HyperLink Technologies HG2408P Manual de usuario
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 1
Hyperlink Technologies, Inc.
Hyperlink WaveLAN
Extended Range Wireless LAN Kit
Featuring Lucent Technologies WaveLAN Technology
Installation Manual
NOTE: The antenna system shall be installed ONLY by experienced antenna
installers who are familiar with local building and safety codes, and
wherever necessary have been licensed by appropriate government
regulatory bodies. Failure to do so may void the Product Warranty, as well
as expose the end-user to legal and/or financial liabilities. Hyperlink
Technologies, its agents, resellers or distributors, are not liable for injury,
damage, or violation of government regulations that may arise from failing
to comply with the guidelines described in this document.
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 2
Hyperlink Technologies, Inc.
Disclaimer: The diagrams used in this manual are for illustrative purposes only.
They should not be confused with the PC card operating in standalone mode. When
these diagrams are used the PC card transceiver will be installed in conjunction with
the specific DC Injector/Lightning Protector, Amplifier, cables and antennas listed in
this manual.
Copyright © 2000, Hyperlink Technologies, Inc.. All rights reserved. No part of the
contents of this document may be transmitted or reproduced in any form or by any
means without the written permission of Hyperlink Technologies, Inc.
Portions Copyright © Lucent Technologies, Inc. All rights reserved
HyperGain and HyperAmp are trademarks of Hyperlink Technologies, Inc.
WaveLAN, WavePOINT and Orinoco are registered trademarks of Lucent
Technologies, Inc.
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 3
Hyperlink Technologies, Inc.
Contents
FCC Radio Interference Statement 4
Radiation and EIRP Information 5
Introduction 6
System Features 6
Types of Installations 7
System Requirements 8
Kit Contents 8
Tools Required 8
WaveLAN Card Features 8
Overall System Configuration 9
Antenna System Connection 10
Surveying the Antenna Site 10
Preparing for System Installation 11
Connections & Features of the Amplifier 12
The DC Power Injector/Lightning Protector 13
Mounting & Cabling the Amplified Antenna System 14
Installing the WaveLAN PC Card 16
Channel Settings 16
Basic System Checks 17
WaveLAN Antenna Alignment Diagnostics 17
System Specifications 18
APPENDICES
Antenna Mounting Instructions Appendix A
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 4
Hyperlink Technologies, Inc.
USA-Federal Communications Commission (FCC)
Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Information to the user
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy. If not installed and used in accordance with the instructions, it
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the distance between the equipment and the receiver.
•Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications of equipment not expressly approved by the
manufacturer could void the user’s authority to operate the equipment and the
company’s warranty.
NOTE: The antenna system shall be installed ONLY by experienced antenna
installers who are familiar with local building and safety codes, and
wherever necessary have been licensed by appropriate government
regulatory bodies. Failure to do so may void the Product Warranty, as well
as expose the end-user to legal and/or financial liabilities. Hyperlink
Technologies, its agents, resellers or distributors, are not liable for injury,
damage, or violation of government regulations that may arise from failing
to comply with the guidelines described in this document.
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 5
Hyperlink Technologies, Inc.
Caution: Exposure to Radio Frequency Radiation.
The radiated output power of this product is below the FCC radio exposure limits.
Nevertheless, this product shall be used in such a manner that the potential for
human contact during normal operation is minimized.
Antenna shall be mounted in such a manner as to minimize the potential for
human contact during normal operation. In order to avoid the possibility of
exceeding the FCC radio frequency exposure limits, human proximity to the
antenna shall not be less than 20 cm (8 inches) during normal operation.
Hyperlink Technologies is not responsible for any radio or television interference
caused by unauthorized modification of this device or the substitution or attachment
of connecting cables and equipment other than specified by Hyperlink
Technologies. The correction of interference caused by such unauthorized
modification, substitution or attachment will be the responsibility of the user.
Antenna
Type Specified
Antenna Gain
(dBi)
Maximum Output
Power at Antenna
Terminal (dBm)
Total EIRP
(dBm) Minimum RF
Exposure
Separation
Distance (cm)
HG2408P 7.5 24 31.5 10.6
HG2408U 8.0 24 32.0 11.2
HG2412P 12.0 20 32.2 11.5
HG2415Y 14.5 20 34.7 15.3
HG2415U 15.0 20 35.2 16.2
HG2415G 15.0 20 35.2 16.2
HG2419G 19.0 17 36.0 17.8
HG2424G 23.5 11 35.1 16.0
WARNING: It is the responsibility of the professional installer to ensure that when
using the outdoor antenna kits in the United States (or where the FCC rules apply),
only these antenna configurations shown in the table above and which are
described in this document are used. The use of any other than those listed is
expressly forbidden in accordance to FCC rules CFR47 part 15.204.
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 6
Hyperlink Technologies, Inc.
Introduction
The Hyperlink Extended Range Wireless LAN Kit is a direct sequence spread
spectrum wireless transceiver providing 11 Mbit/sec data rate to support wireless
connections in an IEEE 802.3 LAN. Equipped with a Hyperlink Extended Range
Amplified Antenna System, this product offers a high-performance long-range
building-to-building wireless networking solution.
This kit incorporates Lucent Technologies WaveLANtechnology. WaveLAN uses a
state-of-the-art direct sequence spread spectrum technology to implement robust
11 Mbps transmission, and offers true “Plug and Play” installation.
System Features:
This system has the following features:
•IEEE 802.11 Compatibility.
•Wireless 11 Mbps data rate.
•State-of-the-art spread spectrum technology provides
reliable, secure, long range, radio link operation.
•True “Plug and Play” installation for compatibility with all
802.3 and Ethernet II LAN devices, all operating systems
and all protocol stacks.
•PCMCIA Form Factor
•User-selectable channels of operation.
•Remote mounted bi-directional amplifier to optimize
transmit power and eliminate the effects of system cable
losses.
•Limited 2 year Warranty.
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 7
Hyperlink Technologies, Inc.
Types of Installations
The type of application will determine which type of kit to install:
1. Fixed Point-to-Point(Building-to-Building or Tower-to-Tower):Typically
these installations will typically require directional Yagi, Panel or Grid Antenna kits.
These devicesare authorized for operation in fixed, point-to-point
configurations only. The professional installer is responsible for
ensuring that the system is used exclusively for fixed, point-to-point
operations.
ANTENNA MODEL ANTENNA GAIN TYPE
HG2408P 8 dBiDIRECTIONAL PATCH
HG2412P 12 dBi DIRECTIONAL PANEL
HG2415G 15 dBi DIRECTIONAL GRID
HG2415Y 14.5 dBi DIRECTIONAL YAGI
HG2419G 19 dBi DIRECTIONAL GRID
HG2424G 23.5 dBi DIRECTIONAL GRID
2. Central Node in a Multipoint Network or Mobile Network:This type of
installation typically requires an Omni Directional Kit at the central node for 360
degree coverage.
ANTENNA MODEL ANTENNA GAIN TYPE
HG2408U8 dBiOMNIDIRECTIONAL
HG2415U 15 dBi OMNIDIRECTIONAL
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 8
Hyperlink Technologies, Inc.
System Requirements
The WaveLAN/HyperGain™ Amplified Extended Range Bridge Kit provides a
complete plug-and-play solution for linking buildings in an outdoor environment.
The PC card included can be installed in any one of the following devices:
Lucent Orinoco Central or Remote Office Router Processor
KarlNet Central or Satellite Router Processor
Other compatible PC, Router, or Bridge Processor equipped with a PC Card slot
Besides one of the host processors above, all you need to add is suitable masts
or towers and some basic site planning. Please read this manual in its entirety
before beginning the installation.
Kit Contents:
Each Kit contains the following items:
WaveLAN/Orinoco Turbo 11 Mbit IEEE 802.11 PC Card
HyperAmp Remote Mounted Amplifier
HyperGain Antenna (Omni, Yagi, Panel or Grid)
HyperGain DC Power Injector/Lightning Protector
50 ft. Antenna Cable
0.5 meter Jumper Cable
Mounting Hardware
Manual
Tools Required:
Assorted open-end or adjustable wrenches
#12-10 AWG or similar wire (for grounding)
Wire cutter / stripper
Pliers
Other Required Equipment:
Suitable mast or tower hardware
Other Helpful Equipment and Tools:
Cellular telephones or Walkie-talkies
Binoculars
Compass
Handheld GPS
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page 9
Hyperlink Technologies, Inc.
Overall System Configuration
The overall system configuration is shown below. Refer to this diagram while
reading the section which follows, and during system installation.
WaveLAN
PC Card
Adapter
Cable 0.5
meter
DC Power
Injector
Antenna
Cable 50ft.
Antenna
Network
Workstation,
WavePOINT-II
Processor or
other Bridge Unit
Amplifier
DC Power
Supply
Hyperlink Extended Range WLAN Kit Installation Manual Rev. A Page
10
Hyperlink Technologies, Inc.
ANTENNA SYSTEM CONNECTION
NOTE: THE ANTENNA SYSTEM SHALL BE INSTALLED ONLY BY
EXPERIENCED ANTENNA INSTALLERS WHO ARE FAMILIAR WITH LOCAL
BUILDING AND SAFETY CODES, AND WHEREVER NECESSARY HAVE
BEEN LICENSED BY APPROPRIATE GOVERNMENT REGULATORY
BODIES. FAILURE TO DO SO MAY VOID THE PRODUCT WARRANTY, AS
WELL AS EXPOSE THE END-USER TO LEGAL AND/OR FINANCIAL
LIABILITIES. HYPERLINK TECHNOLOGIES, ITS AGENTS, RESELLERS OR
DISTRIBUTORS, ARE NOT LIABLE FOR INJURY, DAMAGE, OR VIOLATION
OF GOVERNMENT REGULATIONS THAT MAY ARISE FROM FAILING TO
COMPLY WITH THE GUIDELINES DESCRIBED IN THIS DOCUMENT.
Surveying the Antenna Site
Before beginning system installation, emphasis should be placed on system
planning. It is important that no large obstructions exist near the antenna, such as
retaining walls, chimneys, air-conditioning units or other antenna masts. These
types of objects canhave an impact on the antenna system performance.
Plan to mount the antenna as high as possible. You will need enough mast to
elevate the antenna approximately 10-15 feet above the roof or above any
obstruction that might be in the antenna's signal path.
You will need to identify the location where the antenna cable will be routed. If you
run the antenna cable through the roof, a water-proof fitting will be required. Consult
a building contractor or licensed electrician to help you with the routing ifnecessary.
Take note of the length of the mast you will need and the type of mounting hardware
required. The amplified antenna kit is shipped with U-Bolt mounting hardware which
should be ideal for mounting the antenna and amplifier to most types of mast. Also,
make plans on how you are going to talk to the person at the remote antenna while
you are going through the antenna alignment procedure. For example, cellular
phones or walkie-talkies can be used.
Este manual sirve para los siguientes modelos
7
Tabla de contenidos
Otros manuales de Antena de HyperLink Technologies
Manuales populares de Antena de otras marcas
Alfa Network
Alfa Network APA-L01 Manual de usuario
Naval
Naval PR-422CA Manual de usuario
Feig Electronic
Feig Electronic ID ISC.ANTH200/200 Series Manual de usuario
TERK Technologies
TERK Technologies TV44 Manual de usuario
Directive Systems & Engineering
Directive Systems & Engineering DSE2324LYRMK Manual de usuario
HP
HP J8999A Manual de usuario
