IBM TotalStorage NAS 100 Manual de usuario

IBM TotalStorage NAS 100

Rack Installation Instructions

򔻐򗗠򙳰

IBM TotalStorage NAS 100

Rack Installation Instructions

򔻐򗗠򙳰

First Edition (August 2002)

US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract

with IBM Corp.

IBM TotalStorage

™

NAS 100 Rack Installation Instructions

Checking the rack installation kit

Items that you find in the kit:

vTwo telescopic slide rails

vFour brackets

vTwo mounting ears

vOne cable spiral wrap and eight cable ties

vAssorted hardware, including cage nuts, clip nuts, screws, nuts, and washers

vOne Rack Installation Instructions (this manual)

Items that you provide:

vOne Phillips #2 screwdriver

vOne flat-blade screwdriver (if you are using cage nuts)

vOne nutdriver or pair of pliers

Attaching the brackets

The following procedure explains how to attach the brackets to the telescopic slide

rails.

1. Extend the inner server slide rail as far as it will go.

2. Pull the white spring tab on the server slide rail towards its open end and

remove the server slide rail. Set it aside for attaching to the NAS 100 later.

1 Server slide rail

2 Spring tab

3 Telescopic slide rail

2NAS 100 Rack Installation Instructions

3. Attach the first bracket to the front end (the white end) of the telescopic slide

rail:

a. Locate the alignment screw hole on the front end of the outer telescopic

slide rail and align the bracket with it. The alignment screw hole establishes

where each screw will go in relation to the bracket. For most installations,

the alignment screw hole and bracket alignment will be the one illustrated in

the following figure.

1 Alignment screw hole

2 Bracket

3 Outer telescopic slide rail

Note: You will have to slide the inner ball-bearing slide rail and the inner

telescopic slide rail back and forth to align the oval cutout with the

screw hole so that you can insert the screw.

b. Insert an M4 screw through the bracket and in the alignment screw hole,

fasten a washer and an M4 nut to it, and firmly tighten them. Repeat this

step with three more screws in the remaining holes.

4. Extend the slide rails fully.

IBM TotalStorage

™

NAS 100 Rack Installation Instructions 3

5. Loosely attach the next bracket to the back end of the telescopic slide rail with

four more M4 screws, washers, and nuts, as shown in the following figure.

1 Telescopic slide rail

2 Bracket

Note: Do not completely tighten these screws until you install the slide rail into

the rack. This will make attaching the slide rail to the rack much easier.

After the slide rail is attached to the rack, you can tighten the screws on

the back bracket.

6. Hold the slide rails with the attached brackets up to the rack and check that the

slide rails and brackets will fit in the rack. Make any necessary adjustments to

the back end of the slide rail and its bracket.

7. Repeat this process with the other telescopic slide rail and brackets.

Note: Make sure that you install the screws in the other telescopic slide rail in

exactly the same places that you installed them in the first telescopic

slide rail.

4NAS 100 Rack Installation Instructions

Mounting the slide rails on the rack

The following procedure explains how to attach the telescopic slide rails to the rack.

1. Determine where on the rack you want to mount the NAS 100.

2. Depending on your rack type, use a screwdriver to insert the cage nuts or slide

the clip nuts into the appropriate holes. You will install two nuts on each side of

the back of the rack and three nuts on each side of the front of the rack (the top

nut is used for the mounting ear on the front of the NAS 100).

Note: Make sure that you insert each of the bottom nuts at the same height on

the rack so that the installed NAS 100 will be level.

1 Cage or clip (shown) nut

2 Front bracket

3 Back bracket

4 Left/right front mounting template

5 Left/right back mounting template

IBM TotalStorage

™

NAS 100 Rack Installation Instructions 5

3. Secure the front end of the slide rail to the front of the rack with three M6

screws.

4. Secure the back end of the slide rail to the back of the rack with two M6

screws.

5. Tighten the rear bracket M4 screws of the telescopic slide rail.

6. Repeat this procedure with the other telescopic slide rail and brackets.

6NAS 100 Rack Installation Instructions

Tabla de contenidos

Otros manuales de Almacenamiento de IBM

IBM

IBM Elastic Storage System 3200 Manual técnico

IBM

IBM N Series Instrucciones de instalación

IBM

IBM 7133 Series Manual de usuario

IBM

IBM eserver p Series Manual de usuario

IBM

IBM Ultrastar 18ZX Manual de usuario

IBM

IBM DCXA-210000 Manual de usuario

IBM

IBM System Storage DS5000 series Guía de instalación

IBM

IBM Netfinity EXP300 Manual de usuario

IBM

IBM TS1140 Manual de usuario

IBM

IBM SAN192C-6 Manual

IBM

IBM N6270 Manual de usuario

IBM

IBM 3350-A2 Manual de usuario

IBM

IBM Storwize V5000 Manual de usuario

IBM

IBM Cloud Object Storage System Manual del propietario

IBM

IBM Deskstar Deskstar 3 Manual de usuario

IBM

IBM 4690 Manual de usuario

IBM

IBM TotalStorage Ultrium T800 Manual

IBM

IBM Accesser 4105 Manual de usuario

IBM

IBM Travelstar 3XP Manual de usuario

IBM

IBM FlashSystem 840 Manual de usuario

IBM

IBM Travelstar VP Manual de usuario

IBM

IBM System Storage TS2230 Manual de usuario

IBM

IBM Storwize V7000 Manual de usuario

IBM

IBM 3409-A00 Manual de usuario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario