HP StorageWorks 600 - Modular Disk System Hoja de instrucciones

Important

Rack Installation Guidelines

for the HP BladeSystem 70 Scalable Storage Array and

the HP StorageWorks 600 Modular Disk System

Overview

This document provides guidelines for installing an HP BladeSystem

70 Scalable Storage Array or HP StorageWorks 600 Modular Disk

System into a rack.

Rack installation guidelines

WARNING: When configuring a solution, make sure that

the floor loading specifications are followed. Failure to do

so can result in physical injury or damage to the

equipment and the facility.

WARNING: The storage array with no drives installed

weighs 72.58 kg (160.00 lb). With all drives and

components installed, the storage array can weigh up to

145.15 kg (320 lb). Before configuring your rack solution,

be sure to check the manufacturer weight limits and

specifications. Failure to do so can result in physical injury

or damage to the equipment and the facility.

Observe the following guidelines when installing the SSA70 or

MDS600 into a rack:

•Do not install the SSA70 or MDS600 in the bottom of a rack

other than an HP10000. To install the SSA70 or MDS600 in

the bottom of an HP10000 rack, you must first install a support

bracket and spacer. See "Installing a rack support bracket."

•To install the SSA70 or MDS600 into a third-party rack, or

above any component other than a c3000 enclosure, c7000

enclosure, or another SSA70 or MDS600, you must first install

a support tray. See "Installing a support tray."

•To install an SSA70 or MDS600 above a c3000 or c7000

enclosure, you must first attach a spacer to the top of the

enclosure. See "Attaching a spacer to an enclosure installed

below an SSA70 or MDS600."

•No spacer is required when installing one SSA70 or MDS600

above another SSA70 or MDS600.

Example rack configurations

Item Description

1 SSA70 or MDS600 installed above a support

bracket

2 SSA70 or MDS600

3 c7000 enclosure with a spacer installed

4 SSA70 or MDS600

Item Description

1 c7000 enclosure with a spacer installed

2 SSA70 or MDS600

3 SSA70 or MDS600

Item Description

1 Server

2 Support tray with a spacer installed

3 SSA70 or MDS600

4 SSA70 or MDS600

Item Description

1 c7000 enclosure

2 PDU

3 Support tray with a spacer installed

4 SSA70 or MDS600

5 SSA70 or MDS600

Installing a rack support bracket

1. Place the support bracket in the bottom of the rack and align

with the screw holes in front of the rear vertical rails.

The information contained herein is subject to change without notice. The

only warranties for HP products and services are set forth in the express

warranty statements accompanying such products and services. Nothing

herein should be construed as constituting an additional warranty. HP shall

not be liable for technical or editorial errors or omissions contained herein.

Part Number 498381-002

December 2008 (Second Edition)

Printed in the United States

498381- 002

2. Install three screws on each side of the bracket.

3. Attach a spacer to the front caster plate. Center the spacer

approximately 2.54 to 7.62 cm (1.00 to 3.00 in) behind the

front edge of the caster plate. Apply pressure to adhere the

spacer to the caster plate.

Installing a support bracket riser

To install the component:

1. Place the riser on top of the support bracket, aligning the

mounting holes.

2. Secure the riser to the support bracket with the provided self-

tapping screws.

The installation is complete.

Attaching a spacer to an

enclosure installed below an

SSA70 or MDS600

If the SSA70 or MDS600 is being installed in the rack directly above

a c3000 or c7000 enclosure, a spacer must be adhered to the top

of the c3000 or c7000 enclosure.

IMPORTANT: Do not attach the spacer to an SSA70 or

MDS600 unit.

1. Remove the protective backing from the spacer.

2. Center the spacer approximately 2.54 to 7.62 cm (1.00 to

3.00 in) behind the front edge of the enclosure. Apply pressure

to adhere the spacer to the enclosure.

IMPORTANT: Do not cover any labels on the enclosure

when attaching the spacer.

Installing a support tray

1. Install two clip nuts on each side of the front and rear of the

rack at the top and bottom of a 1U space.

2. Install each rear side bracket using two screws. Do not fully

tighten the screws. L (left) and R (right) markings indicate the

correct side for installation when viewed from the front of the

rack. The support pin should be facing inward.

3. Insert the support tray into the rack front.

4. Set the support tray on the support pins on the rear side

brackets.

5. Install four screws to secure the front of the support tray to the

rack, and then tighten all four front screws.

6. Install two screws through the rear of the support tray into the

threaded inserts on the rear side brackets, and then tighten all

screws.

7. Center the spacer approximately 2.54 to 7.62 cm (1.00 to

3.00 in) behind the front edge of the support tray. Apply

pressure to adhere the spacer to the support tray.

Otros manuales para StorageWorks 600 - Modular Disk System

Otros manuales de Almacenamiento de HP

HP Pavilion p6000 - Desktop PC Guía

HP StoreOnce B6000 Instrucciones de funcionamiento

HP v275w Manual de usuario

HP XP20000/XP24000 Manual de usuario

HP C4405A - Colorado 14GB Tape Drive Manual de usuario

HP Surestore Disk Array 12h - And FC60 Instrucciones de montaje

HP FIPS 140-2 Manual

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Manual de instrucciones

HP StoreOnce 4900 Backup Manual de instrucciones

HP Surestore Tape Library Model 2/28 Manual de usuario

HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Manual de usuario

HP C2246 Manual del producto

HP Surestore Disk Array 12h - And FC60 Guía rápida

HP StorageWorks P2000 Manual de usuario

HP P9000 Manual de usuario

HP A5585A - SureStore DLT E Tape Library 4/40 Guía

HP AU183AA - 2TB Personal Media Drive Manual de uso y mantenimiento

HP nimblestorage CS235 Manual de usuario

HP GM415AA - Pocket Media Drive 160 GB External... Manual de usuario

HP v229g Manual de usuario

HP StorageWorks NAS 8000 - Version 1.6.X Manual de instrucciones

HP P2000 G3 Manual de usuario

HP StorageWorks Disk System 2405 Manual de uso y cuidado

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario

Dell

Dell PowerVault MD3600f Series Manual de usuario

CFI

CFI TERA STOR SATA RAID IV Manual de usuario