......................................................................... 48
CHAPTER IV: Appendix ................................................................................ 49
4-1 Hardware Specification .............................................................................................. 4
4-2 Troubleshooting............................................................................................................. 50
VII
4-3 Glossary ............................................................................................................................ 52
1
Chapter I: Product Information
1-1 Introduction and safety information
Thank you for purchasing this high speed IEEE 802.11b/g/n wireless network
card! This network card is the tiny size design and you are able to plug it into
the USB port of your computer without removing it, just like an embedded
network card. Excepting common wireless standards 802.11b/g, this
wireless network card is also 802.11n compatible - data transfer rate is
300Mbps, and that’s three times faster than 802.11g wireless network!
This adapter is power saving design for green, together with the versatile
features; it is the best solution for you to build your wireless network.
Other features of this router including:
IEEE 802.11b/g/n compatible.
High transfer data rate – up to 300Mbps.
Support WMM wireless QoS feature.
Support 64/128-bit WEP, WPA, WPA2 with IEEE 802.1x functions for
high level of security.
Support the most popular operating system: Windows XP/Vista/7.
Support WPS (Wi- i Protected Setup) hardware button for easy
connection.
Support software AP function.
Support USB 2.0/1.1 interface.
Portable and tiny size design.
Green Power Saving: it supports the smart transmit power control
and auto-idle state adjustment.
1-2 Safety Information
In order to keep the safety of users and your properties, please follow the
following safety instructions:
1. This USB wireless network card is designed for indoor use only. DO NOT
expose this network card to direct sun light, rain, or snow.
2
2. DO NOT put this network card at or near hot or humid places, like kitchen
or bathroom. Also, do not left this wireless network card in the car in
summer.
3. This network card is small enough to put in a child’s mouth, and it could
cause serious injury or could be fatal. If they throw the network card, the
card will be damaged. PLEASE KEEP THIS NETWORK CARD OUT THE REACH
O CHILDREN!
4. This network card will become hot when being used for long time (This is
normal and is not a malfunction). DO NOT put the network card on a paper,
cloth, or other flammable objects after the network card has been used for a
long time.
5. There’s no user-serviceable part inside the network card. If you found that
the network card is not working properly, please contact your dealer of
purchase and ask for help. DO NOT disassemble the network card by yourself,
warranty will be void.
6. If the network card falls into water, DO NOT USE IT AGAIN BE ORE YOU
SEND THE CARD TO THE DEALER O PURCHASE OR INSPECTION.
7. If you smell something strange or even see some smoke coming out from
the network card, switch the computer off immediately, and call dealer of
purchase for help.
1-3 System Requirements
An empty USB 2.0 port (May not be able work with USB 1.1 port, and
performance will be greatly reduced)
Windows XP, Vista, or Windows 7 operating system
CD-ROM drive
At least 100MB of available disk space
3
1.4 Package Contents
Before you starting to use this wireless network adapter, please check if
there is any of the items missing in the package, and contact your dealer of
purchase to claim for missing items:
□
USB Wireless Network Card (1pcs) ……..……………………. 1
□
Driver/Utility/Quick Guide/User Manual CD-ROM (1 pcs) …... 2
1
2
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Adaptador de Icidu
Icidu
Icidu AL-707944 Manual de usuario
Icidu
Icidu NI-707529 Instrucciones de montaje
Icidu
Icidu 200 MBPS Manual de usuario
Icidu
Icidu NI-707524 Manual de usuario
Icidu
Icidu 200 MBPS Manual de usuario
Icidu
Icidu CARDBUS Manual de usuario
Icidu
Icidu CARDBUS ADAPTER USB 2.0 4 PORTS Manual de usuario
Icidu
Icidu NI-707503 Manual de usuario
