Honeywell 138560.10 Manual de usuario

FloodLED IP66

147mm

108mm

146mm 102mm

Dimensional Drawings:

Step 3: Make a hole in the center of the rubber gasket by using a small screwdriver. Pass the mains cable

through the rubber gasket. Always use in any case round mains cable, with a diameter of 5-10mm.

ATTENTION!! The cable must not be deformed in any way (This requirement is important to ensure the

IP rating).

Step 2: Install the bracket to the bottom part of the luminaire, with the supplied screw (long one) and nut.

Step 4: The user can select one of the 3 available minimum autonomy durations: 1 hour, 3 hours and 8

hours. The selection must be done while the luminaire is disconnected from AC and battery supplies. The

selection is achieved through Switches 2 & 3 of DS1. Switch 1 is not used. Two additional labels are included

in the package one for 3 hours duration (180) and one for 8 hours duration (480). The installer must cover

the default 1 hour (60). printing. Please take notice of the orientation of the label.

Step 1: Unfasten the two retaining screws to dismantle the luminaire.

Step 5: Connect the mains cable to the therminal blocks: L for live wire, N for neutral and PE for the

ground wire. For pernament maintained operation switch number 4 must be in ON position. For non-

maintained operation, switch number 4 must be in OFF position. For controlled maintained operation of the

lamp, connect L1 to an external switch and switch number 4 of the DS1 must be in OFF position. Power

supply cables cross section should be 0.8 – 3 mm . Install the supplied plastic tie anchor with the screws, to

fasten securely the power cable, in order to anchor it.

Installation:

N PEL

PE N PEL

Pernament Maintained Operation

Non-Maintained Operation

Controlled Maintained

Operation of the Lamp

1 2 3 4

Maintained operation

(default position)

1 2 3 4

Non-maintained operation Controlled Maintained

Operation of the Lamp

External

Switch

DS1

4 5

Honeywell Life Safety AS, Postboks 236, 1372 Asker http://www.hls-nordic.com

L1 PE

Plastic Ties

Cable Holes

1 2 3 4

(default position)

3h 8h

Honeywell Life Safety AS, Postboks 236, 1372 Asker http://www.hls-nordic.com

Selftest functions

Every 15 days the luminaire will perform an emergency operation test. This will turn on the light source for

approximately 3 seconds. The green LED will flash during this test sequence.

Every 6 months the luminaire will perform a battery condition test. The test will last for the chosen

autonomy. The light source will be lit and the green LED will flash during this test sequence.

Note: When using Wireless communication, the frequencies and schedules for tests will instead be

determined by the connected PC software.

Important notice when installing luminaires within the same area!!!

The FloodLED is a self-contained maintained/non-maintained luminaire with selftest function.

To avoid that luminaires perform their battery test at the same day, connect the battery packs with more

than 1,5 minutes inbetween.

Step 6: Place the battery's connector to the corresponding connector

on the PCB.

Step 7: In case you use a module connect it on the PCB.

Note! FloodLED supports only the Wireless module.

Step 9: Mount the bracket to the wall or to the ceiling.

Step 8. Refit the luminaire to the bottom cover and fasten the two

removed screws.

Indicator LEDs

LED Status explanation

Description

GREEN

RED

Normal

Charging (battery test not possible while charging)

Mains off, battery not connected or charger fault

Battery fault

Battery test (Duration: 1h,3h,8h)

Light source test (Duration: 3s)

Light source fault

Battery fault and light source fault

Off On Slow Blink Fast Blink

Honeywell Life Safety AS, Postboks 236, 1372 Asker http://www.hls-nordic.com

Technical description

Part no.:

Battery (LiFePO ):

Battery Protection: Overcharge protection / full discharge protection

Maximum Power Consumption:

Operation Voltage:

FloodLED 10Y 138h

5.3W / 5.7VA

220-240V AC, 50-60 Hz

138560.10

3.2V / 2Ah

16hours

Produced in accordance with:

Relative Humidity:

Charging Time:

Technical lifetime (light source):

Lumen output, normal:

> 100000 hours

400lm

1h / 3h / 8h manually selected (default 1h)

Degress of cover protection:

Emergency Mode Duration:

Lumen output, emergency: 1h: 390lm / 3h: 190lm / 8: 80lm

Weight:

Expected Battery Lifetime:

Controlgear classification in accordance with IEC 62034: with automatic test function

510 gr

10 years

At the end of their useful life the packaging, product & batteries

should be disposed of via a suitable recycling centre. Do not

dispose of with your normal household waste. Do not burn.

Swivel angles

Ambient Temperature Range:

o o

Up-Down: -90 to +90 o o

Right-Left: -70 to +70

5 to 40 C

Up to 95%

IP66

EN 60598-1, EN 60598-2-22, EN 55015

EN 61547, EN 61000-3-2, EN 61000-3-3

Note: In case of battery replacement, this must be replaced with parts of the same type and characteristics.

The replacement must be performed by the manufacturer or a competent person.

Note: In case of mains power disconnection for a period of more that two months, the battery must be

disconnected.

Note: If the supply cable of the luminaire is damaged, it shall exclusively be replaced by a competent person

in order to avoid hazard.

The light source contained in this luminary shall only be replaced by the manufacturer, or his agent,

or a similar qualified person.

NOTE! The light source is non-user replaceable.

Tabla de contenidos

Otros manuales de Equipo de iluminación de Honeywell

Honeywell

Honeywell ExiLED LP Manual de usuario

Honeywell

Honeywell S283W703-6 Guía de configuración

Honeywell

Honeywell Friedland FGGA02 Series Manual de usuario

Honeywell

Honeywell Ex-Or MSM2000A Manual de instalación y operación

Honeywell

Honeywell Ex-Or MS1500P Manual de usuario

Honeywell

Honeywell FF-LS14 Series Manual de usuario

Honeywell

Honeywell ImperLED Manual de usuario

Honeywell

Honeywell UVL-FCU-LINE Manual de usuario

Honeywell

Honeywell Ova/OmniLED R Manual de usuario

Honeywell

Honeywell OvaLED R Manual de usuario

Honeywell

Honeywell BT0554FF0810 Manual de usuario

Honeywell

Honeywell C7057 Manual de usuario

Honeywell

Honeywell 45366 Manual de usuario

Honeywell

Honeywell Ex-Or MS1101PF Manual de instalación y operación

Honeywell

Honeywell Οva-OmniLED R S Manual de usuario

Honeywell

Honeywell 45744 Manual de usuario

Honeywell

Honeywell UniLED Manual de usuario

Honeywell

Honeywell ST124A216110 Manual de usuario

Honeywell

Honeywell BT0554FF0020 Manual de usuario

Honeywell

Honeywell PEHA PHC 8-fold input pushbutton Guía del usuario

Honeywell

Honeywell MultiLED PRO Combi SET-10 Manual de usuario

Honeywell

Honeywell Ex-Or MS1500P Manual de instalación y operación

Honeywell

Honeywell 45415 Manual de operación y mantenimiento

Honeywell

Honeywell Ex-Or LightSpot Gold Series Manual de instalación y operación

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario