Hi Sharp ML1040 Manual de usuario
Thank you for purchasing our product.
Please read this User’s Manual before
using the product.Change without notice
10.4” CCTV RS485 LCD
User’s Manual
RS485 controller
2
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
DO NOT INSERTANY METALLIC OBJECT THROUGH VENTILATION GRILLS.
CAUTION:
CAUTION
Explanation of Graphical Symbols
The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended. to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert
the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the product.
3
IMPORTANT SAFEGUARDS
1. READ INSTRUCTIONS
All the safety and operating instructions should be read before the unit is operated.
2. RETAIN INSTRUCTIONS
The safety and operating instructions should be retained for future reference.
3. HEED WARNINGS
All warnings on the unit and in the operating instructions should be adhered to.
4. FOLLOW INSTRUCTIONS
All operating and usage instructions should be followed.
5. CLEANING
Unplug this unit from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Clean only with a dry cloth.
6. ATTACHMENTS
The manufacturer of this unit does not make any recommendations for attachments, as they may cause hazards.
7. WATER AND MOISTURE
Do not use this unit near water. For example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a
swimming pool.
8. ACCESSORIES
Do not place this unit on an unstable cart, stand, tripod, bracket, or table. The unit may fall, causing serious injury, and serious
damage to the unit. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven
surfaces may cause the appliance and cart combination to overturn.
9. VENTILATION
Slots and openings at the rear cabinet and bottom are provided for ventilation, these are to ensure reliable operation of the unit,
and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by
placing the unit on a bed, sofa, rug, or other similar surface. This unit should never be placed near or over a radiator or heat
source. This unit should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or
the manufacturer’s instructions have been adhered to.
10. POWER SOURCE
This unit should be operated only from the type of power source indicated on the rating plate. If you are not sure of the type of
power supply to your home, consult your appliance dealer or local power company.
11. POWER-CORD PROTECTION
Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them,
paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.
12. LIGHTNING
To protect your unit from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the
wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line
surges.
13. POWER LINES
An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or
where it can fall onto or against such power lines or circuits. When installing an outside antenna system, extreme care should be
taken to keep from touching such power lines or circuits, as contact with them might be fatal.
14. OVERLOADING
Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.
15. OBJECT AND LIQUID ENTRY
Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short out parts that could
result in fire or electric shock. Never spill or spray any type of liquid into the unit.
16. HEAT
The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including
amplifiers) that produce heat.
17. CONNECTING
When you connect the product to other equipment, turn off the power and unplug all of the equipment from the wall outlet. Failure
to do so may cause a product damage. Read the owner's manual of the other equipment carefully and follow the instructions
when making any connections.
18. LCD
Do not press on or jolt the LCD panel. Doing so may cause the LCD panel glass to break and injury may occur. Should the LCD
panel be broken and liquid leaks out, do not inhale or swallow it. Doing so may cause poisoning. If you have got it into your
mouth, wash it out and consult your doctor. If your hands or clothes have touched it, wipe them with alcohol and a cleaning cloth
and then wash them well.
Important Information
4
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
Safety Precautions
This device complies with Part 15 FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference that may
cause undesired operation
5
Warning…………………………………………………………………………………………………….2
Important Information……………………………………………………………………………………. 3
Safety Precautions………………………………………………………………………………………..4
Table of Contents…………………………………………………………………………………………5
Components………………………………………………………….. …………………………………. 5
Feature……………………………………………………………………………………………………. 6
Exploring Your New Monitor……………………………………………………………………………..7
Backside Connections…….………………………………………………………………………….…. 8
Setup your Monitor……………………………………………………………………..………………...9
Remote controller…………………………………………………………………………………………10
Menu Setup Image………………………………………………………………………………….…… 15
Menu Setup PIP…………………………………………………………………………………….…… 16
Menu Setup System…………………………………………………………………………………… 17
Menu Setup VGA………………………………………………………………………………………. 18
Troubleshooting………………………………………………………………………………………..… 19
Specifications……………………...………………………………………………………………….…..20
Dimensions…………………….. ……………………………………………………………………..….22
Components
(1) LCD Color Monitor 1
(2) Accessories
(A) Power cord 1
(B) User Manual 1
(C) Remote Controller 1
(D) Adapter 1
(E) PC audio cord 1
(F) RCA audio cord 1
(G) VGA cord 1
Table of Contents
6
■ Professional TFT LCD for surveillance in 10.4” with multiple connections
■ Compatible with SVGA (800X600)
■ Picture-In-Picture feature that allow multi-picture display
■ High brightness level and contrast ratio with super wide viewing angle
■ Built-in 3D comb filter and 3D de-interlace for display picture performance
■ Fast response time and refresh rate without time lagging.
■ Provides 6500°K and 9300°K color temperature selection for user’s preference
■ Provides Key Lock and power memory function for easy management
■ Cam mode control that enable auto-adjust incoming video signal level
■ Video looping output supports 75ohm auto termination
■ Support audio and live-out function with stereo phone jack output
■ Remote Controller included for convenient usage
■ Video inputs support NTSC / PAL standards
■ VESA standards bracket (75mm x 75mm)
■ Built-in RS485 jack (optional): control camera, P/T/Z dome and DVR.
■ Protocol: Pelco P / Pelco D and customized protocol
Features
7
You can operate your monitor by using the buttons on the front panel. The side panels provide the
inputs to connect other equipment to your monitor.
Front Panel
Back Side
Exploring Your New Monitor
LED
8
Remark
Backside Connections
1. AUDIO IN (R, L)
Stereo Audio Signal Input, this input is for
VIDEO1 , VIDEO2 , S-VIDEO
2. VIDEO 1 IN
Composite signal Input for VIDEO 1
VIDEO 1 OUT
Video looping output for VIDEO 1
3. VIDEO 2 IN
Composite signal Input for VIDEO 2
VIDEO 2 OUT
Video looping output for VIDEO 2
4. S-VIDEO IN(without RS485 jack)
Y/C separated signal input
Remark
RS485 jack(without S-VIDEO IN)
Camera, P/T/Z dome or DVR connect
5. VGA IN
6. PC AUDIO IN
7. DC POWER SOCKET
DC 12V / 5A
①
②
③
④
⑤
⑥
⑦
RS485 A+
RS485 B-
9
AUTO: Auto-optimize displaying picture under PC mode.
Enter: This “ Auto” Button can be either “Enter” function in OSD Menu)
MENU: OSD menu ON / OFF control.(EXIT Item)
ADJUST: Increase or decrease the value on OSD menu.
Up: Increase value or turn ON / OFF function.
Down: Decrease value or turn ON / OFF function
SOURCE: Select input signal from AV1, AV2, S-Video or VGA (PC).
POWER: Monitor power ON / OFF. At OFF mode, monitor will be at standby status.
Green Light: ON Mode
Red Light: OFF Mode
Setup your Monitor
LED
10
RS485 LCD and RS485 remote controller optional
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Monitor de Hi Sharp
Hi Sharp
Hi Sharp HS-ML3700 Manual de usuario
Hi Sharp
Hi Sharp HS-ML0840 Manual de usuario
Hi Sharp
Hi Sharp HS-ML1500 Manual de usuario
Hi Sharp
Hi Sharp 19" Manual de usuario
Hi Sharp
Hi Sharp HS-ML2011 Manual de usuario
Hi Sharp
Hi Sharp HS-ML22M1 Manual de usuario
Hi Sharp
Hi Sharp HS-ML1002 Manual de usuario
Hi Sharp
Hi Sharp HS-ML22W1 Manual de usuario
Hi Sharp
Hi Sharp 3.5" Manual de usuario
Hi Sharp
Hi Sharp HS-ML1952 Manual de usuario
