Hunter Light Kit Manual de instrucciones
Form# 43548-01
20090430
©2009 Hunter Fan Co.
English Español
4-Light Adapter
Light Kit
4-Light Adapter
Light Kit
4-Light Adapter
Light Kit
Owner’s Guide and Installation Manual
Manual De Propietario
2
43548-01 • 04/30/09 • Hunter Fan Company
Table Of Contents
Installing the Light Kit on Fans With
Removable Switch Housing ........4
Installing the Light Kit on Fans With
Non-Removable Switch Housing...6
Installing the Light Kit on the Hunter
Original .........................8
Troubleshooting.......................9
© 2009 Hunter Fan Company
Your new Hunter® light kit is an addition to your home or oce that
will provide comfort and performance for many years. is installation
and operation manual gives you complete instructions for installing
and operating your light kit.
We are proud of our work. We appreciate the opportunity to supply
you with the best products available anywhere in the world.
Before installing your light kit, for your records and warranty assistance,
record information from the carton and Hunter nameplate label.
Cautions and Warnings
•READ THIS ENTIRE MANUAL CAREFULLY BEFORE BEGINNING
INSTALLATION. SAVE THESE INSTRUCTIONS.
• Use only Hunter replacement parts.
• To reduce the risk of personal injury, install this light xture only on
Hunter® fan types A through Z. Note: e fan type can be found on
the ceiling fan package or on the nameplate label located on top of
the motor housing of the ceiling fan.
• To avoid possible electrical shock, before installing light xtures,
disconnect the power by turning o the circuit breakers both to
the outlet box and to its associated wall switch location. If you
cannot lock the circuit breakers in the o position, securely fasten a
prominent warning device, such as a tag, to the service panel.
• Connect house wiring to the fan before attaching the light xture to
the fan.
• All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualied electrician.
Welcome
3
43548-01 • 04/30/09 • Hunter Fan Company
Installation Methods for Hunter® Ceiling Fans
Your ® light kit can be installed on the Hunter
Fan Corte D’Azur, Custom Home, 42” Dominion, 52”
Dominion, Marseille, and Santa Barbara models.
Preparing the Light Kit
1. Shades are not included with this light kit. Be sure to
purchase shades for your light kit before installing this
light kit.
2. Disconnect power by turning o the circuit breakers
both to the outlet box and to its associated wall switch
location.
4
43548-01 • 04/30/09 • Hunter Fan Company
Before installing the light xture, remove the wiring harness and its components
from the fan’s lower switch housing. en install the wiring harness into the light
xture.
1. Unscrew the three screws from the upper switch housing. Disconnect the 9-pin
plug connectors. Remove the lower switch housing.
2. Push the plug button from inside the lower switch housing to remove the
plug button and switch housing cap. Unscrew the two attachment screws on
the bottom of the switch housing.
NOTE: Save the plug button and switch housing cap should you choose to
remove the light xture in the future.
3. Locate the reversing switch and carefully remove the two screws holding the
reversing switch to the lower switch housing. en, remove the reversing
switch from the housing.
4. Remove the patented breakaway connector from the end of the fan pull
chain. Carefully loosen the bellmouth nut from the pull chain and remove
the pull chain switch from the light xture housing.
5. Locate and carefully remove the two capacitors from the lower switch
housing.
You have now disconnected the wiring harnness and its components from the
lower switch housing.
Removable Switch Housing
9-Pin Plug
Connector
Lower Switch
Housing
Plug Button
Screw
Steps 1–2
WARNING: Improper installation could
cause the light xture to fall.
Fan
Speed
Switch
Steps 3–4
Reversing
Switch
Light
Switch
Light
Assembly
Housing
Capacitors
Bellmouth Nuts
Installing the Light Kit on Fans With Removable Switch Housings
5
43548-01 • 04/30/09 • Hunter Fan Company
Installing the Light Kit
Wire
Connector
Steps 10–11
Light Kit
Plug
Connector
Detail
6. Insert the pull chain and fan pull chain switch through the round
opening on the side of the empty switch housing. read the
bellmouth nut over the pull chain and hand tighten the bellmouth
nut.
7. Reattach the breakaway connector to the pull chain.
8. Insert the reversing switch into the square hole on the side of the
switch housing. Install and tighten the two screws you removed
previously from the other switch housing.
9. Carefully place the capacitors in the switch housing.
You have now installed the wiring harness and its components in the
light kit.
10. Locate the two wires in the wiring harness (removed from the lower
switch housing) labeled “Connect Light Here” or “For Light use.” One is
white; the other is white with a black stripe. Unscrew the connectors to
expose the bare metal leads.
11. Locate the white wire and the black wire coming from the light xture.
Connect the black wire from the light xture to the black/white wire
from the wiring harness. Connect the white wire from the light xture
to the white wire from the wiring harness.
To connect the wires, hold the bare metal leads together and place a
wire nut over them, then twist the wire nut clockwise until tight.
CAUTION: Be sure no bare metal wires or wire strands are visible
after making the connections.
12. Reconnect the 9-pin plug connector.
13. Install screws to reattach the light kit to the upper switch housing.
Step 12
Plug
Connector
Steps 6–9
Lower
Switch
Housing
Screw
Fan
Speed
Switch
6
43548-01 • 04/30/09 • Hunter Fan Company
Troubleshooting
Light does not come on
1. Make sure bulbs are installed properly.
2. Make sure breakers or fuses are on.
3. Verify that the light power lead is connected at the ceiling. Refer to
your ceiling fan manual for locating assembly and wiring.
Glass rattles
1. Make sure the glass shades are secure.
If you need parts or service assistance, please call
888-830-1326 or visit us at our Web site at
http://www.hunterfan.com.
Hunter Fan Company
7130 Goodlett Farms Pkwy. # 400
Memphis, Tennessee 38016
is Light Fixture Weighs 2 lbs. Printed in China
Troubleshooting
Tabla de contenidos
Otros manuales de Accesorios de Hunter
Hunter
Hunter Solar Sync Manual de usuario
Hunter
Hunter Solar Sync Manual de usuario
Hunter
Hunter MINI-CLIK Manual de usuario
Hunter
Hunter LIT-293 Manual de usuario
Hunter
Hunter Hunter Accessory Table 20523 Manual de usuario
Hunter
Hunter Wireless Rain-Clik Manual de usuario
Hunter
Hunter FLOW-CLIK Instrucciones de funcionamiento
Hunter
Hunter BP-01 Manual de usuario
Hunter
Hunter Wireless Rain-Clik Manual de usuario
Hunter
Hunter RAIN CLIK WR-CLIK Instrucciones de funcionamiento
Hunter
Hunter 43758 Manual de usuario
Hunter
Hunter DSP700 Series Manual de usuario
Hunter
Hunter WIRED RAIN-CLIK Manual de usuario
Hunter
Hunter WRC Manual de usuario
Hunter
Hunter Rain-Clik WRC-TR Manual de usuario
Hunter
Hunter WFS Manual de programación
Hunter
Hunter Wireless Rain-Clik Manual de usuario
Hunter
Hunter ET SYSTEM SMARTPORT Manual de usuario
Hunter
Hunter FLOW-SYNC HFS Manual de programación
Hunter
Hunter Wireless Rain-Clik Instrucciones originales
