Table of Contents
1. SAFETY INSTRUCTIONS AND RESPONSIBILITY.......................................................................4
1.1. General Safety Instructions......................................................................................4
1.2. Use according to the intended purpose ...................................................................4
1.3. Installation................................................................................................................5
1.4. Cleaning, Maintenance and Service Notes .............................................................5
2. COMPATIBILITY HINT ..............................................................................................................6
3. INTRODUCTION .......................................................................................................................7
3.1. Impulse input formats and input levels....................................................................7
3.2. Operating range........................................................................................................8
3.3. Suitable encoders and sensors ................................................................................8
4. TERMINAL ASSIGNMENTS AND CONNECTIONS....................................................................9
4.1. Example for use of TTL encoders .............................................................................9
4.2. Example for use of HTL encoders...........................................................................10
4.3. Proximity switches, photocells etc.........................................................................10
4.4. Analog output.........................................................................................................10
4.5. Serial interface.......................................................................................................11
5. DIL SWITCH SETTINGS..........................................................................................................12
5.1. Basic mode of operation ........................................................................................12
5.2. Impulse levels and symmetric / asymmetric input formats ...................................13
5.3. Analog output format .............................................................................................14
5.4. Selecting the RS232 or the RS485 serial interface ...............................................15
5.5. Teach function, Test function, loading of default settings....................................15
6. COMMISSIONING .................................................................................................................16
6.1. Conversion of one only frequency (single or dual channel with direction signal) .17
6.2. Conversion and combination of two independent frequencies ............................17
7. PC SETUP VIA OPERATOR SOFTWARE OS3.X ........................................................................18
8. PARAMETER DESCRIPTION ...................................................................................................20
9. FREE PROGRAMMABLE LINEARIZATION...............................................................................27
10. MONITOR FUNCTIONS ..........................................................................................................29
11. DATA READOUT VIA SERIAL INTERFACE...............................................................................31
12. DIMENSIONS ........................................................................................................................32
13. TECHNICAL SPECIFICATIONS ................................................................................................33
14. INTERNAL REGISTERS AND SERIAL CODES ..........................................................................34
15. COMMISSIONING FORM.......................................................................................................36
www.hohner-elektrotechnik.de 3
