Hotpoint FFU00P Manual de usuario

Remember, you may be charged for a service call, if a problem with your appliance is caused by incorrect installation and misuse.

Refer to the User Instructions to see the details of the installation location and the procedures.

●

Wiring and piping may vary with model.

●

It may be necessary to remove both doors if the appliance will not fit through a doorway.

Installation Guide

Remove the lower cover and pull out

the feed water tube, while pressing

area (1).

NOTE: Cut away any tube end that is

misshapen or worn.

Lift the door off the lower hinge.

Carry the doors through the access

door and lay them down on suitable

material eg.the original packaging.

Pass the appliance through the access

door, in its upright position.

Replace both doors by carrying out

directions in Step 2 (above) in reverse

order

If the doors are misaligned, they will

not close correctly and performance

will be affected. Realign as follows:

The doors can be levelled by inserting

a flat blade (- type) screwdriver into

the groove of the height adjusting

screw and rotating it, in a clockwise

direction, to the arrow.

●

If the freezer compartment door is lower

adjust the left hand adjustment screw.

●

If the fridge compartment door is lower

adjust the right hand adjustment screw.

NOTE: You may need assistance to do

this:

NOTE:

●Support doors at all times, ensuring

they do not fall forward,as this

could cause injury or damage.

●Take care not to damage the feed

water tube when laying down the

Freezer compartment door.

Remove the hinge cover and

separate all connection wires,except

for the earth line.

Remove the retainer by rotating it

Freezer = anti-clockwise (a).

Fridge = clockwise (b).

Then remove the upper hinge by

lifting up.

Ensure the Freezer compartment

door is lifted enough for the feed

water tube to be completely pulled

out.

Freezer

Fridge

NOTE: You may need assistance to do

this:

WARNING!: Your appliance is heavy

and care must be taken when moving

it.

Connection to the mains water supply

Part No. FP111 - 01

●

FIRST CHECK YOU HAVE ALL THE CORRECT ITEMS:

●

Connection to the Appliance:

●

Connection of Water Filter:

●

Connection to the Water Tap:

●

FINALLY: Switch on the power and turn on the water supply tap. Check for any leaks. Place a cup under the dispenser to verify that

the water is flowing, ensure the selection is set to‘water’. When all working OK, move the appliance into its final location, take care

not to trap or kink hoses at the back of the appliance when moving it. Replace the Lower Cover.

Mount the water filter in an accessible position next to the appliance using the self-adhesive fixing plates and cable ties supplied.

●

Pipe / Filter Kit comprises:

* 1 x Water Filter

* 2 x Self-Adhesive

Fixing Plates

* 2 x Cable Ties

* 1 x 10m Water Pipe

●

Adaptor Kit comprises:

* Plastic Pipe Connector

* Rubber Washer

* Threaded Tap Connector

●

NEXT HAVE A LOOK AT THE DIAGRAM BELOW TO VISUALISE HOW THE APPLIANCE SHOULD BE CONNECTED:

FRIDGE

FILTER

WATER PIPE WATER PIPE TAP

*At the back of the appliance you

will see the water inlet valve (Fig.A)

*Now you have to cut the pipe from the back of the appliance to the length it needs to be to attach to the water filter.

NB.The water filter is marked with an arrow to show the direction of water flow (ie.from tap to appliance).

Remember however, that the connection is being done FROM the appliance TO the tap (ie. in reverse of the water flow when in use).

*You now need to cut the water pipe to the right length for the connection of the water filter. It is suggested that approximately 1.5m of

pipe is used - this should allow the filter to be located in an easily accessible position (it should be

replaced approximately every 6 months, according to use and conditions) and also allow some slack in

the pipe behind the appliance so that it can be pulled out for cleaning or servicing purposes.

*Unscrew the metal threaded collar

and place it over one end of the

water pipe (Fig.B)

*Push the water pipe onto the water

inlet valve firmly, tighten up the

metal collar (Fig.C)

*Unscrew the threaded

connector and place it

over the end of the cut

section of pipe coming

away from the

appliance.

Push the pipe over the

end of the water filter

that the arrow points

to and tighten the

threaded connector

(Fig.D)

*Repeat on the other

end of the water filter,

using the remainder of

water pipe (Fig.E)

*Run this section of

water pipe from the

water filter to the water

supply tap, making sure

it is not trapped or

kinked at all.

*Cut the pipe that is

connected to the

water filter to the correct

length. Again, make sure

that the cut is nice and

square to avoid leaks.

*Push the pipe into the

smaller hole of the

connector supplied in the

adaptor kit. The pipe

should be held firm.

(Fig.F)

*Place the threaded tap

connector over the long

part of the brass flange.

Firmly push the flange

into the other end of

the water connector

(Fig.G)

*Place the rubber washer inside the

threaded tap connector and screw onto

the water tap.

You must also ensure that the cut is square and not at any sort of angle as this could cause a leak. ✓✗

The appliance is supplied with a pipe/filter kit and an adaptor kit for water pipework.

Note the direction markings on the filter

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Refrigerador de Hotpoint

Hotpoint

Hotpoint RLS150G Manual de usuario

Hotpoint

Hotpoint FFFL xxxx x O3 Manual de usuario

Hotpoint

Hotpoint 8130 Manual de usuario

Hotpoint

Hotpoint FF65 Manual de usuario

Hotpoint

Hotpoint Quadrio 4D AA X/HA Manual de usuario

Hotpoint

Hotpoint HTH17CBDLWW Manual

Hotpoint

Hotpoint 22 Series Instrucciones de funcionamiento

Hotpoint

Hotpoint HTS18BBPULWW and Instrucciones de funcionamiento

Hotpoint

Hotpoint RLA50 Manual de usuario

Hotpoint

Hotpoint CTX18 Instrucciones de instalación

Hotpoint

Hotpoint FFFM 1 Series Manual de usuario

Hotpoint

Hotpoint DC 85 Series Manual de usuario

Hotpoint

Hotpoint XEX95 Series Manual de usuario

Hotpoint

Hotpoint ENXTY 19 FO3 Series Manual de usuario

Hotpoint

Hotpoint HTM18IBPSA - 18' Refrigerator Instrucciones de montaje

Hotpoint

Hotpoint HS3022VL Manual de usuario

Hotpoint

Hotpoint CTX18 Instrucciones de instalación

Hotpoint

Hotpoint FFS70 Manual de usuario

Hotpoint

Hotpoint SH8 2D XROFD 2 Manual de usuario

Hotpoint

Hotpoint HM 3x AA F Manual de usuario

Hotpoint

Hotpoint CTX18LYZ Manual de usuario

Hotpoint

Hotpoint FF200DP Manual de usuario

Hotpoint

Hotpoint FFU4DG K Manual de usuario

Hotpoint

Hotpoint HTS18BBPPLCC and Instrucciones de funcionamiento

Manuales populares de Refrigerador de otras marcas

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Manual de usuario

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Manual de usuario

Sharp

Sharp SJ-BA31IEXW2-EU Manual de usuario

CORBERO

CORBERO CC2300MCW Manual de usuario

KitchenAid

KitchenAid 2205264 Manual de usuario

Stengel

Stengel KU 1101 A++ Manual de usuario

NEFF

NEFF KI181 Series Manual de usuario

Hoshizaki

Hoshizaki Reach-In Manual de usuario

Amana

Amana ASD2524VES00 Manual de usuario

BOMANN

BOMANN KGC 213 Manual de usuario

Danby

Danby DAR044A1SLDD Instrucciones de montaje

Samsung

Samsung RF323TE Manual de usuario

Beko

Beko CSA31022 Manual de usuario

IKEA

IKEA FROSTIG C 185 E Manual de usuario

Electrolux

Electrolux ER 6821 D Manual de usuario

True

True TS-28 Manual de usuario

Frigidaire

Frigidaire FSC23R5DW9 Manual de usuario

Beko

Beko LSP4579W Manual de usuario