HP A8051A Manual de usuario

Hewlett-Packard Company

3404 East Harmony Road

Fort Collins, Colorado 80528

Read Before Installing

3DLabs Wildcat III 6110 Graphics Accelerator Card

HP Product No. A8051A

General HP Installation Instructions

NOTE Before you install your graphics card, refer to the your workstation’s Technical

Reference (www.hp.com/go/workstationsupport) for important system

conﬁguration information.

CAUTION Graphic cards are susceptible to electrostatic shock. When handling your card

always wear a properly grounded wrist strap and handle the card carefully.

The latest workstation BIOS must be installed on your workstation before

installing the new graphics card. The latest BIOS can be downloaded from

http://www.hp.com/go/workstationsupport. If the latest BIOS is not installed, you

may experience no video, PCI Option ROM errors and system stops during self-

test (POST).

In addition, if you have purchased and/or installed Windows®2000, a chipset

driver must be installed to enable AGP. If an AGP graphics card is not run in

AGP mode, you may experience extremely slow graphics performance, system

lockups and Windows®stop errors. The chipset driver can be downloaded from

http://www.hp.com/go/workstationsupport.

1. Before opening your workstation to install the graphics card, disconnect all cables from the system. When refer-

ring to your system model/type and for obtaining the proper driver version, please use the AxxxxX nomenclature

found on the Serial Number plate on the back of the machine.

2. Following the procedures described in your workstation’s Technical Reference, install the graphics board into the

AGP Pro slot (see the next diagram). Slide the board into the slot and ensure it is fully seated in the connector.

3. Attach your monitor cable to the primary port. If you have two monitors, attach the primary monitor to the pri-

mary port and the second monitor to the secondary port. Use the included DVI-I dongle to attach an analog mon-

itor to the either port.

4. Once you have installed the card, you must install the proper graphics driver which is available on the enclosed

3Dlabs Wildcat III CD.

To obtain future driver upgrades and the Card Installation Instructions as supplied by 3Dlabs go to:

http://www.hp.com/go/workstationsupport

a. If you are installing on a system that previously had a different graphics card, you must uninstall that device’s

driver. Use the Windows®Control Panel utilities (Add/Remove Programs) to remove the old driver. Then shut

down the system.

b. Remove the old graphics card. Install the 3Dlabs Wildcat III card and reboot the system. Then install the Wil-

cat III driver from the provided CD-ROM.

5. Refer to your workstation’s Owner's Guide for instructions on how to verify your graphics conﬁguration.

For information on other 3Dlabs products, visit: http://www.3dlabs.com

HP Hardware Warranty

This HP accessory is covered by a limited hardware warranty for a period of one year from the date of purchase by

the original end-user. The type of service provided is return to an HP or repair-authorized reseller service-center. At

Hewlett-Packard’s discretion, a defective accessory will be repaired or replaced by a new unit, either of the same type

or of an equivalent model.

If this accessory is purchased and used together with an HP Visualize Personal Workstation, it will be covered by the

warranty of this computer or workstation, under the same conditions of service and duration. Please refer to the war-

ranty statement provided with your HP Visualize Personal Workstation for warranty limitations, customer responsi-

bilities, and other terms and conditions.

FOR CONSUMER TRANSACTIONS IN AUSTRALIA AND NEW ZEALAND: The warranty terms contained in

this statement, except to the extent lawfully permitted, do not exclude, restrict or modify and are in addition to the

mandatory statutory rights applicable to the sale of this product to you.

Example system board Example graphics card

Install 3DLabs

Wildcat III Card in

AGP Pro Slot

primary port

secondary port

Regulatory Information

FCC (for USA only)

Federal Communications Commission Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules and the Canadian Department of Communications. These limits

are designed to provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be required to correct the interference

at his own expense.

Notice for Canada

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numérique de la Class B respecte toutes les exigences du Règlement sur le matériel

brouilleur du Canada.

Notice for Japan (Class B)

Declaration of Conformity

according to ISO/IEC Guide 22 and EN 45014

Manufacturer: Hewlett-Packard Company

3404 East Harmony Rd.

Fort Collins, CO 80528

USA

Declares that the:

Product Name: 3Dlabs Wildcat III 6110 Graphics Accelerator Card (as supplied by 3Dlabs corp.)

Model Number: A8051A

Product Options: All

conforms to the following speciﬁcations:

Safety EN 60950

EMC CISPR 22: 1993 & EN 55022: 1994 Class B

EN 50024:1998

Also compliant with. . .

EN 61000-3-2: 1995

EN 61000-3-3: 1995

U.S. FCC Part 15, Class B

Japan VCCI Class B

Australia/New Zealand AS/NZS 3548:1995A

and is certiﬁed by: Bay Area Compliance Laboratory Corporation

Supplementary information:

The product herewith complies with the requirements of the following Directives and carries the CE marking

accordingly:

- the EMC directive 89/336/EEC and 92/31/EEC and 93/68/EEC

- the Low Voltage Directive 73/23/EEC and 93/68/EEC

This product was tested in a typical Hewlett-Packard workstation conﬁguration.

Original signed by Ruth Lutes, Site Quality Manager, Fort Collins, CO, USA

For Compliance Information ONLY, contact:

European Contact: Your local Hewlett-Packard Sales and Service Ofﬁce or Hewlett-Packard GmbH, Dept. HQ-

TRE Standards Europe, Herrenberger Strasse 130 Boeblingen (FAX: +49-7031-14-3143)

Americas Contact: Hewlett-Packard, Fort Collins Site Quality Mgr., Mail Stop 64, 3404 E. Harmony Road,

Fort Collins, CO 80528, U.S.A.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Tarjeta de video de HP

HP P Class 733/800/866MHz / 1GHz Manual de usuario

HP Xw9400 - Workstation - 16 GB RAM Manual de usuario

HP NVIDIA Quadro FX 1700 Instrucciones de uso

HP Xw460c - ProLiant - Blade Workstation Manual de usuario

HP E1C64AA Manual de usuario

HP AMD Radeon 7000 Manual de usuario

HP B180L Manual de usuario

HP Xw4550 - Workstation - 2 GB RAM Manual de usuario

HP Visualize b1000 Manual de usuario

HP 8886 - Photosmart Camera Dock Digital Docking... Manual de usuario

HP Xw460c - ProLiant - Blade Workstation Manual de usuario

HP P Class 733/800/866MHz / 1GHz Manual

HP NVIDIA Quadro FX 570 Instrucciones de uso

HP NVIDIA Quadro FX 1400 Instrucciones de uso

HP Workstation x1000 Manual de usuario

HP c3700 - Workstation Manual de usuario

HP 7500 PCI Manual de usuario

HP Workstation x1000 Manual de usuario

HP ATI FireGL V5100 Instrucciones de uso

HP p2289a Manual de usuario

HP ATI FireGL V3100 Manual de usuario

HP Matrox G450 Manual de usuario

HP NVIDIA Quadro FX 3400 Instrucciones de uso

HP Hurricane Guía

Manuales populares de Tarjeta de video de otras marcas

Gainward

Gainward GeForce GTX 690 4GB Manual de usuario

ATI Technologies

ATI Technologies RADEON 137-40225-20 Manual de usuario

MSI

MSI N220GT series Manual de usuario

ATI Technologies

ATI Technologies RADEON 7000 MAC EDITION Manual de usuario

SIIG

SIIG aurora Manual de usuario

ClearSpeed

ClearSpeed ClearSpeed Advance e720 Manual de usuario

MSI

MSI R7850 series Manual de usuario

DVS

DVS Atomix HDMI Manual de usuario

Aztech

Aztech VGS3D-AGP Manual de usuario

Advoli

Advoli TB4 Standard Manual de usuario

ELSA

ELSA ERAZOR III LT Manual de usuario

Gigabyte

Gigabyte GV-R7500L Manual de usuario

Themis

Themis TGA-7000 PMC Manual de usuario

EMS

EMS XtremeRGB-Ex1 Manual de usuario

Nvidia

Nvidia Quadro Workstation Manual de usuario

Pioneer

Pioneer PDA-5003 Manual de usuario

QDI

QDI N2 Manual de usuario

NEC

NEC N8116-48 Manual de usuario