Honeywell HRDP DVR Manual de usuario

______________________________________________________________________________________________

Document 800-06801 Rev D 02/11

HRDP and HRDPX

H.264 DVR

Digital Recording and Transmission System

User Guide

______________________________________________________________________________________________

HRDP DVR User Guide

______________________________________________________________________________________________

Document 800-06801 Rev D 3

02/11

Revisions

Issue Date Revisions

A 05/10 Initial Release

B 06/10 Updated Content

C 09/10 Updated Content

D 02/11 Added HRDPX H.264

______________________________________________________________________________________________

Document 800-06801 Rev D 02/11

HRDP DVR User Guide

______________________________________________________________________________________________

Document 800-06801 Rev D 5

02/11

Warnings and Safeguards

FCC STATEMENT

INFORMATION TO THE USER: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Compliance Warning

Users of the product are responsible for checking and complying with all federal, state, and local laws

and statutes concerning the monitoring and recording of video and audio signals. Honeywell video

systems shall not be held responsible for the use of this product in violation of current laws and statutes.

CE Compliance Statement

The manufacturer declares that the equipment supplied with this guide is compliant with the essential

protection requirements of the EMC directive 2004/108/EC and the Low Voltage Directive (LVD)

2006/95/EC, conforming to the requirements of standards EN 55022 for emissions, EN 50130-4 for

immunity, and EN 60950 for Electrical Equipment safety.

Warnings and Safeguards

______________________________________________________________________________________________

Important Safeguards

Read Owner’s Manual – After unpacking this product, read the owner’s manual carefully, and

follow all the operating and other instructions.

Power Sources – This product should be operated only from the type of power source indicated on

the label. If not sure of the type of power supply to your home or business, consult product dealer

or local power company

Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure reliable

operation of the product and to protect it from overheating, and these openings must not be

blocked or covered. The product should not be placed in a built-in installation such as a bookcase

or rack unless proper ventilation is provided or Honeywell’s instructions have been adhered to.

Heat – The product should be situated away from heat sources such as radiators, heat registers,

stoves, or other products that produce heat.

Water and Moisture – Do not use this product near water. Do not exceed the humidity

specifications for the product as detailed in this manual

Cleaning – Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or

aerosol cleaners. Use a damp cloth for cleaning.

Power Cord Protection – Power-supply cords should not be routed so that they are likely to be

walked on or pinched by items placed against them, paying particular attention to cords at plugs,

receptacles, and the point where they exit the product.

Overloading – Do not overload wall outlets; extension cords, or integral convenience receptacles

as this can result in a risk of fire or electrical shock.

Lightning – For added protection for this product during storm, or when it is left unattended and

unused for long periods of time, unplug it from the wall outlet. This will prevent damage to the

product due to lightning and power line surges.

10.

Object and Liquid Entry Points – Never insert foreign objects into the DVR, other than the media

types approved by Honeywell, as they may touch dangerous voltage points or short-out parts that

could result in a fire or electrical shock. Never spill liquid of any kind on the product.

11.

Accessories – Do not place this product on an unstable cart, stand, tripod, bracket, or table. The

product may fall, causing serious personal injury and serious damage to the product.

12.

Disc Tray –Keep fingers well clear of the disc tray as it is closing. Neglecting to do so may cause

serious personal injury.

13.

Burden – Do not place a heavy object on or step on the product. The object may fall, causing

serious personal injury and serious damage to the product.

14.

Disc – Do not use a cracked, deformed, or repaired disc. These discs are easily broken and may

cause serious personal injury and product malfunction.

15.

Fuses – CAUTION: For continued protection against risk of fire, replace only with same type and

HRDP DVR User Guide

______________________________________________________________________________________________

Document 800-06801 Rev D 7

02/11

rating of fuse.

16.

Replaceable Batteries – CAUTION: Risk of Risk of Explosion if Battery is replaced by an Incorrect

Type. Dispose of Used Batteries According to the Instructions

17.

Grounded Outlet – This equipment shall be connected to a properly grounded outlet."

18.

Outlet Location – This equipment must be installed within six feet of an easily accessible outlet.

19.

Damage Requiring Service –Unplug the unit from the outlet and refer servicing to qualified service

personnel under the following conditions:

When the power-supply cord or plug is damaged.

If liquid has been spilled, or objects have fallen into the unit.

If the unit has been exposed to rain or water.

If the unit does not operate normally by following the operating instructions. Adjust only those

controls that are covered by the operating instructions as an improper adjustment of other controls

may result in damage and will often require extensive work by a qualified technician to restore the

unit to its normal operation.

If the unit has been dropped or the enclosure has been damaged.

When the unit exhibits a distinct change in performance - this indicates a need for service.

20.

Servicing –Do not attempt to service this product. Opening or removing covers may expose the

user to dangerous voltage or other hazards. Refer all servicing to qualified personnel.

21.

Replacement Parts –When replacement parts are required, be sure the service technician has

used replacement parts specified by Honeywell. Unauthorized substitutions may result in fire,

electric shock or other hazards.

22.

Safety Check –Upon completion of any service or repairs to this unit, ask the service technician to

perform safety checks to determine that the unit is in proper operating condition.

Warnings and Safeguards

______________________________________________________________________________________________

Notes on Handling

Please retain the original shipping carton and/or packing materials supplied

with this product. To ensure the integrity of this product when shipping or

moving, repackage the unit as it was originally received from Honeywell.

Do not use volatile liquids, such as aerosol spray, near this product. Do not

leave rubber or plastic objects in contact with this product for long periods

of time. They will leave marks on the finish.

The top and rear panels of the unit may become warm after long periods of

use. This is not a malfunction.

Notes on Locating

Place the unit on a level surface. Do not use it on a shaky or unstable

surface such as a wobbling table or inclined stand.

If this unit is placed next to a TV, radio, or VCR, the playback picture may

become poor and the sound may be distorted. If this happens, place the

DVR away from the TV, radio, or VCR.

Notes on Cleaning

Use a soft dry cloth for cleaning.

For stubborn dirt, soak the cloth in a weak detergent solution, wring well and

wipe. Use a dry cloth to wipe it dry. Do not use any type of solvent, such as

thinner and benzene, as they may damage the surface of the DVR.

If using a chemical saturated cloth to clean the unit, follow that product’s

instructions.

Notes on Maintenance

This DVR is designed to last for long periods of time. To keep the DVR

always operational we recommend regular inspection maintenance

(cleaning parts or replacement). For details contact the nearest dealer.

HRDP DVR User Guide

______________________________________________________________________________________________

Document 800-06801 Rev D 9

02/11

Notes on Moisture Condensation

Moisture condensation could damage the DVR. Read the following

information carefully.

Moisture condensation might occur under the following circumstances:

•When this product is brought directly from a cool location to a

warm location.

•When this product is moved to a hot and humid location from a

cool location.

•When this product is moved to a cool and humid location from a

warm location.

•When this product is used in a room where the temperature

fluctuates.

•When this product is used near an air-conditioning unit vent.

•When this product is used in a humid place.

Do not use the DVR when moisture condensation may occur.

If the DVR is used in such a situation, it may damage discs and internal

parts. Remove any CD discs, connect the power cord of the DVR to the wall

outlet, turn on the DVR, and leave it for two to three hours. After two to three

hours, the DVR will warm up and evaporate any moisture. Keep the DVR

connected to the wall outlet and moisture will seldom occur.

Warnings and Safeguards

______________________________________________________________________________________________

Safety Instructions – Rack Mount

A) Elevated Operating Ambient – If installed in a closed or multi-unit rack

assembly, the operating ambient temperature of the rack environment may

be greater than room ambient. Therefore, consideration should be given to

installing the equipment in an environment compatible with the maximum

ambient temperature (Tma) specified by the manufacturer.

B) Reduced Air Flow – Installation of the equipment in a rack should be such

that the amount of air flow required for safe operation of the equipment is

not compromised.

C) Mechanical Loading – Mounting of the equipment in the rack should be

such that a hazardous condition is not achieved due to uneven mechanical

D) Circuit Overloading - Consideration should be given to the connection of

the equipment to the supply circuit and the effect that overloading of the

circuits might have on overcurrent protection and supply wiring. Appropriate

consideration of equipment nameplate ratings should be used when

addressing this concern.

E) Reliable Earthing - Reliable earthing of rack-mounted equipment should

be maintained. Particular attention should be given to supply connections

other than direct connections to the branch circuit (e.g. use of power

strips)."

CAUTION

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

Otros manuales para HRDP DVR

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de DVR de Honeywell

Honeywell

Honeywell HRHD 410 Manual de usuario

Honeywell

Honeywell HRXDS16D1T Manual de usuario

Honeywell

Honeywell HRDP16D1T0 Manual de usuario

Honeywell

Honeywell HLVR4 Manual de usuario

Honeywell

Honeywell HRXD9 Manual de usuario

Honeywell

Honeywell Fusion IV Manual de usuario

Honeywell

Honeywell HREP 8 Manual de usuario

Honeywell

Honeywell HUS-NVR-1032/6032-E Manual de usuario

Honeywell

Honeywell Rapid Eye Hybrid LT Manual de usuario

Honeywell

Honeywell Rapid Eye Hybrid LT Manual de usuario

Honeywell

Honeywell HRHD4+ Manual de usuario

Honeywell

Honeywell HD-DVR-1004 Manual de usuario

Honeywell

Honeywell HD-16DVR-C Manual de usuario

Honeywell

Honeywell Rapid Eye LT Manual de usuario

Honeywell

Honeywell HRDPX Manual de usuario

Honeywell

Honeywell MAXPRO Manual de usuario

Honeywell

Honeywell Rapid Eye Manual de usuario

Honeywell

Honeywell HRG4X Manual de usuario

Honeywell

Honeywell HRSD16 Manual de usuario

Honeywell

Honeywell HNDR-S 4848 Manual de instrucciones

Honeywell

Honeywell H.264 HRDP Manual de usuario

Honeywell

Honeywell CADVR-1004-WD-M Manual de usuario

Honeywell

Honeywell HRGX45 Manual de usuario

Honeywell

Honeywell MAXPRO Manual

Manuales populares de DVR de otras marcas

FLIR

FLIR M3100E Series Manual de usuario

VTRACKPRO

VTRACKPRO FPRO300 Manual de usuario

Swann

Swann NVR-7085 models Manual de usuario

XtendLan

XtendLan DVR-1670C Manual de usuario

urmet domus

urmet domus 1093/004AHD Manual de usuario

Holux

Holux M1 Manual de usuario

CMOS DOTCOM

CMOS DOTCOM ANX-1670 Manual de usuario

Whistler

Whistler D16VRS Manual de usuario

Defender Security

Defender Security 82-20235 Manual de usuario

MISUMI

MISUMI MP-WF100M Manual de usuario

Speco

Speco D8HU Manual de usuario

UST

UST DDR-E04AA Instrucciones de uso

Consolidated

Consolidated Digital Video Recorder Manual de usuario

Mace

Mace DVR0404RW Guía de inicio rápido

RCA

RCA RTD315W Manual de usuario

FSM

FSM Colibri Grande PRO Manual de usuario

Hauppauge

Hauppauge HD PVR 2 Manual de usuario

Identivision

Identivision ICR-PH161i PIONEER Manual de usuario