Hoover HF 4E7L0A-80 Manual de usuario

Thank you for choosing this product.

We are proud to offer the ideal product for

you and the best complete range of home

appliances for your daily routine.

Carefully read this manual for correct and

safe appliance use and for helpful tips on

efficient maintenance.

Only use the dish washer

after

carefully reading these instructions. We

recommend you always keep this manual

to hand and in good condition for any

future

owner.

Please check that the appliance is

delivered with this instruction manual, the

warranty certificate, the service centre

address and the energy efficiency label.

Each product is identified by

a unique 16

digit code, also called the “serial number”,

printed on the warranty

certificate or on

the serial plate found inside the door, on

the upper right hand side. This code is a

sort of product

specific ID card that you

will need to use to register the product or

if you need to contact the Technical

Assistance Centre.

Fig. A

GENERAL SAFETY RULES

WATER CONNECTION

LOADING THE SALT

ADJUSTING THE UPPER BASKET

(ONLY ON SOME MODELS)

LOADING DISHES

INFORMATION FOR TEST

LABORATORIES

LOADING THE DETERGENT

TYPES OF DETERGENT

LOADING THE RINSE AID

10.

CLEANING THE FILTERS

11.

PRACTICAL HINTS

12.

CLEANING AND MAINTENANCE

13.

DESCRIPTION OF THE CONTROL

PANEL

14.

TECHNICAL DATA

15.

PROGRAMME SELECTION AND

SPECIAL FEATURES

16.

REMOTE CONTROL (Wi-Fi)

17.

PROGRAMME LEGEND

18.

WATER SOFTENER UNIT

19.

TROUBLESHOOTING AND WARRANTY

20.

ENVIRONMENTAL CONDITIONS

Contents

1. GENERAL SAFETY

RULES



This appliances is intended to

be used in household and

similar applications such as:

−Staff kitchen areas in

shops, offices and other

working environments;

−Farm houses;

−By clients in hotels, motels

and other residential type

environments;

−Bed and breakfast type

environments.

A different use of this appliance

from household environment

or from typical housekeeping

functions, as commercial use by

expert or trained users, is excluded

even in the above applications. If

the appliance is used in a manner

inconsistent with this it may reduce

the life of the appliance and may

void the manufacturer’s warranty.

Any damage to the appliance or

other damage or loss arising

through use that is not consistent

with domestic or household use

(even if located in a domestic or

household environment) shall not

be accepted by the manufacturer to

the fullest extent permitted by law.

for EU market

The appliance can be used by

those aged 8 or over and by

those with limited physical,

sensorial or mental capacities,

without experience or knowledge

of the product, only if supervised

or provided with instruction as

to the operation of the appliance,

in a safe way with awareness

of the possible risks.

for Extra EU markets

This appliance is not intended

for use by persons (including

children) with reduced physical,

sensory or mental capabilities,

or lack of experience and

knowledge, unless they have

been given supervision or

instruction concerning use of

the appliance by a person

responsible for their safety.

Children should be supervised

to ensure that they do not play

with the appliance.

Children of aged 3 and under

should be kept away unless

continuously supervised.

If the supply cord is damaged,

it must be replaced by a

Special cord or assembly

available from the manufactured

or its service agent.



Only use the hose-sets

supplied with the appliance for

the water supply connection

(do not reuse old hose-sets).



Water pressure must be

between 0.08 MPa and 0.8

MPa.



Make sure carpets or rugs do

not obstruct the base or any of

the ventilation openings.

After installation, the appliance

must be positioned so that the

plug is accessible.



Do not leave the door open in

a horizontal position, in order

to avoid potential dangers (e.g.

tripping).



For further information on the

product or to consult the technical

data sheet, please refer to the

manufacturer's website.

For the maximum number of

place settings, see the relevant

data plate attached to the product



The technical details (supply voltage

and power input) are indicated

on the product rating plate.



Make sure that the electrical

system is earthed and complies

with all applicable laws, and

that the socket is compatible

with the plug of the appliance.

The manufacturer declines all

responsibility for any damage

to people or property due to

non-earthing of the machine.

Ensure that the dishwasher

does not crush power cables.

In general it is not advisable to

use adaptors, multiple plugs

and/or extension cables.

Before cleaning or maintaining

the dishwasher, unplug the

appliance and turn off the

water supply.

Do not pull on the power cord

or appliance to unplug the

machine.

WARNING:

Water may reach very high

temperatures during the

wash cycle.

WARNING:

The appliance must not be

supplied through an external

switching device, such as a

timer, or connected to a circuit

that is regularly switched on

and off by a utility.

Electrical connections and

safety instructions

Do not leave the appliance

exposed to the elements (rain,

sun, etc.).

Leaning or sitting on the open

door of the dishwasher could

cause it to tip over.

When moving, do not lift the

dishwasher by the door; during

the transport, never lean the

door on the trolley. We

recommend two people lift the

machine.



The dishwasher is designed for

normal kitchen utensils. Objects

that have been contamined by

petrol, paint, traces of steel or

iron, corrosive chemicals, acids

or alkalis must not be washed in

the dishwasher.



If there is a water softening

device installed in the home

there is no need to add salt to

the water softener fitted in the

dishwasher.



If the appliance breaks down or

stops working properly, switch it

off, turn off the water supply and

do not tamper with it. Repair work

should only be carried out by an

approved service agent and only

genuine spare parts should be

fitted. Any failure to follow the

above advice may have serious

consequences for the safety of

the appliance.

If you need to move the

machine after removing the

packaging, do not try to lift it by

the bottom of the door. Open

the door slightly and lift the

machine by holding it on the top.

By marking this product,

we confirm, under our own

responsibility, full compliance

of this product with all

relevant safety, health and

environmental requirements

under European legislation.



Remove all elements of the

packaging.

Do not install or use the

dishwasher if it is damaged.

WARNING:

Keep packaging materials

away from children.

Installation

WARNING:

Knives and other utensils

with sharp points must be

loaded in the basket with

their points down or placed

in a horizontal position.



Follow the instructions supplied

with the product.



In case of breakage, the hose

must be replaced with an

original spare part available

from the manufacturer or its

service center.

Remove the anti-removal

device (A) by unscrewing the

fixing screw (B).

Remove the inlet hose (C) by

unscrewing the ring nut (D).

WARNING:

Use only the inlet hose

supplied with the appliance

for connection to the

water

mains. Old inlet hoses must

not be reused.

Replacement of the inlet hose

WARNING:

Ensure tha

t the product,

before being switched on for

the first time, is installed in a

horizontal position by way of

the adjustable feet.

Check the horizontal position

using a spirit level

WARNING:

(only freestanding models)

If it is necessary to remove

the worktop to install the

dishwasher in a compartment

of a modular kitchen, please

contact our Authorized

Technical Assistance Centres.

WARNING:

(only built-

in and half

integrated models)

Do not connect the dishwasher

to the mains supply until the

front panel has been fully

installed. Otherwise, the risk

of an electrical hazard

may

persist.

WARNING:

(only built-in and semi-

integrated models)

Do not connect the dishwasher

to the mains supply unt

il all

installation operations have

been performed according

to the "TECHNICAL NOTES

FOR INSTALLATION" supplied

with the product.

Connect the new inlet hose by

screwing the ring nut.

Fit the anti-removal device,

fixing it with the designated

screw.

WARNING:

Ensure that the ring nut has

been screwed in correctly

and that there are no water

leakages.

2. WATER CONNECTION



The inlet and drain hoses can be directed

to left or right.



Water pressure must be between 0,08

MPa and 0,8 MPa.



The inlet hose must be connected to a tap

so that the water supply can be cut off

when the machine is not in use (fig.1B).



The dishwasher is fitted with 3/4" threaded

connector (fig.2).



Connect inlet hose "A" to water tap

"B"

with a 3/4" attachment making sure that it

has been properly tightened.



If it is necessary, the inlet pipe can be

lengthened up to 2,5 m. The extension

pipe is available from the After Sales

Service Centre.

If the dishwasher is connected to new

pipes or to pipes which have not been

inuse for a long time run water through for

a few minutes before connecting the inlet

hose. In this way no deposits of san

d or

rust will clog up the water inflow filter.

The dishwasher can be connected to

either cold or hot water, as long as it

is no hotter than 60°C.

The appliance must be connected to

the water mains using new hose-

sets.

The old hose-

sets should not be

reused.

SOM

E MODELS

may include one or more

of the following features:



WATERBLOCK (fig.3)

The waterblock system has been designed

improve the safety of your appliance. The

system prevents flooding which might be

caused by a machine malfunction or as a

result of a fracture on the rubber pipes

and in particular on the water supply pipe.

How it works

A sump located on the base of the appliance

collects any possible water leakage and

operates a sensor which activates a valve

placed under the water tap and blocks any

water, even with the tap fully opened.

box "A"

containing the electrical parts is

damaged, remove the plug from the socket

immediately. To ensure perfect operation of

the safety system, the hose with box "A"

should be connected to the tap as shown in

the

figure

. The water supply hose should

not

be cut, as it contains live parts. If the

hose is not long enough for correct

connection, it must be replaced with a longer

one. The hose can be obtained from the

Technical Assistance Centre.



AQUASTOP (fig.4):

A device located on the supply tube

that

stops water flow if the tube deteriorates;

in this case, a red mark will appear in the

window "A"

and the tube must be

replaced. To unscrew the nut, press the

one-way lock device "B".

All the dishwashers are equipped with

an overflow safety device which, if

water exceeds normal levels due to

malfunctions, automatically blocks

water flow and/or drains excess

quantities.

Hydraulic safety devices



The outlet hose should disharge into a

standpipe, making sure that there are no

kinks (fig.5).



The standpipe must be at least 40 cm

above floor level and it must have an

internal diameter of at least 4 cm.



It is advisable to fit an anti-

odour air trap

(fig.5X)

. If necessary the outlet hose can

be extended up to 2,5 m, provided that it

is kept at a maximum height of 85 cm

above floor level. The extension pipe is

available from the After Sales Service

Centre.



The hose can be hooked over the side of

the sink, but it must not be immersed in

water, in order to prevent water from

being syphoned back to the machine

when this is in operation (fig.5Y).



When installing the appliance under a

worktop the hose pipe clam

p must be

attached to the wall in the highest

possible position under the worktop

(fig.5Z).



Check that there are no kinks in the inlet

and outlet hoses.

Connecting the outlet hose

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Lavavajillas de Hoover

Hoover

Hoover HDPN 2D520PW Manual de usuario

Hoover

Hoover HD96M 32000068 Manual de usuario

Hoover

Hoover HOD 6615 BL Instrucciones de instalación

Hoover

Hoover HDI 2D949-80 Manual de usuario

Hoover

Hoover DDY 088T Manual de usuario

Hoover

Hoover HDP 2LO36W Manual de usuario

Hoover

Hoover DDY 65543FAM Manual de usuario

Hoover

Hoover DDY 088T Manual de usuario

Hoover

Hoover HD 96 M ALU Manual de usuario

Hoover

Hoover HLSI 762GT WIFI Manual de usuario

Hoover

Hoover HDP 2D945W-86 Manual de usuario

Hoover

Hoover HDIH 2T1047-80 Manual de usuario

Hoover

Hoover DDY 062 L Guía de inicio rápido

Hoover

Hoover HDS 556 MS-80 Manual de usuario

Hoover

Hoover HFI 4015 Instrucciones de instalación

Hoover

Hoover HDI1L038B Manual de usuario

Hoover

Hoover HDP 3T60PWDFX Manual de usuario

Hoover

Hoover 32000298 Manual de usuario

Hoover

Hoover D824/1 Manual de usuario

Hoover

Hoover DYM 896T WIFI Manual de usuario

Hoover

Hoover HDI 2D62 Manual de usuario

Hoover

Hoover DDY 088T Manual de usuario

Hoover

Hoover HLSI 500GT Manual de usuario

Hoover

Hoover DDY 088TX Manual de usuario

Manuales populares de Lavavajillas de otras marcas

Electrolux

Electrolux ESI5211LOX Manual de usuario

KitchenAid

KitchenAid KUDB230B Manual de usuario

Brandt

Brandt BDJ424DB Manual de usuario

Asko

Asko DSD767UXXL.AU Manual de usuario

Beko

Beko DFN26210W Manual de usuario

NEFF

NEFF S153ITX00E Hoja de especificaciones

Midea

Midea SV 4.45 wi Manual de usuario

LG LDF7932 Manual de usuario

Gorenje

Gorenje GV63214 Manual de usuario

Hotpoint

Hotpoint HDA1100ZWH Manual de servicio

Blomberg

Blomberg LDFN2240W Manual de usuario

AEG

AEG FFB83836PM Manual de usuario

Cylinda

Cylinda DM3220RFD Manual de usuario

Atag

Atag DW8214MB Manual de usuario

GE GLD8000 Series Manual de usuario

Siemens

Siemens SN23HI02KE Hoja de especificaciones

Omega

Omega ODW717X Manual de usuario

BORETTI

BORETTI BVW-683 Manual de usuario