HP 9100C Digital Sender Manual de usuario
1. Load the documents into feeder{face up} / or on glass {face down}
2. Press E-Mail
3. Type your email address in the FROM Field.
4. Press Enter.
5. Type a subject into SUBJECT Line.
6. Press Enter
7. Type a valid email address in the TO field.
8. Press Enter. {you can repeat this process for multiple email addresses}
9. Press Start
Email
Enter
Start
Email
-Loading a document
You can load a stack of pages in the ADF
or load one page at a time on the glass.
See “What documents you can place in
the digital sender”on page 30 if you
need help determining which method to
use.
CAUTION
Before using the ADF, remove from the
document anything such as self-
adhesive notes, paper clips, or staples,
that could get caught in the digital
sender and damage it.
To load a document in the ADF
1Raise the ADF unit and ensure
nothing is on the glass. Then, close
ADF unit.
2Slide the document (up to 50 pages)
face up, top first, into the ADF until
the document stops. Center the
document between the document
guides.
3Adjust the document guides to fit
snugly against the sides of the stack.
4If necessary, adjust the output
support to the correct paper size.
5Set the digital sender to accept your
single- or double-sided document by
pressing the SINGLE-/DOUBLE-SIDED
key until the light under the correct
icon is lit.
6---.
1
2
3
4
--
To load a document on the
glass
1Raise the ADF unit to reveal the
glass.
2Place the page face down on the
glass, top edge toward the back.
3Align the document in the upper-
right corner of the glass.
4Lower the ADF unit.
5-.
1
2
3
4
-
To clear jams at the end of a
page
1Raise the control panel and then the
document tray.
2Remove the jammed paper.
3Close the document tray and push
the control panel down securely.
4The control panel prompts you to do
one of the following:
Reinsert the paper and press
to continue sending.
Stop processing and send the
data to its destination by pressing
SEND.
Stop sending without saving your
data by pressing .
1
2
3
Clearing paper jams
When you have a paper jam, the control
panel displays this message: Paper
jam. Open the cover and remove the
paper. Use the appropriate procedure
below to clear the jam.
To clear jams at the start of a
page
1Raise the control panel.
2Remove the jammed paper.
3Push the control panel down
securely.
4The control panel prompts you to do
one of the following:
Reinsert the paper and press
to continue sending.
Stop processing and send the
data to its destination by pressing
SEND.
Stop sending without saving your
data by pressing .
1
2
3
To clear jams inside the ADF
1Raise the control panel.
2Raise the ADF unit.
3Open the delivery guide by grasping
the small plastic handles on either
side of the delivery guide and pulling
down.
4Remove the jammed paper.
1
2
3
4
-
5Close the delivery guide sheet by
aligning its holes with the small
plastic spindles on the delivery guide
and pressing down.
6Close the ADF unit.
7Push the control panel down
securely.
8The control panel prompts you to do
one of the following:
Reinsert the paper and press
to continue sending.
Stop processing and send the
data to its destination by pressing
SEND.
Stop sending without saving your
data by pressing .
5
6
Tabla de contenidos
Otros manuales de Lector de código de barras de HP
HP
HP EY022AA Instrucciones de uso
HP
HP Engage One 2D Manual de usuario
HP
HP Wireless Barcode Scanner Manual de usuario
HP
HP BW868AA Manual de usuario
HP
HP 82153A Manual de usuario
HP
HP 4430 Manual de usuario
HP
HP LaserJetsseries Manual de usuario
HP
HP 9200C - Digital Sender Manual de usuario
HP
HP Wireless Barcode Scanner Manual de usuario
HP
HP Linear Barcode Scanner II Manual de usuario
