HPE StoreEver MSL4048 Manual de usuario
HPE StoreEver MSL4048
Tape Library Chassis
repackaging instructions
© Copyright 2008, 2010, 2018 Hewlett Packard Enterprise
Development LP
Part Number: AG320-96017
Published: October 2018
Edition: 3
CAUTION:
Not following this procedure can cause damage to
the chassis during shipment and may void the
warranty.
1 Replacing the shipping lock
When possible, power off the chassis from the front
panel so the robot will be in the correct location to be
restrained by the shipping lock. 1) Remove the shipping
lock from its storage position on the back of the chassis.
2) If possible, place the shipping lock in the shipping
position on top of the chassis. 3) Tape the shipping lock
to the chassis to keep it in place during shipping.
2 Replacing the drive bay covers
If you removed drive bay covers from the new chassis,
attach them to the chassis you are returning.
From the back of the chassis, locate an uncovered drive
bay. Use Phillips screws to attach the drive bay covers to
the chassis.
3 Applying the protective material
Insert one foam block into each pair of magazine bays.
Page 1
Wrap the foam sheet around the chassis.
4 Packing the box
Place the foam pieces and chassis in the box in the
order shown.
Page 2
Otros manuales de Chasis de HPE
HPE
HPE 12901E Instrucciones de montaje
HPE
HPE Apollo 4510 Gen9 Instrucciones de funcionamiento y seguridad
HPE
HPE Synergy 12000 Frame Instrucciones de funcionamiento y seguridad
HPE
HPE Moonshot 1500 Manual
HPE
HPE Apollo k6000 Manual de usuario
HPE
HPE Apollo 2000 Gen10 Manual de usuario
HPE
HPE Apollo 4530 Gen9 Instrucciones de funcionamiento y seguridad
HPE
HPE Synergy 12000 Frame Instrucciones de funcionamiento y seguridad
HPE
HPE Altoline 9960 C1 Instrucciones de instalación
HPE
HPE Apollo z70 Manual de usuario
