Honeywell F50F Manual de usuario

® U.S. Registered Trademark

69-0756-3

OWNER’S GUIDE

F50F and F300E

Electronic

Air Cleaners

F50F AND F300E ELECTRONIC AIR CLEANERS

69-0756-3 2

CONTENTS

Operating Your Electronic Air Cleaner 3

Getting the Most from Your Electronic Air Cleaner 4

Cleaning Electronic Prefilter(s) and Cell(s) 6

How Electronic Air Cleaning Works 11

Before You Call for Service 14

Honeywell10-Year UltraCleanCoil Guarantee™ 15

Limited Five-year Warranty 16

Product Registration 17

F50F AND F300E ELECTRONIC AIR CLEANERS

3 69-0756-3

OPERATING YOUR ELECTRONIC AIR CLEANER

Turn the On-Off switch on the power box to On.

NOTE: Set the switch to 1 for On and set the switch to O for

Off.

The air cleaner now operates whenever your furnace/air

conditioning system fan operates. For maximum air cleaning

benefit and cleaner air conditioner coils, leave the air cleaner

switch turned on at all times and the thermostat fan switch set

to On. Of course, continuous fan operation adds to your electric

bill each month. Check your equipment for the amount of

electricity needed to run your System fan.

When the fan and air cleaner come on, the neon indicator lights.

You may occasionally hear a snapping (electrical arcing) sound

as the air cleaner operates. The source is larger dust particles

that cause a high voltage discharge.The snapping sound

means that your air cleaner is working as it should.

The switch remains in the On position to keep the air cleaner

running.

When the fan and air cleaner stops, the neon light goes off.The

air cleaner is off until the heating or air conditioning and fan start

again.

If you do not want the air cleaner to run, set the On-Off switch to

Off to turn off the air cleaner. Your furnace and air conditioner

continue to operate normally, but without the added benefit of

air cleaning. Normally, this switch should be turn to On at all

times.

M3584

M3586

M3585A

M3583

F50F AND F300E ELECTRONIC AIR CLEANERS

69-0756-3 4

GETTING THE MOST FROM YOUR ELECTRONIC AIR

CLEANER

Run the

electronic air

cleaner as

much as

possible

For greatest efficiency, the air cleaner should run all the time. To

do this, set the Fan switch on your thermostat to On, and make

sure the air cleaner is turned on. The fan and air cleaner run

even when the furnace or air conditioner is off.

NOTE: A manual fan switch may be built into the furnace or

furnace fan controller.

The air cleaner uses less power than a 40 watt light bulb (two-

cell model—33 watts; single cell model—22 watts). Many

believe that the added cost is more than offset by the added

benefits of full-time air cleaning and full-time air circulation. And

you may feel that the room temperature stays more even when

the fan is always on.

Even if your thermostat does not have a Fan On position, you

can obtain maximum available air cleaning benefit by making

sure the air cleaner is always turn to On so it operates

whenever the furnace or air conditioner is on.

Keep the

cell(s) and

prefilter(s)

clean

Although the air cleaner is designed to be efficient over a wide

range of cell dirt loading conditions, regular cleaning is your

best assurance of consistent performance. Also, a very dirty

prefilter and cell reduces air flow and, in turn, this reduces the

efficiency of the furnace or air conditioner. The cell wash

reminder schedule or the optional W8600 Air Cleaner Indicator

should be used to maintain a regular wash schedule.

If you have a

humidifier

All Honeywell whole house humidifiers can be used in a system

with the Honeywell Electronic Air Cleaner without any additional

filters or system modification.

If your system includes an atomizing humidifier, you may want

to install a standard furnace filter between the humidifier and

the air cleaner.This filter would keep the humidifier spray

mineral deposits from collecting on the air cleaner.This filter

should be checked regularly and changed when it shows signs

of mineral or dirt buildup. If you do not install a filter, you will

probably need to wash the cell(s) and prefilter(s) more often to

remove the mineral buildup.

F50F AND F300E ELECTRONIC AIR CLEANERS

5 69-0756-3

If an ultrasonic room humidifier is used often, especially if filled

with tap (undistilled) water, the cell(s) and prefilter(s) require

more frequent washing. A white residue accumulates on the

cell(s) from the minerals in the water. This residue may also

contribute to "white dust.” See About lint or “white dust” section

for more information.

F50F AND F300E ELECTRONIC AIR CLEANERS

69-0756-3 6

CLEANING THE PREFILTER(S) AND CELL(S)

CAUTION

Sharp edges.

Can cause personal injury.

Carefully handle cell(s) or wear protective gloves to

avoid cuts from sharp metal edges.

Setting a

regular

cleaning

schedule

To ensure optimum performance from the air cleaner, the

prefilter(s) and cell(s) must be cleaned regularly—the

prefilter(s) should be cleaned every one to six months and the

cell(s) every six to twelve months. Washing frequency varies,

depending on the number of family members, pets, activities

(such as cooking or woodshop) and smoking habits. Use the

wash reminder schedule below to help establish and maintain a

regular cleaning schedule. Mount the wash reminder schedule

in a convenient location.

NOTE: You may let the heating or air conditioning system

operate normally while the cell(s) are being washed.

Simply turn off the air cleaner switch.

YEAR

ELECTRONIC AIR CLEANER WASH REMINDER SCHEDULE

M982

JFMAMJJASOND

INSTALLATION DATE:

F50F AND F300E ELECTRONIC AIR CLEANERS

7 69-0756-3

Cleaning the

prefilter(s)

Vacuum the prefilter with a brush attachment, rinse it with a

hose, or soak it in a tub. Do not wash the prefilter(s) in the

dishwasher or car wash.

CAUTION

Burn Hazard.

Can cause personal injury.

Washing the

cell(s) in your

automatic

dishwasher

Allow the cell(s) to cool completely in the dishwasher at the end

of the wash cycle or wear protective gloves to avoid burns. Hot

water can accumulate in the tubes supporting the collector

plates.Tip the cell(s) so these tubes can drain.

IMPORTANT

• Check your dishwasher Owner’s manual. Some manu-

facturers do not recommend washing electronic cell(s)

in their dishwashers.

• If the dishwasher has upper and lower arms, position

the cell(s) carefully to allow good water circulation.

• Be careful to avoid damaging the cell(s) when placing

them in the dishwasher. Broken ionizer wires or bent

collector plates are not covered under the Warranty.

• Very dirty cell(s), especially from tobacco or cooking

smoke, can discolor the plastic parts and the lining of

some dishwashers.This discoloration is not harmful.

To minimize it, wash the cell(s) more frequently or try a

different brand of detergent.

•Do NOT allow the dishwasher to run through the

dry cycle. This bakes on any contaminants not

removed during the wash cycle and reduces air

cleaner efficiency.

Step 1 Put the cell(s) on the lower rack of the dishwasher with the

airflow arrow pointing up. It may be necessary to remove the

upper rack. Do not block water flow to the upper arm.

HINT: Lay a few large water glasses between the spikes on the

lower rack, and rest the cell(s) on them so the spikes do not

damage the aluminum collector blades.

F50F AND F300E ELECTRONIC AIR CLEANERS

69-0756-3 8

Step 2 Using your regular dishwashing detergent, allow the

dishwasher to run through the complete wash and rinse cycle.

Do not use the dry cycle.To avoid burns, let the cell(s) cool

completely before removing, or wear protective gloves when

removing the cell(s). Remember that water may be trapped

inside the cell(s) plates. Tip the cell(s) so these tubes can drain.

Step 3 Wipe the ionizer wires and contact board on the end of the cell

using your thumb and forefinger with a small, damp cloth.

Step 4 Inspect the dishwasher. You may want to rerun the wash and/or

rinse cycle with the dishwasher empty if you see dirt or residue

from washing the cell(s). If dirt or residue seems excessive,

wash the cell(s) more often or try a different detergent.

CAUTION

Hazardous Chemical.

Can cause personal injury.

Do not splash detergent solution in eyes.

Washing the

cell(s) in a tub

• Wear rubber gloves to avoid prolonged detergent contact

with your skin.

• Keep detergent and solution out of reach

of children.

NOTE: Always wash the cell(s) first, then the prefilter(s), to

keep heavy prefilter lint from getting caught in the

cell(s).

Step 1 Use a large enough container, such as a laundry tub or trash

container, to hold one or both cell(s).

NOTE: Sharp corners on the cell(s) can scratch the surface of

a bathtub.

Step 2 Dissolve about three-fourth cup of automatic dishwasher

detergent per cell in enough hot water to cover the cell(s). If the

detergent does not dissolve readily, or forms a scum on the

water, try another brand, or use softened water.

F50F AND F300E ELECTRONIC AIR CLEANERS

9 69-0756-3

Step 3 After the detergent has completely dissolved, place the cell(s)

in the container and allow to soak for 15 to 20 minutes or until

water cools. Agitate them up and down a few times and

remove. Repeat steps 2 and 3, if necessary, for very dirty cells.

Step 4 Next, wash the prefilter(s) the same way. Empty and rinse the

wash container.

Step 5 Rinse the cell(s) with a hard spray of very hot water; rinse the

tub clean, then fill the tub with clean hot water and soak for 5 to

15 minutes. Rinse until the water draining from the cell(s) and

prefilter(s) no longer feels slippery.

Step 6 Soak cell(s) in a final clear water rinse for ten minutes.

Step 7 Wipe the ionizer wires and contact board on the end of the cell

using your thumb and forefinger with a small, damp cloth.

F50F AND F300E ELECTRONIC AIR CLEANERS

69-0756-3 10

Replacing

electronic air

cleaner

components

Step 1 Inspect the cell(s) for broken ionizer wires and bent collector

plates. Repair, as necessary, or call your contractor for service.

Step 2 Slide the prefilter(s) into the upstream prefilter guides.

Step 3 Slide the air cleaner cell(s) in so the air flow arrow points

downstream and the handle(s) face outward.

Step 4 Firmly close the access door.

Step 5 Turn on the air cleaner. If the cell(s) and prefilter(s) are wet, the

neon light may not come on and you may hear arcing. If the

arcing is annoying, simply turn the air cleaner off for two to

three hours or until the cell(s) are dry.

M3582

Otros manuales para F50F

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Purificador de aire de Honeywell

Honeywell

Honeywell F50F Manual de usuario

Honeywell

Honeywell HPA090 series Manual de usuario

Honeywell

Honeywell F59A Manual de usuario

Honeywell

Honeywell F58G Manual de operación

Honeywell

Honeywell F300 Manual de usuario

Honeywell

Honeywell UV100A Manual de usuario

Honeywell

Honeywell F35F Manual de operación

Honeywell

Honeywell HPA060 Series Manual de usuario

Honeywell

Honeywell 18155 Manual de usuario

Honeywell

Honeywell F50F Manual de usuario

Honeywell

Honeywell F58F Manual de usuario

Honeywell

Honeywell F111 Manual de usuario

Honeywell

Honeywell 17000 - Permanent Pure HEPA QuietCare Air... Manual de usuario

Honeywell

Honeywell HPA830 Manual de usuario

Honeywell

Honeywell HEPACLEAN HHT270 Series Manual de usuario

Honeywell

Honeywell F90B Manual de usuario

Honeywell

Honeywell Enviracaire Elite UV100E Manual de operación

Honeywell

Honeywell IFD-60001E Manual de usuario

Honeywell

Honeywell HPA-051 Series Manual de usuario

Honeywell

Honeywell eenviracaire 51130 Series Manual de usuario

Honeywell

Honeywell QUIETCLEAN HFD230 Series Manual de usuario

Honeywell

Honeywell AIR GENIUS HFD30 Series Manual de usuario

Honeywell

Honeywell HT-380 Series Manual de usuario

Honeywell

Honeywell HHT-055 Series Manual de usuario

Manuales populares de Purificador de aire de otras marcas

IKEA

IKEA UPPÅTVIND Manual de usuario

Nash

Nash AP-1 PureSmart Manual de usuario

LG PH-U450 Series Manual de usuario

DeLonghi

DeLonghi DDSX 220WFA Manual de usuario

Mitsubishi Electric

Mitsubishi Electric MA-E85R-E Manual de usuario

Sharp

Sharp FU-40SE Manual de usuario

Philips

Philips AC2721 Manual de usuario

Hitachi

Hitachi EP-A3000 Manual de usuario

TruSens

TruSens Z-2000 Manual de usuario

Motorola

Motorola MBP87SN Manual de usuario

Beko

Beko ATP 7100I Manual de usuario

Carrier

Carrier INFINITY 1620 Manual de usuario

AtmosAir

AtmosAir P2002 Manual de usuario

Winix

Winix NK300 Manual de usuario

Friedrich

Friedrich C-90A Instrucciones de funcionamiento e instalación

Surgically Clean Air

Surgically Clean Air JADE2.0 Manual de usuario

Base aire

Base aire 555 Pro Manual de usuario

Champion

Champion CP25 Manual de usuario