IBM Slicestor 2584 Manual de usuario

IBM Cloud Object Storage System™

Version 3.13.1

Slicestor®2584 Installation Guide

IBM

Note

Before using this information and the product it supports, read the following information:

vThe general information in Notices

vThe information in Safety and environmental notices

vThe information in the IBM Environmental Notices and User Guide (provided on a DVD)

This edition applies to IBM Cloud Object Storage System™Slicestor®2584 and is valid until replaced by new

editions.

US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract

with IBM Corp.

Contents

Figures ............... v

Tables ............... vii

Safety and environmental notices ... ix

Safety notices .............. ix

Environmental notices........... xii

Declared noise emissions ........ xiii

Support information ........... xiii

Chapter 1. Appliance safety precautions 1

Safe handling .............. 1

Safety................. 1

Rack system precautions .......... 2

Electrostatic discharge (ESD) precautions ..... 3

Product rating .............. 3

Chapter 2. Preparation ........ 5

Before you begin ............. 5

Unpacking the storage system ........ 5

Chapter 3. Installing the appliance into a

rack ................ 7

Mounting the system into a rack........ 7

Enclosure layout ............. 8

Installing and removing disk drives in carriers

(DDICs) ............... 10

Installing and removing cooling modules, power

supply units, and compute modules ...... 11

Battery removal ............. 14

Chapter 4. LED states ........ 17

Compute module LEDs .......... 17

Ops panel LEDs ............. 18

Drawer indicators ............ 19

Power supply unit (PSU) LEDs ........ 20

Cooling module LEDs ........... 21

Notices .............. 23

Trademarks .............. 25

Homologation statement .......... 25

iv Slicestor®2584 Installation Guide

Figures

1. Unpacking the storage system....... 6

2. Mounting the system into a rack (left rail only) 8

3. Drive numbering for drawer 1 (top)..... 9

4. Drive numbering for drawer 2 (bottom) ... 9

5. LED locations ............ 10

6. Installing a DDIC .......... 10

7. Removing a DDIC .......... 11

8. Removing a cooling module (1) ...... 11

9. Removing a cooling module (2) ...... 12

10. Removing a PSU (1).......... 12

11. Removing a PSU (2).......... 13

12. Removing a module (1). (6Gb/s SAS EBOD

module shown) ........... 13

13. Removing a module (2). (6Gb/s SAS EBOD

module shown) ........... 14

14. Remove the battery .......... 15

15. SBB compute module LEDs ....... 17

16. Ops panel LEDs ........... 18

17. Drawer status indicators ........ 19

18. PSU LEDs ............. 20

19. Cooling module LEDs ......... 21

vi Slicestor®2584 Installation Guide

Tables

1. Declared noise emissions in accordance with

ISO 9296(1,2,3) ............ xiii

2. SBB compute module LED descriptions 17

3. Ops module LED states ........ 18

4. Drawer LED states .......... 19

5. PSU LED states ........... 20

6. Cooling module LED states ....... 21

viii Slicestor®2584 Installation Guide

Safety and environmental notices

Review the safety notices, environmental notices, and electronic emission notices for IBM®Cloud Object

Storage System before you install and use the product.

Suitability for telecommunication environment - This product is not intended to connect directly or

indirectly by any means whatsoever to interfaces of public telecommunications networks.

Examples of a caution and a danger notice. Numbers in parentheses refer to message numbers in the IBM

Safety Notices publication G229-9054, which is included with your product.

CAUTION:

A caution notice indicates the presence of a hazard that has the potential of causing moderate or

minor personal injury. (C001)

DANGER

A danger notice indicates the presence of a hazard that has the potential of causing death or serious

personal injury. (D002)

Safety notices

Safety notices for this product.

Familiarize yourself with the IBM Safety Notices publication G229-9054, which is included with your

product.

DANGER: When working on or around the system, observe the following precautions:

Electrical voltage and current from power, telephone, and communication cables are hazardous. To

avoid a shock hazard:

• , connect power to this unit only with the IBM provided powerIf IBM supplied a power cord(s)

cord. Do not use the IBM provided power cord for any other product.

• Do not open or service any power supply assembly.

• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration

of this product during an electrical storm.

• The product might be equipped with multiple power cords. To remove all hazardous voltages,

disconnect all power cords.

• Connect all power cords to a properly wired and grounded electrical outlet. Ensure that the outlet

supplies proper voltage and phase rotation according to the system rating plate.

• Connect any equipment that will be attached to this product to properly wired outlets.

• When possible, use one hand only to connect or disconnect signal cables.

• Never turn on any equipment when there is evidence of fire, water, or structural damage.

• Do not attempt to switch on power to the machine until all possible unsafe conditions are corrected.

• Assume that an electrical safety hazard is present. Perform all continuity, grounding, and power

checks specified during the subsystem installation procedures to ensure that the machine meets

safety requirements.

• Do not continue with the inspection if any unsafe conditions are present.

• Disconnect the attached power cords, telecommunications systems, networks, and modems before

you open the device covers, unless instructed otherwise in the installation and configuration

procedures.

• Connect and disconnect cables as described in the following procedures when installing, moving,

or opening covers on this product or attached devices.

To disconnect:

1. Turn off everything (unless instructed otherwise).

2. Remove the power cords from the outlets.

3. Remove the signal cables from the connectors.

4. Remove all cables from the devices.

To connect:

1. Turn off everything (unless instructed otherwise).

2. Attach all cables to the devices.

3. Attach the signal cables to the connectors.

4. Attach the power cords to the outlets.

5. Turn on the devices.

• Sharp edges, corners and joints may be present in and around the system. Use care when handling

equipment to avoid cuts, scrapes and pinching. (D005)

DANGER: Heavy equipment — personal injury or equipment damage might result if mishandled.

(D006)

xSlicestor®2584 Installation Guide

Tabla de contenidos

Otros manuales de Almacenamiento de IBM

IBM

IBM 40/80 GB DLT Manual de usuario

IBM

IBM 7208 Manual

IBM

IBM Ultrastar 36LP Manual de usuario

IBM

IBM Storwize V5000 Gen2 Manual de usuario

IBM

IBM System Storage DS5020 Guía de instalación

IBM

IBM DDRS-34560 Manual de usuario

IBM

IBM DCS3700 Instrucciones de funcionamiento

IBM

IBM SAN128B-7 Manual

IBM

IBM EXP400 Type 1733 Manual de usuario

IBM

IBM Ultrastar 9ZX Manual de usuario

IBM

IBM N Series Instrucciones de instalación

IBM

IBM 3480 Manual de servicio

IBM

IBM TS4300 3555 Manual de usuario

IBM

IBM System Storage N3220 Manual

IBM

IBM Storwize V7000 Manual de usuario

IBM

IBM System Storage TS3500 Manual técnico

IBM

IBM N6270 Manual de usuario

IBM

IBM System Storage TS3100 Manual de usuario

IBM

IBM N2115 Manual de instalación

IBM

IBM DYLA-26480 Manual de usuario

IBM

IBM 39M5657 Manual de usuario

IBM

IBM FlashSystem A9000R Guía de referencia rápida

IBM

IBM FlashSystem 840 Manual de usuario

IBM

IBM EXN1000 Manual de usuario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario